The discovery of ballistic transport in graphene grown on SiC(0001) sidewall trenches has sparked an intense effort to uncover the origin of this exceptional conductivity. How a ribbon's edge termination, width, and topography influence its transport is not yet understood. This work presents the first structural and electronic comparison of sidewall graphene grown with different edge terminations. We show that armchair and zigzag terminated ribbons, grown from SiC, have very different topographies and interact differently with the substrate, properties that are critical to device architecture in sidewall ribbon electronics.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1021/nl502942z | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Copper Oxidation-Induced Nanoscale Deformation of Electromechanical, Laminate Polymer/Graphene Thin Films during Thermal Annealing: Implications for Flexible, Transparent, and Conductive Electrodes.
ACS Appl Nano Mater
December 2024
Department of Chemistry, Virginia Tech, Blacksburg, Virginia 24061, United States.
The transfer of large-area, continuous, chemical vapor deposition (CVD)-grown graphene without introducing defects remains a challenge for fabricating graphene-based electronics. Polymer thin films are commonly used as supports for transferring graphene, but they typically require thermal annealing before transfer. However, little work has been done to thoroughly investigate how thermal annealing affects the polymer/graphene thin film when directly annealed on the growth substrate.
View Article and Find Full Text PDFAtomic layer deposition of Pt nanoparticles grown onto 3D B-doped graphene as an efficient ultra-low Pt loading catalyst layer for PEMFC.
J Colloid Interface Sci
December 2024
Collaborative Innovation Center of Sustainable Energy Materials, School of Physical Science and Technology, Guangxi University; Guangxi Key Laboratory of Electrochemical Energy Materials, State Key Laboratory of Featured Metal Materials and Life-cycle Safety for Composite Structures, Nanning 530004, China. Electronic address:
Article Synopsis
- Researchers developed a new catalyst layer using 3D porous B-doped graphene integrated with ultra-low platinum (Pt) for proton exchange membrane fuel cells (PEMFC), aiming to improve activity and durability.
- The Pt/3D-PBG configuration achieved a maximum power density of 0.90 W/cm² while meeting the Department of Energy's 2025 targets, which is a significant breakthrough.
- The integration of boron (B) dopants enhances both the deposition of Pt and its electronic interaction, resulting in better performance and stability of the fuel cell at lower amounts of platinum.
Direct synthesis of multilayer graphene on a microscale ridge-patterned copper substrate.
Micron
December 2024
School of Chemical and Biological Engineering, and Institute of Chemical Processes, Seoul National University, Seoul 08826, Republic of Korea; Center for Nanoparticle Research, Institute for Basic Science (IBS), Seoul National University, Seoul 08826, Republic of Korea; Advanced Institute of Convergence Technology, Seoul National University, Suwon 16229, Republic of Korea; Institute of Engineering Research, College of Engineering, Seoul National University, Seoul 08826, Republic of Korea. Electronic address:
Graphene's exceptional physical properties, such as high thermal conductivity and mechanical strength, have attracted significant interest for its integration in transistors and thermal interface materials. While achieving various conformations of graphene is desirable for such applications, synthesizing graphene with target conformations remains a challenge. In this work, we present a method for synthesizing multilayer graphene with ridged conformations, using a microscale ridge-patterned copper (Cu) layer that was epitaxially deposited on a sapphire substrate.
View Article and Find Full Text PDFQuantitative Measurement of Interfacial Adhesion of CVD Grown Bilayer WS on Various Substrates.
Small
December 2024
School of Mechanical and Materials Engineering, Indian Institute of Technology Mandi, Himachal Pradesh, 175075, India.
The interfacial adhesion between transition metal dichalcogenides (TMDs) and the growth substrate significantly influences the employment of flakes in various applications. Most previous studies have focused on MoS and graphene, particularly their interaction with SiO/Si substrates. In this work, the adhesion strength of CVD-grown bilayer WS is directly measured using the nano scratch technique on three different substrates-Sapphire, SiO/Si, and fused quartz.
View Article and Find Full Text PDFAdvanced solar photo-Fenton-like process with directly growing nano-heterojunctions on graphite fiber felt for phenolic wastewater treatment :Synergistically expand the pH activity range and facilitate the Fe(III)/Fe(II) cycle.
Chemosphere
December 2024
School of Materials Science and Engineering, Shijiazhuang Tiedao University, Hebei Key Laboratory of New Materials for Collaborative Development of Traffic Engineering and Environment. Electronic address:
Nanoscale FeWO/BiVO heterojunctions were directly grown on the graphite fiber felt (GF) with good conductivity to construct a FeWO/BiVO @GF solar photo-Fenton like wastewater treatment system. The removal effect of COD from phenolic wastewater and the mechanism of synergistic improvement of wastewater treatment efficiency by this system were investigated. The FeWO/BiVO heterojunction prepared by hydrothermal method exhibited higher photoelectric conversion efficiency and solar light utilization rate, thus endowing FeWO/BiVO with excellent solar-Fenton like reaction activity.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!