Novel macroporous palladium cation crosslinked chitosan membranes for heterogeneous catalysis application.

Int J Biol Macromol

Zhejiang Key Laboratory of Alternative Technologies for Fine Chemicals Process, Shaoxing University, Shaoxing 312000, China. Electronic address:

Published: July 2014

A novel palladium supported on chitosan porous membrane heterogeneous catalyst has been prepared by freeze-drying of Pd(2+)-crosslinked chitosan gel solution. The prepared membrane catalyst has three-dimensional porous structure (porosity: >70%). The crosslinking effects of Pd(2+) to chitosan were good for the improvement of the mechanical properties and thermal stabilities. Pd(2+) cations have been shown not only as the crosslinker, but also as the catalytic active sites. The reductive palladium species of the recycled membrane catalysts was found in the nanometer scale (20-40nm). Excellent cross-coupling yields were achieved using as low as 0.12mol% palladium catalyst loading for the Heck-type reaction of aromatic halides with acrylates. The catalyst could be recycled six times without obvious decreased conversion.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.ijbiomac.2014.04.035DOI Listing

Publication Analysis

Top Keywords

novel macroporous
4
palladium
4
macroporous palladium
4
palladium cation
4
cation crosslinked
4
chitosan
4
crosslinked chitosan
4
chitosan membranes
4
membranes heterogeneous
4
heterogeneous catalysis
4

Similar Publications

A mechanically robust chitosan-based macroporous foam for sustainable Se(IV) elimination from wastewater.

Carbohydr Polym

March 2025

College of Chemistry and Chemical Engineering, Qingdao University, Qingdao 266071, China; College of Chemical Engineering and Technology, Yantai Nanshan University, Yantai 265713, China. Electronic address:

The contamination of water resources by selenium (Se), particularly in the highly toxic Se(IV) oxidation state, poses a significant environmental and public health concern due to its detrimental impacts on humans and aquatic ecosystems. In this work, we report a novel composite foam (CFC) by incorporating chitosan (CS), cellulose nanofibers (CNF) and iron oxyhydroxide (FeOOH) nanoparticles through a one-pot fabrication process. The CFC foam features a three-dimensional porous structure, conferring both exceptional mechanical strength and superior adsorption performance for Se(IV), with a maximum equilibrium adsorption capacity of 90 mg/g achieved within 3 h.

View Article and Find Full Text PDF

Mass transfer governs the overall catalytic performance of heterogeneous catalysts considerably; however, this fundamental research has often been ignored. Here, macroporous SiO-supported Pt nanoparticle (Pt/SiO-M) and mesoporous SiO-supported Pt nanoparticle (Pt/SiO-m) catalysts were specifically fabricated by a facile thermal reduction step to engineer the resultant Pt nanoparticles showing similar physiochemical properties while possessing completely different porous microstructures exclusively originating from SiO supports. On this basis, a platform to explore the crucial mass transfer difference affecting catalytic activity is then established by systematically practicing industry-important benzene oxidation measurements.

View Article and Find Full Text PDF

Establishment of Gas-Liquid-Solid Interface on Multilevel Porous CuO for Potential-Driven Selective CO Electroreduction toward C or C Products.

ACS Appl Mater Interfaces

January 2025

College of Chemistry and Materials Science, The Key Laboratory of Functional Molecular Solids, Ministry of Education, The Key Laboratory of Electrochemical Clean Energy of Anhui Higher Education Institutes, Anhui Provincial Engineering Laboratory for New-Energy Vehicle Battery Energy-Storage Materials, Anhui Normal University, Jiuhua Road 189, Wuhu 241002, China.

Copper-based catalysts demonstrate distinctive multicarbon product activity in the CO electroreduction reaction (CORR); however, their low selectivity presents significant challenges for practical applications. Herein, we have developed a multilevel porous spherical CuO structure, wherein the mesopores are enriched with catalytic active sites and effectively stabilize Cu, while the macropores facilitate the formation of a "gas-liquid-solid" three-phase interface, thereby creating a microenvironment with an increasing water concentration gradient from the interior to the exterior. Potential-driven phase engineering and protonation synergistically optimize the reaction pathway, facilitating a switch between CO and CH.

View Article and Find Full Text PDF

Carving Metal-Organic-Framework Glass Based Solid-State Electrolyte Via a Top-Down Strategy for Lithium-Metal Battery.

Angew Chem Int Ed Engl

January 2025

KU Leuven, Materials engineering, Kasteelpark Arenberg 44 bus 2450, 3001 LEUVEN Belgium, LEUVEN, BELGIUM.

Traditional polymer solid electrolytes (PSEs) suffer from low Li conductivity, poor kinetics and safety concerns. Here, we present a novel porous MOF glass gelled polymer electrolyte (PMG-GPE) prepared via a top-down strategy, which features a unique three-dimensional interconnected graded-aperture structure for efficient ion transport. Comprehensive analyses, including time-of-flight secondary ion mass spectrometry (TOF-SIMS), Solid-state 7Li magic-angle-spinning nuclear magnetic resonance (MAS-NMR), Molecular Dynamics (MD) simulations, and electrochemical tests, quantify the pore structures, revealing their relationship with ion conductivity that increases and then decreases as macropore proportion rises.

View Article and Find Full Text PDF

Assembly-foaming synthesis of hierarchically porous nitrogen-doped carbon supported single-atom iron catalysts for efficient oxygen reduction.

J Colloid Interface Sci

January 2025

Particle Engineering Laboratory (China Petroleum and Chemical Industry Federation), School of Chemical and Environmental Engineering, College of Chemistry, Chemical Engineering and Materials Science, Soochow University, Suzhou 215123 Jiangsu, PR China. Electronic address:

High-performance electrocatalysts are highly concerned in oxygen reduction reaction (ORR) related energy applications. However, facile synthesis of hierarchically porous structures with highly exposed active sites and improved mass transfer is challenging. Herein, we develop a novel assembly-foaming strategy for synthesizing hierarchically porous nitrogen-doped carbon supported single-atom iron catalysts.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!