We propose a novel carrier-suppressed return-to-zero (CSRZ) to non-return-to-zero (NRZ) conversion scheme based on a single custom-designed fiber Bragg grating (FBG) with a knife-shaped spectrum. The structure of the FBG is designed and synthesized using a discrete layer-peeling inverse scattering technique. It is shown that such an FBG can replace the combination of interferometer and the cascaded filter that is invariably employed in the reported schemes for CSRZ to NRZ format conversion. Simulation results show that conversion of 40 Gbit/s CSRZ into NRZ signals results in a Q factor that is 4.5 dB greater than the previously reported schemes.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1364/AO.53.005649 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
We propose what we believe is a novel format conversion scheme using a few-mode fiber Bragg grating (FM-FBG) that can perform multichannel format conversion from carrier-suppressed return-to-zero (CSRZ) to non-return-to-zero (NRZ) for both LP and LP. The multichannel spectral response of FM-FBG is designed according to the algebraic difference between the CSRZ and NRZ spectra outlines. Additionally, the FM-FBG response spectra of LP are designed to shift with that of LP by the WDM-MDM channel spacing for filtering both modes together.
View Article and Find Full Text PDFThe dense wavelength division multiplexing (DWDM) technique has been used to provide a large capacity and low bandwidth loss for optical communication systems. In this paper, simulation designs by Optisystem15.0 of carrier-suppressed return to zero (CSRZ), differential phase shift keying (DPSK), and intensity modulation is proposed to determine which modulation format is more compatible with four and eight DWDM channels for transmitting an optical signal over 400 km distance.
View Article and Find Full Text PDFWe have proposed and demonstrated the optical time-and-polarization interleaving (OTPI) technique, which can effectively extend the transmitter bandwidth for an intensity modulation and direct detection (IM/DD) optical system. The 224-Gbit/s line-rate OTPI-PAM-4 signal is successfully transmitted over a 500-m standard single-mode fiber (SSMF) in the C band, using the transmitter with a bandwidth of 25 GHz and the receiver with a single photodiode. By using a 33%-return-to-zero (RZ) pulse train, a bit-error ratio (BER) below 7% hard-decision forward error correction (HD-FEC) threshold is achieved.
View Article and Find Full Text PDFWe investigate reduction of mode partition noise of a spectrally sliced Fabry-Perot laser diode (FP-LD) for application to seeded DWDM systems. The proposed scheme for the noise reduction incorporates a fiber-based Mach-Zehnder interferometer (MZI) and a reflective semiconductor optical amplifier (RSOA). The MZI enables to reduce a relative intensity noise (RIN) more than 3 dB with better noise distributions.
View Article and Find Full Text PDFA novel multichannel carrier-suppressed return-to-zero (CSRZ) to non-return-to-zero (NRZ) format conversion scheme based on a single custom-designed fiber Bragg grating (FBG) with comb spectra is proposed. The spectral response of each channel is designed according to the algebraic difference between the CSRZ and NRZ spectra outlines. The tailored group delays are introduced to minimize the maximum refractive index modulation.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!