The retention characteristics of a silicon oxynitride stationary phase for carbohydrate separation were studied in hydrophilic interaction chromatography mode. Four saccharides including mono-, di-, and trisaccharides were employed to investigate the effects of water content and buffer concentration in the mobile phase on hydrophilic interaction liquid chromatography retention. For the tested saccharides, the silicon oxynitride column demonstrated excellent performance in terms of separation efficiency, hydrophilicity, and interesting separation selectivity for carbohydrates compared to the bare silica stationary phase. Finally, the silicon oxynitride hydrophilic interaction liquid chromatography column was employed in the separation of complex samples of fructooligosaccharides, saponins, and steviol glycoside from natural products. The resulting chromatograms demonstrated good separation efficiency and longer retention compared with silica, which further confirmed the advantages and potential application of silicon oxynitride stationary phase for hydrophilic interaction liquid chromatography separation.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1002/jssc.201401413 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Triplet Exciton Sensitization of Silicon Mediated by Defect States in Hafnium Oxynitride.
Adv Mater
December 2024
Research Laboratory of Electronics, Massachusetts Institute of Technology, 77 Massachusetts Avenue, Cambridge, MA, 02139, USA.
Singlet exciton fission has the potential to increase the efficiency of crystalline silicon solar cells beyond the conventional single junction limit. Perhaps the largest obstacle to achieving this enhancement is uncertainty about energy coupling mechanisms at the interfaces between silicon and exciton fission materials such as tetracene. Here, the previously reported silicon-hafnium oxynitride-tetracene structure is studied and a combination of magnetic-field-dependent silicon photoluminescence measurements and density functional theory calculations is used to probe the influence of the interlayer composition on the triplet transfer process across the hafnium oxynitride interlayer.
View Article and Find Full Text PDFStructural, Mechanical, and Optical Properties of Laminate-Type Thin Film SWCNT/SiON Composites.
Nanomaterials (Basel)
November 2024
Department of Materials and Environmental Technology, School of Engineering, Tallinn University of Technology, Ehitajate tee 5, 19086 Tallinn, Estonia.
The development of new encapsulating coatings for flexible solar cells (SCs) can help address the complex problem of the short lifespan of these devices, as well as optimize the technological process of their production. In this study, new laminate-type protective composite coatings were prepared using a silicon oxynitride thin-film matrix obtained by curing the pre-ceramic polymer perhydropolysilazane (PHPS) through two low-temperature methods: (i) thermal annealing at 180 °C and (ii) exposure to UV radiation at wavelengths of 185 and 254 nm. Single-walled carbon nanotubes (SWCNTs) were used as fillers via dry transfer, facilitating their horizontal orientation within the matrix.
View Article and Find Full Text PDFPassivation Effect of Rock-Salt Nitride Materials on a Planar -Si Photocathode for Solar Water Reduction.
ACS Appl Mater Interfaces
November 2024
Department of Chemistry Education and Optoelectronic Convergence Research Center, Chonnam National University, Gwangju 61186, Republic of Korea.
Article Synopsis
- Photoelectrochemical water splitting is becoming important for producing clean hydrogen fuel using sunlight, driven by concerns over fossil fuels and pollution.
- Silicon photocathodes are effective due to their light absorption abilities, but issues like low voltage and rapid corrosion limit their performance.
- This study explores a titanium nitride passivation layer and a molybdenum oxynitride cocatalyst to improve the stability and efficiency of silicon photocathodes, achieving a high onset potential and over 140 hours of stable operation under harsh conditions.
Effect of N reactive gas flow rate on the structural, optical and wettability properties of silicon carbon oxynitride thin films.
Heliyon
August 2024
Department of Engineering Sciences, Hakim Sabzevari University, Sabzevar, Iran.
In the current research, the silicon carbon oxynitride (SiCON) thin film was deposited on the silicon (Si) substrate by radio frequency (RF) reactive magnetron sputtering method. To comprehensively assess the impact of nitrogen flux rate on thin film characteristics, a suite of advanced analytical methods was utilized. The GIXRD analysis confirmed that the SiCON thin film is amorphous in structure.
View Article and Find Full Text PDFArticle Synopsis
- - We propose an efficient design for a spin-photon interface using a diamond microdisk topped with a silicon oxynitride triangular lattice, allowing for effective light emission without needing precise alignment between layers.
- - The setup achieves a high quantum efficiency of up to 46% for a specific type of color center in the diamond, making it promising for larger-scale production of quantum light sources.
- - Our new optimization method leverages a dipole model to significantly enhance free space performance, yielding results similar to complex simulations but with a much shorter computation time (a 7·10 reduction).
Want AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!