In situ electrochemical stress measurements are used to interrogate changes in oxide structure before and during the oxygen evolution reaction (OER) from Ir, Ni, Co, Au, and Pt electrodes in alkaline electrolyte. Stress evolution during potential cycling reports on changes in oxidation state and oxide forms. Hysteresis observed in the potential-dependent stress from Ir, Au, and Pt electrodes is associated with chemical irreversibility in electrode composition and roughness. Alternatively, Ni and Co exhibit reversible conversion between hydroxide and oxyhydroxide forms during cycling. From the experimentally determined stress, charge passed during electrode oxidation, and Young's modulus, the change in strain exhibited by Ni and Co electrodes during hydroxide-oxyhydroxide conversion is calculated to be 7.0% and 8.4%, respectively. We also show that the magnitude of change in stress is proportional to the amount of material that is further oxidized.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1021/ac5030717 | DOI Listing |
Nanoscale
January 2025
Hubei Key Laboratory of Material Chemistry and Service Failure, Key Laboratory of Material Chemistry for Energy Conversion and Storage (Ministry of Education), Hubei Engineering Research Center for Biomaterials and Medical Protective Materials, School of Chemistry and Chemical Engineering, Huazhong University of Science and Technology, 1037 Luoyu Rd, Wuhan, China.
Acetaminophen (AP) is a widely used analgesic and antipyretic drug, but its excessive use poses health risks and contributes to environmental contamination. In response to the need for rapid, accurate, and cost-effective detection methods, we developed a highly sensitive and selective electrochemical sensor for AP. The sensor was based on a composite of UIO-66-NH (UN) and an MXene (TiC).
View Article and Find Full Text PDFChem Sci
January 2025
J. Mike Walker '66 Department of Mechanical Engineering, Texas A&M University College Station TX 77843 USA
This perspective work examines the current advancements in integrated CO capture and electrochemical conversion technologies, comparing the emerging methods of (1) electrochemical reactive capture (eRCC) though amine- and (bi)carbonate-mediated processes and (2) direct (flue gas) adsorptive capture and conversion (ACC) with the conventional approach of sequential carbon capture and conversion (SCCC). We initially identified and discussed a range of cell-level technological bottlenecks inherent to eRCC and ACC including, but not limited to, mass transport limitations of reactive species, limitation of dimerization, impurity effects, inadequate generation of CO to sustain industrially relevant current densities, and catalyst instabilities with respect to some eRCC electrolytes, amongst others. We followed this with stepwise perspectives on whether these are considered intrinsic challenges of the technologies - otherwise recommendations were disclosed where appropriate.
View Article and Find Full Text PDFACS Phys Chem Au
January 2025
Department of Medical Applied Chemistry, Chung Shan Medical University, Taichung 402, Taiwan.
Novel coumarin-triphenyliminophosphorane (TPIPP) fluorophores, synthesized via a nonhydrolytic Staudinger reaction, exhibit remarkable redox-responsive optical properties. Upon chemical and electrochemical oxidation, these compounds display a hypsochromic shift in absorption from 430 to 350 nm, accompanied by up to 11-fold fluorescence enhancement under 405 nm excitation. The fluorescence switching occurs at an electrochemical oxidation potential of approximately +2.
View Article and Find Full Text PDFRSC Adv
January 2025
University of Science and Technology of Hanoi, Vietnam Academy of Science and Technology 18 Hoang Quoc Viet Hanoi Vietnam
We report on the synthesis and characterization of an imine-type nickel complex produced the complexation of an generated 2-(iminomethyl)phenol ligand with Ni ion. The use of this complex as an electrocatalyst for H evolution in a DMF solution, with acetic acid as the proton source, was investigated in detail, employing both experimental analyses (electrochemical analysis, spectroscopy analysis) and theoretical analysis (plateau current analysis). The overpotential required for H evolution is about 590 mV with a faradaic efficiency of 49% after 3 hours bulk electrolysis, competing with the two-electron reduction of free-imine groups in the ligand.
View Article and Find Full Text PDFMater Horiz
January 2025
College of Materials Science & Engineering, Zhejiang University of Technology, Hangzhou 310014, P. R. China.
Developing hydrogels with high conductivity and toughness a facile strategy is important yet challenging. Herein, we proposed a new strategy to develop conductive hydrogels by growing metal dendrites. Water-soluble Sn ions were soaked into the gel and then converted to Sn dendrites an electrochemical reaction; the excessive Sn ions were finally removed by water dialysis, accompanied by dramatic shrinkage of the gel.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!