The effects of solution (sol) processed contacts of indium tin oxide (ITO-sol) and gold (Au-sol) on solar cells are tested. When combined with solution processed active layers of CdTe/CdSe, all-inorganic fully solution processed solar cells are produced on non-conductive glass substrates. Under AM 1.5G illumination, open circuit voltages (Voc), short circuit currents (Jsc) and efficiencies (η) of solar cells processed with evaporated Au and commercial ITO were found to be (Voc = 0.56 ± 0.04 V, Jsc = 17.2 ± 2.2 mA cm(-2), η = 3.8 ± 0.4%), with Au-sol replacement (Voc = 0.54 ± 0.03 V, Jsc = 12.6 ± 1.0 mA cm(-2), η = 2.0 ± 0.1%), with ITO-sol (Voc = 0.38 ± 0.04 V, Jsc = 12.3 ± 0.8 mA cm(-2), η = 1.3 ± 0.2%), and with each layer solution processed (Voc = 0.49 ± 0.01 V, Jsc = 10.0 ± 1.5 mA cm(-2), η = 1.5 ± 0.2%) with the champion fully-solution processed all-inorganic device showing η = 1.7%. Layers and devices were characterized with UV/Vis spectroscopy, optical profilometry, XRD, XPS and SEM. The results indicate that the reduced performance of the all-solution devices results primarily from increased roughness of the Au film and decreased conductivity of the ITO layer.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1039/c4cp02403f | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Genomic analysis and potential polyhydroxybutyrate (PHB) production from Bacillus strains isolated from extreme environments in Mexico.
BMC Microbiol
January 2025
Unidad de Manipulación Genética, Facultad de Ciencias Biológicas, Departamento de Microbiología e Inmunología, Universidad Autónoma de Nuevo León, Monterrey, Nuevo León, México.
Background: Plastic pollution is a significant environmental problem caused by its high resistance to degradation. One potential solution is polyhydroxybutyrate (PHB), a microbial biodegradable polymer. Mexico has great uncovered microbial diversity with high potential for biotechnological applications.
View Article and Find Full Text PDFMitigating anthropogenic climate change with aqueous green energy.
Sci Rep
January 2025
School of Earth and Ocean Sciences, University of Victoria, PO Box 1700, Victoria, BC, V8W 2Y2, Canada.
Reaching net zero emissions and limiting global warming to 2 °C requires the widespread introduction of technology-based solutions to draw down existing atmospheric levels and future emissions of CO. One such approach is direct air CO capture and storage (DACCS), a readily available, yet energy-intensive process. The combination of DACCS and ocean thermal energy conversion (OTEC) allows for independently powered carbon capture plants to inject concentrated carbon into deep marine sediments where storage is generally safe and permanent.
View Article and Find Full Text PDFSurrogate-assisted global and distributed local collaborative optimization algorithm for expensive constrained optimization problems.
Sci Rep
January 2025
Jiangxi Tellhow Power Technology Co., Ltd, Nanchang, 330031, China.
This paper presents a surrogate-assisted global and distributed local collaborative optimization (SGDLCO) algorithm for expensive constrained optimization problems where two surrogate optimization phases are executed collaboratively at each generation. As the complexity of optimization problems and the cost of solutions increase in practical applications, how to efficiently solve expensive constrained optimization problems with limited computational resources has become an important area of research. Traditional optimization algorithms often struggle to balance the efficiency of global and local searches, especially when dealing with high-dimensional and complex constraint conditions.
View Article and Find Full Text PDFRolling schedule design for the ESP rolling process based on NSGA-II-DE.
ISA Trans
January 2025
State Key Laboratory of Rolling and Automation, Northeastern University, Shenyang, Liaoning 110819, China; Engineering Research Center of Frontier Technologies for Low-carbon Steelmaking, Ministry of Education, Shenyang 110819, China. Electronic address:
Multiple processes connected closely during the endless strip production (ESP) rolling, it is difficult to obtain the global optimal solution by multi-objective modelling of a single process, and the parameters to be optimized coupled with each other. To obtain the optimal solution, a multi-objective optimization model combining the power consumption, product quality, and loading balance was proposed for the design of an ESP rolling schedule. The thickness and heating temperature were simultaneously taken as the decision variables for coupling the temperature and loading in the rolling process, and the non-dominated sorting genetic algorithm-II (NSGA-II) based on differential evolution (NSGA-II-DE) was applied to obtain the Pareto solutions.
View Article and Find Full Text PDFBackground: Simulation offers an opportunity to practice neonatal resuscitation and test clinical systems to improve safety. The authors used simulation-based clinical systems testing (SbCST) with a Healthcare Failure Mode and Effect Analysis (HFMEA) rubric to categorize and quantify latent safety threats (LSTs) during in situ training in eight rural delivery hospitals. The research team hypothesized that most LSTs would be common across hospitals.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!