Background/aim: Stevioside is a glycoside that supposedly possesses a number of pharmacodynamic effects such as anti-infective, hypoglycemic, along with the beneficial influence on the cardiovascular system. The aim of this study was to determine the effect of rats pretreatment with aqueous solution of stevioside on pharmacological actions of adrenaline, metoprolol and verapamil.

Methods: Rats were administered (intraperitoneally 200 mg/kg/day) stevioside as aqueous solution or physiological saline in the course of 5 days, then anaesthetized with urethane and the first ECG recording was made. The prepared jugular vein was connected to an infusion pump with adrenaline (0.1 mg/mL), verapamil (2.5 mg/mL) or metoprolol (1 mg/mL). Control animals, pretreated with saline, in addition to the mentioned drugs, were also infused with the solution of stevioside (200 mg/mL) in the course of recording ECG.

Results: The infusion of stevioside produced no significant changes in ECG, even at a dose exceeding 1,600 mg/kg. In the control group, a dose of adrenaline of 0.07 +/- 0.02 mg/kg decreased the heart rate, whereas in the stevioside-pretreated rats this occurred at a significantly higher dose (0.13 +/- 0.03 mg/kg). In stevioside-pretreated rats, the amount of verapamil needed to produce the decrease in heart rate was significantly lower compared to the control. The pretreatment with stevioside caused no significant changes in the parameters registered on ECG during infusion of metoprolol.

Conclusion: The results suggest that pretreatment with stevioside may change the effect of adrenaline and verapamile on the heart rate.

Download full-text PDF

Source
http://dx.doi.org/10.2298/vsp120524014vDOI Listing

Publication Analysis

Top Keywords

aqueous solution
12
solution stevioside
12
heart rate
12
stevioside
8
stevioside pharmacological
8
stevioside-pretreated rats
8
pretreatment stevioside
8
pharmacological properties
4
properties cardioactive
4
cardioactive drugs
4

Similar Publications

Pharmaceuticals removal from aqueous solution by water hyacinth (Eichhornia crassipes): a comprehensive investigation of kinetics, equilibrium, and thermodynamics.

Environ Sci Pollut Res Int

January 2025

Grupo de Investigación Materiales Con Impacto (Mat&Mpac), Facultad de Ciencias Básicas, Universidad de Medellín, Carrera 87 No. 30-65, 050026, Medellín, Colombia.

This study shows the efficiency of WH-C450, an adsorbent obtained from water hyacinth (WH) biomass, in the removal of sulfamethoxazole (SMX) from aqueous solutions. The process involves calcination of WH at 450 °C to produce an optimal adsorbent material capable of removing up to 73% of SMX and maximum SMX adsorption capacity of 132.23 mg/g.

View Article and Find Full Text PDF

In present study, 15 morphologically different fungi isolated from rhizopheric soils of an industrial area were screened for their Zn removal efficiency from aqueous solution. Isolate depicting highest potential was molecularly identified as Aspergillus terreus SJP02. Effect of various process parameters viz.

View Article and Find Full Text PDF

Three composites based on Poly (meta-aminophenol) (PmAP), (3-aminopropyl) triethoxysilane (APTES) and graphene oxide (GO) were synthesized with initial GO dispersion of 3.3, 6.6, and 9.

View Article and Find Full Text PDF

Structural Basis of Ultralow Capacitances at Metal-Nonaqueous Solution Interfaces.

J Am Chem Soc

January 2025

State Key Laboratory of Materials-Oriented Chemical Engineering, College of Chemical Engineering, Nanjing Tech University, Nanjing 211816, China.

Metal-nonaqueous solution interfaces, a key to many electrochemical technologies, including lithium metal batteries, are much less understood than their aqueous counterparts. Herein, on several metal-nonaqueous solution interfaces, we observe capacitances that are 2 orders of magnitude lower than the usual double-layer capacitance. Combining electrochemical impedance spectroscopy, atomic force microscopy, and physical modeling, we ascribe the ultralow capacitance to an interfacial layer of 10-100 nm above the metal surface.

View Article and Find Full Text PDF

Localized Nanopore Fabrication in Silicon Nitride Membranes by Femtosecond Laser Exposure and Subsequent Controlled Breakdown.

ACS Appl Mater Interfaces

January 2025

Division of Micro and Nanosystems (MST), School of Electrical Engineering and Computer Science (EECS), KTH Royal Institute of Technology, Stockholm SE-10044, Sweden.

Controlled breakdown has emerged as an effective method for fabricating solid-state nanopores in thin suspended dielectric membranes for various biomolecular sensing applications. On an unpatterned membrane, the site of nanopore formation by controlled breakdown is random. Nanopore formation on a specific site on the membrane has previously been realized using local thinning of the membrane by lithographic processes or laser-assisted photothermal etching under immersion in an aqueous salt solution.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!