The adsorption and desorption properties of D001 resin for Cd(II) has been investigated. Batch studies were carried out with various pH, contact time, temperature and initial concentrations, and then column studies were conducted. The results showed that the optimal adsorption condition was at pH value of 3.0 in HAc-NaAc medium. The resin exhibited a high Cd(II) uptake of 185.8 mg/g at 298 K. The apparent activation energy Ea is 5.05 kJ/mol and the sorption thermodynamic parameters are ΔH = 21.1 kJ/mol, ΔS = 0.122 kJ/(mol K) and ΔG298K = -15.3 kJ/mol, which indicated that the adsorption process was spontaneous and endothermic. Compared with the Freundlich isotherm, the sorption of Cd(II) obeys the Langmuir isotherm better. The Thomas model was delineated here to predict the breakthrough curves based on the experimental column study data. Furthermore, the resin could be regenerated through the desorption of the Cd(II) anions using 1 mol/L HCl solution and could be reused to adsorb again. The infrared spectroscopic technique was undertaken. Compared with other absorbents, D001 resin was relatively low cost and was effective in removing Cd(II) ions.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.2166/wst.2013.756 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Adsorption Mechanisms of CO on Macroporous Ion-Exchange Resin Organic Amine Composite Materials by the Density Functional Theory.
ACS Omega
April 2024
State Key Laboratory Base of Eco-Chemical Engineering in College of Chemical Engineering, Qingdao University of Science and Technology, Qingdao 266042, China.
The adsorption mechanisms of CO on macroporous cation exchange resin (MCER), D001 ion-exchange resin, and macroporous ion-exchange resin organic amine composite materials (MCER-DEA and D001-PEI) were studied by density functional theory (DFT). The adsorption energies and Mulliken atomic charges in the adsorption process were analyzed, indicating that CO on MCER and D001 were physisorbed. The adsorption heat of the adsorption process of MCER-DEA and D001-PEI was calculated by the Monte Carlo method, and it was found that the adsorption process of CO by MCER-DEA and D001-PEI was both physical adsorption and chemical adsorption.
View Article and Find Full Text PDFDesigning N-doped graphene-like supported highly dispersed bimetallic NiCoP NPs as an efficient electrocatalyst for water oxidation.
Dalton Trans
September 2023
Information Materials and Intelligent Sensing Laboratory of Anhui Province, Institutes of Physical Science and Information Technology, Anhui University, Hefei 230601, PR China.
Electrocatalysts with a high oxygen evolution reaction (OER) activity are very important for electrochemical water oxidation, but they are also challenging. In this study, N-doped graphene-like supported highly dispersed bimetallic NiCoP NPs as an efficient electrocatalyst for water oxidation were prepared by using cation exchange resin as a carbon source and by loading cobalt and nickel on D001 by a high-temperature calcination method. The designed electrocatalyst with bimetallic phosphide as the active center shows excellent OER catalytic performance, with an overpotential of 324 mV at 10 mA cm and a corresponding Tafel slope of 97.
View Article and Find Full Text PDFOptimization of phosphate oxygen isotope pretreatment measurement method based on phosphate in situ enrichment blanket.
Water Sci Technol
August 2023
School of Energy and Environmental Engineering, Hebei University of Engineering, Handan, Hebei 056038, China; Hebei Water Pollution Control and Water Ecological Restoration Technology Innovation Center, Handan, Hebei 056038, China.
Phosphate oxygen isotope analysis is an effective tool for investigating phosphorus migration and transformation in water bodies. Unfortunately, current pretreatment methods for this technology are significantly limited due to their demanding sample amount requirements, complex operation, and limited scope of application. In order to enhance the efficiency of the pretreatment process, hydrated zirconia was synthesized through liquid-phase precipitation.
View Article and Find Full Text PDFEfficient Activation of Peroxymonosulfate by Cobalt Supported Used Resin Based Carbon Ball Catalyst for the Degradation of Ibuprofen.
Materials (Basel)
July 2022
School of Environmental Science and Engineering, Nanjing Tech University, Nanjing 211816, China.
The extensive use of ibuprofen (IBU) and other pharmaceuticals and personal care products (PPCPs) causes them widely to exist in nature and be frequently detected in water bodies. Advanced catalytic oxidation processes (AOPs) are often used as an efficient way to degrade them, and the research on heterogeneous catalysts has become a hot spot in the field of AOPs. Among transitional metal-based catalysts, metal cobalt has been proved to be an effective element in activating peroxymonosulfate (PMS) to produce strong oxidizing components.
View Article and Find Full Text PDFA facile modification of cation exchange resin by nano-sized goethite for enhanced Cr(VI) removal from water.
Environ Technol
May 2022
School of Environment and Energy, South China University of Technology, Guangzhou, People's Republic of China.
A novel macroporous strong acidic cation exchange resin (D001) modified by nano-sized goethite (nFeOOH@D001) was fabricated by using a facile ethanol dispersion and impregnation method, and its efficiency for Cr(VI) removal was tested thereafter. Due to the dispersing effect of ethanol, FeOOH particles of 20-150 nm were coated on the D001 surfaces. The nFeOOH@D001 obtained a Cr(VI) removal efficiency and capacity of 80.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!