Gallium nitride (GaN) nanostructures were successfully synthesized by the nitridation of the electrochemically deposited gallium oxide (Ga2O3) through the utilization of a so-called ammoniating process. Ga2O3 nanostructures were firstly deposited on Si substrate by a simple two-terminal electrochemical technique at a constant current density of 0.15 A/cm(2) using a mixture of Ga2O3, HCl, NH4OH and H2O for 2 h. Then, the deposited Ga2O3 sample was ammoniated in a horizontal quartz tube single zone furnace at various ammoniating times and temperatures. The complete nitridation of Ga2O3 nanostructures at temperatures of 850°C and below was not observed even the ammoniating time was kept up to 45 min. After the ammoniating process at temperature of 900°C for 15 min, several prominent diffraction peaks correspond to hexagonal GaN (h-GaN) planes were detected, while no diffraction peak of Ga2O3 structure was detected, suggesting a complete transformation of Ga2O3 to GaN. Thus, temperature seems to be a key parameter in a nitridation process where the deoxidization rate of Ga2O3 to generate gaseous Ga2O increase with temperature. The growth mechanism for the transformation of Ga2O3 to GaN was proposed and discussed. It was found that a complete transformation can not be realized without a complete deoxidization of Ga2O3. A significant change of morphological structures takes place after a complete transformation of Ga2O3 to GaN where the original nanorod structures of Ga2O3 diminish, and a new nanowire-like GaN structures appear. These results show that the presented method seems to be promising in producing high-quality h-GaN nanostructures on Si.
Download full-text PDF |
Source |
---|---|
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC4273690 | PMC |
http://dx.doi.org/10.1186/1556-276X-9-685 | DOI Listing |
Sensors (Basel)
January 2025
Department of Mathematical, Physical and Computer Sciences, University of Parma, Viale delle Scienze 7/A, 43124 Parma, Italy.
Electrical contacts are of the greatest importance as they decisively contribute to the overall performance of photoresistors. Undoped κ-GaO is an ideal material for photoresistors with high performance in the UV-C spectral region thanks to its intrinsic solar blindness and extremely low dark current. The quality assessment of the contact/κ-GaO interface is therefore of paramount importance.
View Article and Find Full Text PDFNanomaterials (Basel)
January 2025
School of Microelectronics, Southern University of Science and Technology, Shenzhen 518055, China.
This study optimizes the CuO/GaO heterojunction diodes (HJDs) by tailoring the structural parameters of CuO layers. The hole concentration in the sputtered CuO was precisely controlled by adjusting the Ar/O gas ratio. Experimental investigations and TCAD simulations were employed to systematically evaluate the impact of the CuO layer dimension and hole concentration on the electrical performance of HJDs.
View Article and Find Full Text PDFSmall
January 2025
Key Laboratory of UV Light Emitting Materials and Technology, Ministry of Education, Northeast Normal University, Changchun, 130024, China.
In this study an (AlGa)O barrier layer is inserted between β-GaO and GaN in a p-GaN/n-GaO diode photodetector, causing the dark current to decrease considerably, and device performance to improve significantly. The β-GaO/β-(AlGa)O/GaN n-type/Barrier/p-type photodetector achieves a photocurrent gain of 1246, responsivity of 237 A W, and specific detectivity of 5.23 × 10 cm Hz W under a bias of -20 V.
View Article and Find Full Text PDFNano Lett
January 2025
Institute of Photoelectronic Thin Film Devices and Technology, State Key Laboratory of Photovoltaic Materials and Cells, Tianjin Key Laboratory of Efficient Solar Energy Utilization, Ministry of Education Engineering Research Center of Thin Film Photoelectronic Technology, Nankai University, 300350 Tianjin, China.
Hematite is a promising material for photoelectrochemical (PEC) water oxidation, but its photocurrent is limited by bulk charge recombination and poor oxidation kinetics. In this study, we report a high-performance FeO photoanode achieved through gradient surface gallium doping, utilizing a GaO overlayer on FeOOH precursors via atomic layer deposition (ALD) and co-annealing for Ga diffusion. The Ga-doped layer passivates surface states and modifies the band structure, creating a built-in electric field that enhances the charge separation efficiency.
View Article and Find Full Text PDFAdv Mater
January 2025
Advanced Semiconductor Laboratory, Electrical and Computer Engineering Program, Division of Computer, Electrical, and Mathematical Sciences and Engineering (CEMSE), King Abdullah University of Science and Technology (KAUST), Thuwal, 23955-6900, Kingdom of Saudi Arabia.
Ultrawide-bandgap gallium oxide (GaO) holds immense potential for crucial applications such as solar-blind photonics and high-power electronics. Although several GaO polymorphs, i.e.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!