Purpose: We defined the theoretical oxygen tension behind modern scleral contact lenses (CLs) made of different rigid gas permeable (RGP) materials, assuming different thickness of the tear layer behind the lens. A second goal was to show clinically the effect of the postlens tear film on corneal swelling.
Methods: We simulated the partial pressure of oxygen across the cornea behind scleral CLs made of different lens materials (oxygen permeability Dk, 75-200 barrer) and different thickness (Tav, 100-300 μm). Postlens tear film thicknesses (Tpost-tear) ranging from 150 to 350 μm were considered. Eight healthy subjects were fitted randomly with a scleral lens with a thin and a thick postlens tear layer in two different sessions for a period of 3 hours under open-eye conditions.
Results: The CLs with less than 125 barrer of Dk and a thickness over 200 μm depleted the oxygen availability at the lens-cornea interface below 55 mm Hg for a postlens tear film of 150 μm. For a postlens tear film thickness of 350 μm, no combination of material or lens thickness will meet the criteria of 55 mm Hg. Our clinical measures of corneal edema showed that this was significantly higher (P < 0.001, Wilcoxon signed ranks test) with the thicker compared to the thinner Tpost-tear (mean ± SD, 1.66 ± 1.12 vs. 4.27 ± 1.19%).
Conclusions: Scleral RGP CLs must be comprised of at least 125 barrer of oxygen permeability and up to 200 μm thick to avoid hypoxic effects even under open eye conditions. Postlens tear film layer should be below 150 μm to avoid clinically significant edema.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1167/iovs.14-14038 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Repeatability of lipid layer thickness using LipiView® following removal of contact lenses and its relationship to comfort.
Ophthalmic Physiol Opt
January 2025
School of Optometry and Vision Science, University of New South Wales, Sydney, New South Wales, Australia.
Purpose: To assess the repeatability of lipid layer thickness (LLT) measurement using the LipiView® interferometer after daily disposable contact lens (CL) wear and correlation with ocular comfort in soft contact lens wearers.
Methods: A prospective study was conducted over two consecutive months, wherein CL wearers (n = 20) wore either Somofilcon A or Verofilcon A daily disposable CLs in a crossover design, switching lenses after 1 month. The pre-corneal tear film LLT was measured at the end of each month after CLs had been worn for at least 6 h.
Quantifying tear exchange during rigid contact lens wear using corneoscleral profilometry: A proof of concept study.
Ophthalmic Physiol Opt
January 2025
Contact Lens and Visual Optics Laboratory, Optometry and Vision Science, Centre for Vision and Eye Research, Queensland University of Technology, Brisbane, Queensland, Australia.
Introduction: Tear exchange during contact lens wear is essential for ocular surface integrity, facilitating debris removal, and maintaining corneal metabolism. Fluorophotometry and fluorogram methods are typically used to measure tear exchange, which require hardware modifications to a slit lamp biomicroscope. This manuscript introduces an alternative method using a corneoscleral profilometer, the Eye Surface Profiler (ESP), to quantify tear exchange during corneal and scleral rigid lens wear by assessing fluorescence intensity changes over time.
View Article and Find Full Text PDFContact lens fenestrations and channels in relation to tear exchange and corneal oedema.
Clin Exp Optom
November 2024
Centre for Vision and Eye Research, Optometry and Vision Science, Queensland University of Technology, Brisbane, Australia.
Oxygen delivery and tear exchange are considered essential to maintain corneal homoeostasis during contact lens wear. Since the 1940s, fenestrations and back surface channels have been utilised in scleral, corneal rigid, and soft contact lenses in an attempt to enhance corneal oxygen transmission, facilitate the removal of carbon dioxide from the post-lens tear layer, minimise corneal oedema and prevent post-lens tear stagnation. This review examines the use of contact lens fenestrations and channels in both clinical and laboratory settings, and the effect of these modifications upon tear exchange and corneal oedema.
View Article and Find Full Text PDFRaman spectroscopy to investigate early biochemical alterations in human tears caused by contact lenses.
Clin Exp Optom
January 2025
Department of Materials Science, University of Milano-Bicocca, Milan, Italy.
Clinical Relevance: The interaction between contact lenses and tear film plays a critical role in lens biocompatibility and can influence discomfort during wear. Early detection of biochemical changes is important for improving ocular surface health, preventing complications, and developing advanced lens materials to enhance long-term comfort.
Background: The pursuit of biocompatible lens materials requires a thorough understanding of their interaction with tear environment.
Changes in bulbar conjunctival microcirculation and microvasculature during short-term scleral lens wearing and their associated factors.
Cont Lens Anterior Eye
October 2024
The School of Ophthalmology and Optometry, Wenzhou Medical University, Wenzhou, Zhejiang, China. Electronic address:
Objective: To explore the changes in microcirculation and microvasculature of the bulbar conjunctiva during the short-term wearing of the scleral lenses (ScCL). And investigate the factors affecting the microcirculation and microvasculature of the bulbar conjunctiva.
Methods: In this prospective cross-sectional study, functional slit lamp biomicroscopy (FSLB) was used to image the ocular surface microcirculation and microvascular images at two different sites (under the area of ScCL and outside of the area of ScCL) before (baseline) and during the wearing of ScCL at 0 h, 1 h, 2 h and 3 h.
Want AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!