V2O5-coated ZnO 1D nanostructures were prepared by using a two step process: thermal evaporation of a mixture of ZnO and graphite powders (ZnO:C = 1:1) in an oxidative atmosphere and sputter-deposition of V2O5. Scanning electron microscopy revealed that the nanostructures had a rod-like morphology with the thickness diminishing gradually from an end to the other. The thicknesses and lengths of the nanorods range from a few tens to a few hundreds of nanometers and from a few to a few tens of micrometers, respectively. Transmission electron microscopy and X-ray diffraction analyses revealed that the ZnO cores and V2O5 shells of the core-shell nanorods were wurtzite-type hexagonal close-packed structured single crystal and amorphous, respectively. The intensity ratio of the near-band edge (NBE) emission to the deep-level emission was increased about three times by coating the ZnO nanorods with a V2o5 thin film about 10 nm thick. The NBE emission enhancement may be mainly attributed to two sources: the effects of suppression of capturing of carriers by surface states and suppression of visible emission and nonradiative recombination by depletion regions formed in the ZnO cores. In addition, it was found that postannealing of V2O5-coated ZnO nanorods is not desirable, whereas post annealing makes a positive effect on the NBE emission enhancement in uncoated ZnO nanorods.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1166/jnn.2014.8415 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Synthesis and performance evaluation of ZnO/CdS photoanodes with copper sulfide (CuS) and carbon counter electrodes.
Sci Rep
December 2024
Advanced Physics Laboratory, Department of Physics, Savitribai Phule Pune University, Pune, Maharashtra, 411007, India.
The present study demonstrates the synthesis of compact ZnO layers using CdS sensitized on ZnO as a photoanode with copper sulfide (CuS) and carbon as a counter electrode (CE). In this study, a compact ZnO layer was fabricated using the simple and low-cost successive ionic layer adsorption and reaction (SILAR) method, and CuS CE films were synthesized using the chemical bath deposition method. Various characterizations, such as X-ray diffraction (XRD) and X-ray photoelectron spectroscopy (XPS), confirmed the formation of ZnO and CdS sensitizations on the ZnO .
View Article and Find Full Text PDFEnhanced degradation of Ciprofloxacin (CIP) antibiotic and methylene blue (MB) dye using ZnO/GO nanocomposites under solar irradiation.
Sci Rep
December 2024
Department of Physics, Faculty of Science, Islamic University of Madinah, Madinah 42351, Saudi Arabia.
Modifying ZnO nanorods with graphene oxide (GO) is crucial for enhancing photocatalytic degradation by boosting the concentration of reactive oxygen species (ROS) in the reaction medium. In this study, we present a straightforward chemical synthesis of ZnO nanorods embedded on GO, forming a novel nanocomposite, GOZ. This composite serves as an efficient photocatalyst for the sunlight-driven degradation of methylene blue (MB) and ciprofloxacin (CIP).
View Article and Find Full Text PDFRole of en-APTAS Membranes in Enhancing the NO Gas-Sensing Characteristics of Carbon Nanotube/ZnO-Based Memristor Gas Sensors.
Biosensors (Basel)
December 2024
Department of Semiconductor Systems Engineering, Convergence Engineering for Intelligent Drone, Institute of Semiconductor and System IC, Sejong University, 209, Neungdong-ro, Gwangjin-gu, Seoul 05006, Republic of Korea.
NO is a toxic gas that can damage the lungs with prolonged exposure and contribute to health conditions, such as asthma in children. Detecting NO is therefore crucial for maintaining a healthy environment. Carbon nanotubes (CNTs) are promising materials for NO gas sensors due to their excellent electronic properties and high adsorption energy for NO molecules.
View Article and Find Full Text PDFSynergistic Effects of ZnO@NiM'-Layered Double Hydroxide (M' = Mn, Co, and Fe) Composites on Supercapacitor Performance: A Comparative Evaluation.
ACS Nanosci Au
December 2024
Department of Physics, Malaviya National Institute of Technology Jaipur, Jaipur 302017, Rajasthan, India.
The development of supercapacitors is pivotal for sustainable energy storage solutions, necessitating the advancement of innovative electrode materials to supplant fossil-fuel-based energy sources. Zinc oxide (ZnO) is widely studied for use in supercapacitor electrodes because of its beneficial physicochemical properties, including excellent chemical and thermal stability, semiconducting characteristics, low cost, and environmentally friendly nature. In this study, ZnO nanorods were synthesized using a simple hydrothermal method and then combined with various Ni-based layered double hydroxides (LDHs) [NiM'-LDHs (M' = Mn, Co, and Fe)] to improve the electrochemical performance of the ZnO nanorods.
View Article and Find Full Text PDFPt-Decorated ZnO Nanorods for Light-Assisted Ethanol Sensing and Analysis of the Sensing Mechanism under Light Irradiation.
ACS Appl Mater Interfaces
December 2024
Faculty of Advanced Science and Technology, Kumamoto University, Kumamoto 860-8555, Japan.
ZnO nanorods have attracted much attention owing to their outstanding properties for chemical gas sensors. Although they show greater sensing properties than conventional nanoparticulate ZnO, high operation temperature (>250-350 °C) is required for them to work even if precious metals are deposited on them to sensitize their sensing properties. Light irradiation is one solution for overcoming the high operation temperature and the gas selectivity because it assists the oxidation activity on the surface that affects the sensor response.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!