This paper summarizes the conclusions of experiments conducted on the adsorption of Cd(2+), Co(2+), Cu(2+), Mn(2+), Ni(2+), Pb(2+) and Zn(2+) onto zeolite. The focus of the experiments was to establish the influence of the initial pH of the contact solution as well as the selectivity of zeolite on the efficiency of the adsorption process. To this end, experimental adsorption isotherms were established for the pH values ranging from 1 to 4 by using the Na-form of clinoptilolite (particle size range 0.5-1 mm) as an adsorbent. Langmuir, Freundlich and Dubinin-Raduschkevich isotherm models were used to validate the experimental data and the Gibbs free energy was calculated based on the distribution coefficient. From the Langmuir model, correlations between the maximum adsorption capacity and selected physical-chemical parameters of the cations studied were established. The results of the experiments suggest that the selectivity of zeolite is strongly influenced by the pH of the contact solution, dehydration energy of cations, diffusion coefficient and the pH at which the precipitation of hydroxides occurs.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.jenvman.2014.02.007DOI Listing

Publication Analysis

Top Keywords

contact solution
8
selectivity zeolite
8
adsorption
5
adsorption heavy
4
heavy metal
4
metal cations
4
cations na-clinoptilolite
4
na-clinoptilolite equilibrium
4
equilibrium selectivity
4
selectivity studies
4

Similar Publications

In this research, activated carbon from banana peel (BPAC) was prepared by calcination (600 °C) method. Nano composites MO@BPAC (MO=NiO, CuO and ZnO) were prepared and then were characterized by XRD, FTIR, FESM, EDX, BETand TGA methods. Formation of MO@BPAC nanocomposites was confirmed by analysis methods.

View Article and Find Full Text PDF

Mild steel provides strength to various building and industrial materials but it is badly affected by corrosion. In the present study, we investigate the efficacy of , a plant-based green corrosion inhibitor to minimize mild steel corrosion in a 1 M HSO solution. Weight loss, surface coverage, inhibition efficiency, and corrosion rate measurements were evaluated for various inhibitor concentrations and time intervals.

View Article and Find Full Text PDF

The discharge of oil-laden wastewater from industrial processes and the frequent occurrence of oil spills pose severe threats to the ecological environment and human health. Membrane materials with special wettability have garnered attention for their ability to achieve efficient oil-water separation by leveraging the differences in wettability at the oil-water interface. These materials are characterized by their simplicity, energy efficiency, environmental friendliness, and reusability.

View Article and Find Full Text PDF

Exploring participant satisfaction with an eHealth intervention for low back pain and knee osteoarthritis: Enhancing physiotherapy access in rural Australia.

Musculoskelet Sci Pract

January 2025

School of Rural Health, Orange Campus, Faculty of Medicine and Health, University of Sydney, Orange, New South Wales, Australia; Sydney Musculoskeletal Health, Charles Perkins Centre, School of Health Sciences, Faculty of Medicine and Health, University of Sydney, Sydney, Australia. Electronic address:

Introduction: Accessing health services in rural Australia is challenging and innovative solutions to meet residents' needs are required. Research into eHealth is crucial as it offers potential solutions to these challenges. The study aimed to assess participants' satisfaction and experience with an eHealth physiotherapy intervention at improving physical function for low back pain and knee osteoarthritis in rural Australia.

View Article and Find Full Text PDF

A photocatalytic superhydrophobic coating with p-n type BiOBr/α-FeO heterojunctions applied in NO degradation.

RSC Adv

January 2025

Institute of Resources and Environmental Engineering, Shanxi University, Shanxi Yellow River Laboratory Taiyuan China

Coal combustion generates soot-type air pollution, and NO, as a typical pollutant, is the main haze-causing pollutant. The degradation of NO by means of photocatalytic superhydrophobic multifunctional coatings is both durable and economical. The precipitation method was employed to create a p-n type BiOBr/α-FeO photocatalytic binary system.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!