In modern medico-legal literature, only a small number of publications deal with fatal injuries from black powder guns. Most of them focus on the morphological features such as intense soot soiling, blast tattooing and burn effects in close-range shots or describe the wound ballistics of spherical lead bullets. Another kind of "unusual" and potentially lethal weapons are handguns destined for firing only blank cartridges such as starter and alarm pistols. The dangerousness of these guns is restricted to very close and contact range shots and results from the gas jet produced by the deflagration of the propellant. The present paper reports on a suicide committed with a muzzle-loading percussion pistol cal. 45. An unusually large stellate entrance wound was located in the precordial region, accompanied by an imprint mark from the ramrod and a faint greenish discoloration (apparently due to the formation of sulfhemoglobin). Autopsy revealed an oversized powder cavity, multiple fractures of the anterior thoracic wall as well as ruptures of the heart, the aorta, the left hepatic lobe and the diaphragm. In total, the zone of mechanical destruction had a diameter of approx. 15 cm. As there was no exit wound and no bullet lodged in the body, the injury was caused exclusively by the inrushing combustion gases of the propellant (black powder) comparable with the gas jet of a blank cartridge gun. In contact shots to ballistic gelatine using the suicide's pistol loaded with black powder but no projectile, the formation of a nearly spherical cavity could be demonstrated by means of a high-speed camera. The extent of the temporary cavity after firing with 5 g of black powder roughly corresponded to the zone of destruction found in the suicide's body.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1007/s00414-014-1064-3 | DOI Listing |
J Forensic Sci
December 2024
Federal University of Rio de Janeiro, Institute of Biomedical Sciences, Rio de Janeiro, Rio de Janeiro, Brazil.
Postmortem identification through fingerprints often encounters significant challenges, particularly with damaged epidermal tissue, due to factors such as carbonization, putrefaction, mummification, or saponification. Traditional techniques frequently fall short in cases involving fragile skin, which complicates the collection of clear fingerprint impressions. This study presents and evaluates an adaptive modification of the transillumination technique, integrating it with moistened black volcano powder to enhance fingerprint recovery from compromised postmortem tissue.
View Article and Find Full Text PDFACS Bio Med Chem Au
December 2024
The University of Arizona College of Pharmacy, Skaggs Pharmaceutical Sciences Center, Tucson, Arizona 85721, United States.
This study introduces novel cospray-dried (Co-SD) formulations of simvastatin, a Nrf2 activator ROCK inhibitor, with l-carnitine as molecular mixtures in various molar ratios for targeted pulmonary inhalation aerosol delivery in pulmonary hypertension, optimized for excipient-free dry powder inhalers (DPIs). The two components were spray-dried at various molar ratios by using different starting feed solution concentrations and process parameters. In addition to comprehensive physicochemical characterization, in vitro aerosol dispersion performance as DPIs using two FDA-approved DPI devices with different shear stress properties, in vitro viability as a function of dose on 2D human pulmonary cellular monolayers and on 3D small airway epithelia human primary cultures at the air-liquid interface (ALI), and in vitro transepithelial electrical resistance (TEER) at the ALI were conducted.
View Article and Find Full Text PDFHeliyon
December 2024
Department of Animal Resources Science, Kongju National University, Yesan, 32439, Republic of Korea.
This study investigated the tenderization and quality characteristics of Korean black goat biceps femoris treated with ginger powder extracts (0 %, 3 %, 5 %, and 7 %). The proximate composition, pH, color, shear force, water-holding capacity, sarcomere length, fiber cross-sectional area, and sensory properties were determined and analyzed according to the concentration of the ginger powder extract. The shear force decreased significantly with increasing concentrations of ginger powder extract ( < 0.
View Article and Find Full Text PDFPolymers (Basel)
November 2024
Department of Vehicle Engineering, WuFeng University, Chia-Yi 621303, Taiwan.
The bone plates used in surgery to assist in fracture healing are often manufactured by metal injection molding (MIM) using a feedstock material consisting of metal powder and polymer binder. However, if the local powder concentration is too low or uneven, black lines may be formed, which impair the product appearance. Furthermore, if the melding temperature is too low, it can lead to meld lines and reduced mechanical properties.
View Article and Find Full Text PDFFoods
November 2024
Breeding Department, Maize Research Institute, Zemun Polje, Slobodana Bajića 1, 11080 Belgrade, Serbia.
Oats are gluten-free cereals rich in dietary fiber, -glucans, phenolic acids, flavonoids, carotenoids, vitamin E, and phytosterols. They have been used in traditional medicine for centuries to treat hyperacidity, acute pancreatitis, burns, and skin inflammation. This study assessed the nutritional and phenolic profile of oat flour (OF) and ground oat husks (OHs) from white, brown, and black hulled oat genotypes, as well as the antioxidant and antimicrobial activity of their extracts.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!