Hypothesis: Modification of the interface by blending of surfactants produces considerable changes in the elastic rigidity of the interface, which in turn affects the physicochemical properties of w/o microemulsions. Hence, it could be possible to tune the thermodynamic properties, microstructures and antimicrobial activity of microemulsions by using ionic/non-ionic mixed surfactants and polar lipophilic oil, which are widely used in biologically relevant systems.
Experiments: The present report was aimed at precise characterization of mixed cetyltrimethylammonium bromide and polyoxyethylene (23) lauryl ether microemulsions stabilized in 1-pentanol (Pn) and isopropyl myristate at different physicochemical conditions by employing phase studies, the dilution method, conductivity, DLS, FTIR (with HOD probing) and (1)H NMR measurements. Further, microbiological activities at different compositions were examined against two bacterial strains Bacillus subtilis and Escherichia coli at 303 K.
Findings: The formation of mixed surfactant microemulsions was found to be spontaneous at all compositions, whereas it was endothermic at equimolar composition. FTIR and (1)H NMR measurements showed the existence of bulk-like, bound and trapped water molecules in confined environments. Interestingly, composition dependence of both highest and lowest inhibitory effects was observed against the bacterial strains, whereas similar features in spontaneity of microemulsion formation were also evidenced. These results suggested a close relationship between thermodynamic stability and antimicrobial activities. Such studies on polar lipophilic oil derived mixed surfactant microemulsions have not been reported earlier.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1016/j.jcis.2014.05.042 | DOI Listing |
ACS Omega
December 2024
Petroleum Engineering Department, King Fahd University of Petroleum & Minerals, Dhahran 31261,Saudi Arabia.
Surfactant chemical-enhanced oil recovery plays a crucial role in achieving ultralow interfacial tension between remaining crude oil and injected water, thereby enhancing oil recovery rates. This study aims to investigate the impact of pressure and gas/oil ratios (GORs) on surfactant flooding for enhanced oil recovery, focusing on high-pressure and high-temperature (HPHT) conditions. High-temperature salinity screening was employed to identify optimal surfactant formulations for Type III microemulsions.
View Article and Find Full Text PDFHeliyon
December 2024
Department of Condensed Matter Physics, Faculty of Physics, University of Tabriz, 29 Bahman Blvd., Tabriz, Iran.
Research on hydroxyapatite (HAP) coatings for bone tissue applications has been investigated for decades due to their significant osteoconductive and bioactivity properties. HAP closely resembles the mineral component of human bone, making it ideal for biomedical applications such as implants. This study investigates the synthesis of hydroxyapatite nanoparticles (HAP-NPs) via the microemulsion method, which is essential for creating HAP coatings on the Ti-6Al-4V substrate.
View Article and Find Full Text PDFACS Omega
December 2024
Enhanced Oil Recovery & Carbon Utilization and Storage Laboratory, Department of Petroleum Engineering, Indian Institute of Technology (Indian School of Mines), Dhanbad 826 004, India.
This research explores the development of engineered oil-water microemulsions stabilized by a synergistic combination of polymer and surfactant to enhance stability and interfacial properties for improved enhanced oil recovery (EOR). Conventional surfactant-stabilized emulsions often suffer from phase instability and limited wettability alteration during water flooding and chemical injection, hindering the EOR efficiency. In contrast, our formulations incorporating polymers significantly increase the emulsion viscosity and resilience to temperature fluctuations, resulting in enhanced phase stability.
View Article and Find Full Text PDFPolymers (Basel)
November 2024
Technology of Synthetic Rubber Department, Kazan National Research Technological University, 68 Karl Marx Str., 420015 Kazan, Russia.
Polymers with micro- and mesoporous structure are promising as materials for gas storage and separation, encapsulating agents for controlled drug release, carriers for catalysts and sensors, precursors of nanostructured carbon materials, carriers for biomolecular immobilization and cellular scaffolds, as materials with a low dielectric constant, filtering/separating membranes, proton exchange membranes, templates for replicating structures, and as electrode materials for energy storage. Sol-gel technologies, track etching, and template synthesis are used for their production, including in micelles of surfactants and microemulsions and sublimation drying. The listed methods make it possible to obtain pores with variable shapes and sizes of 5-50 nm and achieve a narrow pore size distribution.
View Article and Find Full Text PDFACS Omega
December 2024
Key Laboratory of Enhanced Oil Recovery, Northeast Petroleum University, Daqing, Heilongjiang 163000, China.
After many years of mining in the Fang2 block of the Songfangtun oilfield, the conventional water drive development method can no longer meet the requirement of greatly improving the recovery rate, and ternary composite drive (TCD) technology is adopted for this purpose. TCD is one of the most important methods to further improve crude oil recovery, and it has entered the industrialization and promotion stage, but there are still problems of fouling in the injection and extraction system and high production and maintenance costs. In order to reduce formation damage and improve recovery in the Songfangtun oilfield, an alkali-free microemulsion system was developed by replacing the weak base sodium carbonate with sodium chloride, but its emulsification capacity was weak and the recovery enhancement value was lower than that of the weak base TCD.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!