The purpose of the present study was to formulate polymeric self-emulsifying curcumin nanocapsules with high encapsulation efficiency, good emulsification ability, and optimal globule size for localized targeting in the colon. Formulations were prepared using modified quasiemulsion solvent diffusion method. Concentration of formulation variables, namely, X1 (oil), X2 (polymeric emulsifier), and X3 (adsorbent), was optimized by design of experiments using Box-Behnken design, for its impact on mean globule size (Y1) and encapsulation efficiency (Y2) of the formulation. Polymeric nanocapsules with an average diameter of 100-180 nm and an encapsulation efficiency of 64.85±0.12% were obtained. In vitro studies revealed that formulations released the drug after 5 h lag time corresponding to the time to reach the colonic region. Pronounced localized action was inferred from the plasma concentration profile (C max 200 ng/mL) that depicts limited systemic absorption. Roentgenography study confirms the localized presence of carrier (0-2 h in upper GIT; 2-4 h in small intestine; and 4-24 h in the lower intestine). Optimized formulation showed significantly higher cytotoxicity (IC50 value 20.32 μM) in HT 29 colonic cancer cell line. The present study demonstrates systematic development of polymeric self-emulsifying nanocapsule formulation of curcumin for localized targeting in colon.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC4265377PMC
http://dx.doi.org/10.1155/2014/516069DOI Listing

Publication Analysis

Top Keywords

polymeric self-emulsifying
12
encapsulation efficiency
12
globule size
8
localized targeting
8
targeting colon
8
polymeric
5
localized
5
development optimization
4
optimization polymeric
4
self-emulsifying nanocapsules
4

Similar Publications

Silicon/carbon (Si/C) materials have achieved commercial applications as a solution to the problems of large volume expansion and short lifespan of silicon-based anodes in lithium-ion batteries. However, the potential risk of structural fracture and localized differences in surface adsorption properties lead to difficulties in maintaining the structural integrity of Si/C anodes using conventional binders during repeated lithiation/delithiation. Herein, an aqueous binder (PVA-g-M) based on polyvinyl alcohol (PVA) grafted methacrylic acid (MAA) obtained by self-emulsifyingemulsion polymerization is reported.

View Article and Find Full Text PDF

The oleo-gum-resin of Boswellia serrata, an Ayurvedic herb for the treatment of chronic inflammatory diseases, contains both volatile (terpenes) and nonvolatile (boswellic acids) molecules as responsible for its bioactivity. The present randomized, double-blinded, placebo-controlled, crossover study evaluated the human pharmacokinetics of a 'natural' hybrid-hydrogel formulation of a unique full-spectrum boswellia extract (BFQ-20) (standardized for both volatile and nonvolatile bioactives) in comparison with unformulated extract (U-BE), for the first time. Mass spectrometry coupled with LC (UPLC-MS/MS) and gas chromatography (GC-MS/MS) measurements of the plasma concentration of boswellic acids and α-thujene at different post-administration time points followed by a single dose (400 mg) of U-BE and BFQ-20, to healthy volunteers (n = 16), offered 4-fold enhancement in the overall bioavailability of boswellic acids from BFQ-20, [area under the curve (AUC) (BFQ-20) = 9484.

View Article and Find Full Text PDF

The study aimed to develop thiolated pluronic-based self-emulsifying drug delivery system (SNEDDS) targeted delivery of Rifampicin coated by arginine for enhanced drug loading, mucoadhesion, muco penetration, site-specific delivery, stabilized delivery against intracellular mycobacterium tuberculosis (M. tb), decreased bacterial burden and production by intracellular targeting. Oleic oil, PEG 200 and Tween 80 are selected as oil, co-surfactant and surfactant based on solubilizing capacity and pseudo ternary diagram region.

View Article and Find Full Text PDF

Oral formulations for highly lipophilic drugs: Impact of surface decoration on the efficacy of self-emulsifying drug delivery systems.

J Colloid Interface Sci

January 2025

Department of Pharmaceutical Technology, University of Innsbruck, Institute of Pharmacy, Center for Chemistry and Biomedicine, 6020, Innsbruck, Austria. Electronic address:

Aim: To evaluate the impact of the surface decoration of cannabidiol (CBD) loaded self-emulsifying drug delivery systems (SEDDS) on the efficacy of the formulations to cross the various barriers faced by orally administered drugs.

Methods: Polyethylene glycol (PEG)-free polyglycerol (PG)-based SEDDS, mixed zwitterionic phosphatidyl choline (PC)/PEG-containing SEDDS and PEG-based SEDDS were compared regarding stability against lipid degrading enzymes, surface properties, permeation across porcine mucus, cellular uptake and cytocompatibility.

Results: SEDDS with a size of about 200 nm with narrow size distributions were developed and loaded with 20-21 % of CBD.

View Article and Find Full Text PDF
Article Synopsis
  • A novel technique was developed to improve the water solubility and oral bioavailability of aceclofenac using different nanoparticle systems, with sodium carboxymethylcellulose (Na-CMC) proving to be the most effective polymer.
  • Various methods like spray-drying were used to create different solid dispersions with aceclofenac and Na-CMC, which resulted in nanoparticles with distinct properties such as size and morphology.
  • The study found that the self-nanoemulsifying drug delivery system (SNEDDS) had the best overall performance in enhancing drug solubility and bioavailability, making the nanoparticle screening method a valuable tool for improving other poorly soluble compounds.
View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!