5,10,15,20-Tetraphenylporphyrin chromium chloride (TPPCrCl) with added [Ph3P═N═PPh3](+)Cl(-) (PPN(+)Cl(-)) selectively polymerizes lactide (L and rac) dissolved in neat propylene oxide (PO) to yield polylactide (PLA) terminated by the -OCHMeCH2Cl group. At 0 °C and below, rac-LA yields polymers highly enriched in isotactic tetrads (iii). At 25 °C, some stereoselectivity is lost as transesterification becomes significant, and at 60 °C and above, enchainment of PO leads to the formation of 3,6-dimethyl-1,4-dioxan-2-one by a backbiting mechanism. At 0 °C, after the enchainment of L-(S,S)-LA in neat (R)-(+)-PO, the formation of (3S,6R)-3,6-dimethyl-1,4-dioxan-2-one occurs, while at higher temperatures the ratio of (3S,6R)-3,6-dimethyl-1,4-dioxan-2-one to (3R,6R)-3,6-dimethyl-1,4-dioxan-2-one falls to 3:2.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1021/ja512554t | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Gram Negative Biofilms: Structural and Functional Responses to Destruction by Antibiotic-Loaded Mixed Polymeric Micelles.
Microorganisms
December 2024
Department of Microbiology, Stephan Angeloff Institute of Microbiology, Bulgarian Academy of Sciences, Akad. G. Bonchev Street, bl. 26, 1113 Sofia, Bulgaria.
Biofilms are a well-known multifactorial virulence factor with a pivotal role in chronic bacterial infections. Their pathogenicity is determined by the combination of strain-specific mechanisms of virulence and the biofilm extracellular matrix (ECM) protecting the bacteria from the host immune defense and the action of antibacterials. The successful antibiofilm agents should combine antibacterial activity and good biocompatibility with the capacity to penetrate through the ECM.
View Article and Find Full Text PDFAlkaline-Assisted Excessive Impregnation for Enhancing Au Nanoparticle Loading on the TS-1 Zeolite.
Langmuir
December 2024
State Key Laboratory of Chemical Safety, 339th Songling Road, Qingdao 266071, China.
Direct epoxidation of propylene (CH) with hydrogen (H) and oxygen (O) over the Au/TS-1 catalyst is known as the "Holy Grail" reaction for propylene oxide (PO) synthesis. However, Au nanoparticle loading on TS-1 was limited by traditional deposition precipitation, impregnation and could not achieve ideal catalytic results. In this report, alkaline-assisted excessive impregnation helped to remove Cl from the Au impregnation precursor, improve the loading efficiency of Au nanoparticles and overcome the abnormal growth of nanograins.
View Article and Find Full Text PDFNovel Simple Approach for Production of Elastic Poly(propylene carbonate).
Polymers (Basel)
November 2024
Faculty of Chemistry, Lomonosov Moscow State University, Lenin Hills, 1, Bld. 3, 119991 Moscow, Russia.
The simple approach of increasing the elastic properties of atactic poly(propylene carbonate) (PPC) with Mn = 71.4 kDa, ĐM = M/M = 1.86, and predominantly carbonate units (>99%) is suggested by selecting the appropriate hot pressing temperature for PPC between 110 and 140 °C.
View Article and Find Full Text PDFEvaluation of the effect of sodium alginate, hydroxyethyl cellulose, aspartame, and poly(ethylene oxide)-b-poly(propylene oxide) copolymer on the in-vitro corrosion of AZ31 Mg alloy in simulated body fluid.
Int J Biol Macromol
December 2024
Interdisciplinary Research Centre for Advanced Materials, King Fahd University of Petroleum and Minerals, Dhahran 31261, Saudi Arabia; Department of Materials Science and Engineering, King Fahd University of Petroleum and Minerals, Dhahran 31261, Saudi Arabia. Electronic address:
Research on Mg-based implants has increased recently because of their compatibility and biodegradability. Despite this promise, challenges related to high corrosion rates hampered wide-scale deployment. This paper explores the inhibiting properties of biomacromolecules, sodium alginate (ALG), hydroxyethyl cellulose (HEC), aspartame (ASP), and poly(ethylene oxide)-b-poly(propylene oxide) copolymer (PEO-b-PPO) on AZ31 Mg alloy in simulated body fluid at 37 °C.
View Article and Find Full Text PDFPollution analysis of micro/nano meters glass particles and benzene produced from the friction cleaning process for the recovery of waste glass.
Waste Manag
December 2024
School of Environmental Science and Engineering, Guangdong Provincial Key Lab for Environmental Pollution Control and Remediation Technology, Sun Yat-sen University, Guangzhou 510006, the People's Republic of China. Electronic address:
Friction cleaning can effectively remove the paint coating (adhesive organic impurities) on the surface of waste glass, and promote the closed-loop recovery of urban silicic acid resources in industrial applications. However, due to a large number of mechanical collisions and wear during use, it is easy to produce powder dust and organic waste gas, and the pollution characteristics and mechanism have not been studied. In this study, the ball milling experiment was designed and the pollutants were tested and evaluated.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!