AI Article Synopsis
Article Abstract
Nicotine, a highly toxic alkaloid, has been detected in effluents, surface and groundwater and even bottled mineral water. The present work studied the photocatalytic degradation of nicotine in aqueous solution, under ultraviolet irradiation. The experiments were carried out using commercial (ZnO, TiO2) and non-conventional catalysts, which were prepared from industrial and laboratory waste. Two experimental designs (CCD) were performed for both commercial catalysts, and initial nicotine concentration, catalyst concentration and initial solution pH effects were studied. Then, the synthesized catalysts were tested under the optimal conditions which were found through CCDs. Using commercial catalysts, about 98% of the alkaloid was degraded by ZnO, and 88% by TiO2, in 1h. Among the non-conventional catalysts, the highest photocatalytic degradation (44%) was achieved using the catalyst prepared from a petrochemical industry residue.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1016/j.scitotenv.2014.06.139 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Enhancing the Built-in Electric Field in Oxygen Vacancies-Enriched I-Doped BiOCl for Visible Light-Driven Photocatalytic Oxidation.
Inorg Chem
December 2024
School of Chemistry and Chemical Engineering, Southwest University, Chongqing 400715, P. R. China.
In semiconductor catalysts, rational doping of nonmetallic elements holds significant scientific and technological importance for enhancing photocatalytic performance. Here, using a one-step hydrothermal technique, we synthesized iodine-doped BiOCl composite and evaluated the impact of iodine doping on its photocatalytic capability for organic dye degradation under visible light irradiation. In this study, we demonstrate that the introduction of iodide ions not only provides an ideal built-in electric field (BIEF) for BiOCl but also induces the generation of additional oxygen vacancies (OVs).
View Article and Find Full Text PDFData-Driven Machine Learning Strategy for Designing Metal-Ion-Doped γ-BiMoO Photocatalysts to Enhance Degradation Performance.
J Phys Chem B
December 2024
Science and Technology on Aerospace Chemical Power Laboratory, Laboratory of Emergency Safety and Rescue Technology, Hubei Institute of Aerospace Chemotechnology, Xiangyang 441003, China.
Doped semiconductors are often used to improve photocatalytic efficiency and address the challenges of easy recombination of electron-hole pairs and poor photoluminescence. However, the reproducibility and complexity of experimental studies result in time-consuming and less cost-effective studies, and it is difficult to gain insights into the intrinsic properties of doped photocatalysts to control their performance. Introducing a machine learning approach, we constructed a photocatalytic model of transition-metal- and rare earth metal-ion-doped γ-BiMoO.
View Article and Find Full Text PDFUnveiling the role of sintering temperatures in the physical properties of Cu-Mg ferrite nanoparticles for photocatalytic application.
Heliyon
December 2024
Department of Physics, University of Dhaka, Dhaka, 1000, Bangladesh.
This research presents an explicit analysis of the effects of sintering temperature (T) on the structural, morphological, magnetic, and optical properties of CuMgFeO nanoferrites synthesized via the sol-gel method. To accomplish it, Cu-Mg ferrite NPs were sintered at temperatures ranging from 300 to 800 °C in increments of 100 with a constant holding duration of 5 h. Thermogravimetric analysis was used to observe the degradation of organic components and the thermally stable zone of the material.
View Article and Find Full Text PDFThermodynamic and kinetic insights into azo dyes photocatalytic degradation on biogenically synthesized ZnO nanoparticles and their antibacterial potential.
Heliyon
December 2024
Chemistry Department, Faculty of Science, Cairo University, Giza, 12613, Egypt.
The extensive use of azo dyes in textile and pharmaceutical industries pose significant environmental and health risks. This problem requires to be tackled forthwith through a cheap, environmentally friendly and viable approach to mitigate water pollution. In this context, the green synthesis method was used for synthesis of ZnO NPs.
View Article and Find Full Text PDFMesoporous NiFe2O4@g-C3N4-based p-n Heterostructures for Boosting Solar-Driven Photocatalytic Dye Degradation and Hydrogen Evolution.
Chem Asian J
December 2024
SN Bose National Centre for Basic Sciences, Condensed Matter and Materials Physics, JD Block, Sector III, 700106, Salt Lake City, INDIA.
Mass-fraction-optimized heterojunction composites featuring precisely engineered interfaces and mesoporous structures are crucial for improving light absorption, minimizing electron-hole recombination, and boosting overall catalytic efficiency. Herein, highly efficient mesoporous-NiFe2O4@g-C3N4 heterojunctions were developed by embedding p-type NiFe2O4 nanoparticles (NPs) within n-type porous ultrathin g-C3N4 (p-uCN) nanosheets. The optimized NiFe2O4@g-C3N4, loaded with 20wt% magnetic counterparts, exhibits exceptional photocatalytic methylene blue degradation, achieving the highest performance in both photocatalytic and photo-Fenton processes with rate constants of 0.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!