The performance of polymer field-effect transistors (PFETs) based on short rigid rod semiconducting poly(2,5-didodecyloxy-p-phenyleneethynylene) (D-OPPE) is highlighted. The controlled heating and cooling of thin films of D-OPPE allows for a recrystallization from the melt, boosting the performance of D-OPPE-based transistors. The improved film properties induced by controlled annealing lead to a hole field-effect mobility around 0.014 cm V s , an on/off ratio of 10 , a sub-threshold swing of 3 V dec and a threshold voltage of -35 V, employing a poly(methyl methacrylate) (PMMA) gate dielectric. Thus, PFETs out of D-OPPE compete now with spin-coated, polycrystalline poly(3-hexylthiophene)-based PFETs.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1002/marc.201400203 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Design of an Atomic Layer-Deposited InO/GaO Channel Structure for High-Performance Thin-Film Transistors.
ACS Appl Mater Interfaces
January 2025
Department of Electronic Engineering, Hanyang University, Seoul 04763, Republic of Korea.
For potential application in advanced memory devices such as dynamic random-access memory (DRAM) or NAND flash, nanolaminated indium oxide (In-O) and gallium oxide (Ga-O) films with five different vertical cation distributions were grown and investigated by using a plasma-enhanced atomic layer deposition (PEALD) process. Specifically, this study provides an in-depth examination of how the control of individual layer thicknesses in the nanolaminated (NL) IGO structure impacts not only the physical and chemical properties of the thin film but also the overall device performance. To eliminate the influence of the cation composition ratio and overall thickness on the IGO thin film, these parameters were held constant across all conditions.
View Article and Find Full Text PDFFabrication of high-performance tin halide perovskite thin-film transistors via chemical solution-based composition engineering.
Nat Protoc
January 2025
Department of Chemical Engineering, Pohang University of Science and Technology, Pohang, Gyeongbuk, Republic of Korea.
Metal halide perovskite semiconductors have attracted considerable attention because they enable the development of devices with exceptional optoelectronic and electronic properties via cost-effective and high-throughput chemical solution processes. However, challenges persist in the solution processing of perovskite films, including limited control over crystallization and the formation of defective deposits, leading to suboptimal device performance and reproducibility. Tin (Sn) halide perovskite holds promise for achieving high-performance thin-film transistors (TFTs) due to its intrinsic high hole mobility.
View Article and Find Full Text PDFImprovement of glucose detection using 10 nm AlO thin film on diamond solution-gate field-effect transistor.
Talanta
January 2025
Key Laboratory for Physical Electronics and Devices of the Ministry of Education & School of Science & Shaanxi Key Laboratory of Information Photonic Technique & Institute of Wide Bandgap Semiconductors, Xi'an Jiaotong University, Xi'an, 710049, China. Electronic address:
Glucose detection is crucial for diagnosis, prevention and treatment of diabetes mellitus. In this work, 10 nm AlO thin film was introduced on the channel of diamond solution-gate field-effect transistor (SGFET) to improve the performance of glucose detection. AFM results show the roughness of channel surface increased after AlO thin film deposition.
View Article and Find Full Text PDFModification of the Se/MoO Rear Interface for Efficient Wide-Band-Gap Trigonal Selenium Solar Cells.
ACS Appl Mater Interfaces
January 2025
Institute of New Energy Technology, College of Physics & Optoelectronic Engineering, Jinan University, Guangzhou 510632, China.
Trigonal selenium (t-Se) is a promising wide-band-gap photovoltaic material with a high absorption coefficient, abundant resources, simple composition, nontoxicity, and a low melting point, making it suitable for absorbers in advanced indoor and tandem photovoltaic applications. However, severe electrical losses at the rear interface of the t-Se absorber, caused by work function and lattice mismatches, limit the voltage output and overall performance. In this study, a strategy to enhance carrier transport and collection by modifying interfacial chemical interactions is proposed.
View Article and Find Full Text PDFOpportunities and challenges of lead-free metal halide perovskites for luminescence.
Chem Sci
October 2024
Key Laboratory of Optoelectronic Technology and Systems (Ministry of Education), Chongqing University Chongqing 400044 China
Metal halide perovskites (MHPs) have been developed rapidly for application in light-emitting diodes (LEDs), lasers, solar cells, photodetectors and other fields in recent years due to their excellent photoelectronic properties, and they have attracted the attention of many researchers. Perovskite LEDs (PeLEDs) show great promise for next-generation lighting and display technologies, and the external quantum efficiency (EQE) values of polycrystalline thin-film PeLEDs exceed 20%, which is undoubtedly a big breakthrough in lighting and display fields. However, the toxicity and instabilities of lead-based MHPs remain major obstacles limiting their further commercial applications.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!