This study aims at comparing the steam gasification behaviour of two species of algal biomass (Chlamydomonas reinhardtii and Arthrospira platensis) and three species of lignocellulosic biomass (miscanthus, beech and wheat straw). Isothermal experiments were carried out in a thermobalance under chemical regime. Samples had very different contents in inorganic elements, which resulted in different reactivities, with about a factor of 5 between samples. For biomasses with ratio between potassium content and phosphorus and silicon content K/(Si+P) higher than one, the reaction rate was constant during most of the reaction and then slightly increased at high conversion. On the contrary, for biomasses with ratio K/(Si+P) lower than one, the reaction rate decreased along conversion. A simple kinetic model was proposed to predict these behaviours.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1016/j.biortech.2014.04.111 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Energy and climate policy implications on the deployment of low-carbon ammonia technologies.
Nat Commun
January 2025
Department of Chemical Engineering, Worcester Polytechnic Institute, Worcester, MA, USA.
The economic feasibility of low-carbon ammonia production pathways, such as steam methane reforming with carbon capture and storage, biomass gasification, and electrolysis, is assessed under various policy frameworks, including subsidies, carbon pricing, and renewable hydrogen regulations. Here, we show that employing a stochastic techno-economic analysis at the plant level and a net present value approach under the US Inflation Reduction Act reveals that carbon capture and biomass pathways demonstrate strong economic potential due to cost-effectiveness and minimal public support needs. Conversely, the electrolytic pathway faces significant economic challenges due to higher costs and lower efficiency.
View Article and Find Full Text PDFCo-gasification of blast furnace dust with petcoke for sustainable waste management.
Waste Manag
December 2024
Department of Mineral Processing, CSIR-IMMT, Bhubaneswar, Odisha 751013, India. Electronic address:
This study employed a lab-scale fluidized bed steam gasification setup to perform the co-gasification experiments with blast furnace dust (BFD) and petcoke (PC) - wastes from the steel and refining industries, respectively. Multiple experiments were conducted at the optimized conditions to decipher the effects of the mineralogical content of the feed samples on the gasification performance parameters. With the addition of iron and zinc-abundant BFD sample to PC, an effective enhancement in the ability of the gasifier to produce hydrogen-rich synthesis gas was observed, attributed to an increase in surface active sites for gasification reactivity.
View Article and Find Full Text PDFOptimization of Green Extraction Techniques for Polyphenolics in Bark Extract and Steam Gasification of the Remaining Fraction to Obtain Hydrogen-Rich Syngas and Activated Carbon.
ACS Omega
December 2024
Ege University Solar Energy Institute, 35040 Bornova, Izmir, Turkey.
Utilization of renewable resources has become imperative, and considerable efforts have been devoted to tackling diverse global sustainability challenges, which contribute to the circular economy. The focus of this work was to optimize the extraction of polyphenolic compounds in bark using microwave-assisted (MAE) and ultrasonically assisted (UAE) extractions and evaluate the biological efficacies of the extracts. Additionally, the residue of the extracted pine bark was subjected to steam gasification to produce hydrogen-rich syngas and activated carbon.
View Article and Find Full Text PDFExperimental Study of Sawdust Syngas Gasification in Bench-Scale Gasifier and Three-Dimensional Numerical Analysis for Syngas Cocombustion in a 600 MW Coal-Fired Boiler Furnace.
ACS Omega
December 2024
Guangdong Provincial Key Laboratory of Distributed Energy System, Dongguan University of Technology, Dongguan 523820, China.
To comprehensively explore syngas cocombustion technology, gasification experiments in a bench-scale circulating fluidized bed (CFB) and three-dimensional (3D) numerical simulations of a coal-fired boiler furnace have been conducted. In the amplification experiment of biomass gasification, sawdust has been gasified using air, oxygen-enriched air, and steam. The highest heating value of the syngas products reaches 12.
View Article and Find Full Text PDFCombustion versus Gasification in Power- and Biomass-to-X Processes: An Exergetic Analysis.
ACS Omega
December 2024
Department of Chemical Engineering, KU Leuven, 3001 Leuven, Belgium.
Residual biomass is a promising carbon feedstock for the production of electricity-based organic chemicals and fuels since, unlike carbon dioxide captured from point sources or air, it also has a valuable energy input. Biomass can be converted into an intermediate stream suitable for Power-to-X processes mainly via combustion or gasification. Such combined processes are generally called biohybrid or Power- and Biomass-to-X processes.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!