A fluorescence spectroscopy assay for real-time monitoring of enzyme immobilization into mesoporous silica particles.

Anal Biochem

Department of Chemistry and Chemical Engineering, Physical Chemistry, Chalmers University of Technology, SE-412 96 Gothenburg, Sweden. Electronic address:

Published: May 2015

Mesoporous silica particles are used as support material for immobilization of enzymes. Here we investigated a fluorescence-based assay for real-time monitoring of the immobilization of lipase, bovine serum albumin, and glucose oxidase into micrometer-sized mesoporous silica particles. The proteins are labeled with the dye epicocconone, and the interaction with the particles is observed as an increase in emission intensity of the protein-dye conjugates that can be quantified if correcting for a comparatively slow photobleaching. The immobilization occurs in tens of minutes to hours depending on particle concentration and type of protein. In the limit of excess particles over proteins, the formation of the particle-protein complexes can be described by a single exponential growth for all three investigated proteins, and the fitted pseudo-first-order rate constant increases linearly with particle concentration for each protein type. The derived second-order rate constant k varies with the protein hydrodynamic radius according to k∼RH(-4.70±0.01), indicating that the rate-limiting step at high particle concentrations is not the diffusional encounter between proteins and particles but rather the entry into the pores, consistent with the hydrodynamic radii of the three proteins being smaller but comparable to the pore radius of the particles.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.ab.2015.02.005DOI Listing

Publication Analysis

Top Keywords

mesoporous silica
12
silica particles
12
assay real-time
8
real-time monitoring
8
particles proteins
8
particle concentration
8
rate constant
8
particles
7
proteins
5
fluorescence spectroscopy
4

Similar Publications

Nowadays, most of the newly developed active pharmaceutical ingredients (APIs) consist of cohesive particles with a mean particle size of <100μm, a wide particle size distribution (PSD) and a tendency to agglomerate, therefore they are difficult to handle in continuous manufacturing (CM) lines. The current paper focuses on the impact of various glidants on the bulk properties of difficult-to-handle APIs. Three challenging powders were included: two extremely cohesive APIs (acetaminophen micronized (APAPμ) and metoprolol tartrate (MPT)) which previously have shown processing issues during different stages of the continuous direct compression (CDC)-line and a spray dried placebo (SD) powder containing hydroxypropylmethyl cellulose (HPMC), known for its sub-optimal flow with a high specific surface area (SSA) and low density.

View Article and Find Full Text PDF

Background: Lenvatinib is an oral tyrosine kinase inhibitor that selectively inhib-its receptors involved in tumor angiogenesis and tumor growth. It is an emerging first-line treatment agent for hepatocellular carcinoma (HCC). However, there is no intravenous ad-ministration of Lenvatinib.

View Article and Find Full Text PDF

The differentiation of human induced pluripotent stem cells (hiPSCs) into neural progenitor cells (NPCs) is a promising approach for the treatment of neurodegenerative diseases and regenerative medicine. Dual-SMAD inhibition using small molecules has been identified as a key strategy for directing the differentiation of hiPSCs into NPCs by regulating specific cell signaling pathways. However, conventional culture methods are time-consuming and exhibit low differentiation efficiency in neural differentiation.

View Article and Find Full Text PDF

The application of mesoporous silica nanoparticles (MSN) as a drug carrier system got immense attention in the past few years due to their exceptional high drug loading efficiency. However, the process of drug loading is quite challenging compared to other lipid-based drug delivery systems. Hence, the MSNs using different catalysts were synthesized, and their mesoporous material characteristic was confirmed by the type IV adsorption-desorption isotherm using BET analyzer.

View Article and Find Full Text PDF

Self-Healing Superhydrophobic Coatings with Multiphase Repellence Property.

ACS Appl Mater Interfaces

January 2025

Centre for Advanced Laser Manufacturing (CALM), School of Mechanical Engineering, Shandong University of Technology, Zibo 255000, P. R. China.

Developing versatile, scalable, and durable coatings that repel various matters in different service environments is of great importance for engineered materials applications but remains highly challenging. Here, the mesoporous silica microspheres (HMS) fabricated by the hard template method were utilized as micro-nanocontainers to encapsulate the hydrophobic agent of perfluorooctyltriethoxysilane (F13) and the corrosion inhibitor of benzotriazole (BTA), forming the functional microsphere of F-HMS(BTA). Moreover, the synthesized organosilane-modified silica sol adhesive (SMP) and F-HMS(BTA) were further employed as the binder and functional filler to construct a superhydrophobic self-healing coating of SMP@F-HMS(BTA) on various engineering metals through scalable spraying.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!