Low-Noise Operation of All-Fiber Femtosecond Cherenkov Laser.

IEEE Photonics Technol Lett

DTU Fotonik, Technical University of Denmark, Lyngby DK-2800, Denmark, and also with the Max Planck Institute for Polymer Research, Mainz 55128, Germany.

Published: March 2013

We investigate the noise properties of a femtosecond all-fiber Cherenkov radiation source with emission wavelength 600 nm, based on an Yb-fiber laser and a highly nonlinear photonic crystal fiber. A relative intensity noise as low as 103 dBc/Hz, corresponding to 2.48% pulse-to-pulse fluctuation in energy, is observed at the Cherenkov radiation output power of 4.3 mW, or 150 pJ-pulse energy. This pulse-to-pulse fluctuation is at least 10.6-dB lower compared to spectrally sliced supercontinuum sources traditionally used for ultrafast fiber-based generation at visible wavelengths. Low noise makes all-fiber Cherenkov sources promising for biophotonics applications such as multiphoton microscopy, where minimum pulse-to-pulse energy fluctuation is required. We present the dependency of the noise figure on both the Cherenkov radiation output power and its spectrum.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC3922043PMC
http://dx.doi.org/10.1109/LPT.2013.2253765DOI Listing

Publication Analysis

Top Keywords

cherenkov radiation
12
all-fiber cherenkov
8
pulse-to-pulse fluctuation
8
radiation output
8
output power
8
cherenkov
5
low-noise operation
4
operation all-fiber
4
all-fiber femtosecond
4
femtosecond cherenkov
4

Similar Publications

We demonstrate experimentally an efficient terahertz emitter that consists of a 20 µm thick layer of LiNbO clamped between a fused silica substrate and a Si semicone. A focused laser beam from an ultrafast optical oscillator propagates in the LiNbO layer and emits a Cherenkov cone of terahertz radiation to the Si semicone. The radiation is totally internally reflected by the semicone's convex surface and escapes the semicone through its base as a collimated beam.

View Article and Find Full Text PDF

Novel high-stopping power scintillators for medical applications.

Proc SPIE Int Soc Opt Eng

February 2024

Radiation Monitoring Devices, Inc., 44 Hunt St., Watertown, MA, USA 02472- 4624.

Development of new scintillator materials is a continuous effort, which recently has been focused on materials with higher stopping power. Higher stopping power can be achieved if the compositions include elements such as Tl (Z=81) or Lu (Z=71), as the compounds gain higher densities and effective atomic numbers. In context of medical imaging this translates into high detection efficiency (count rates), therefore, better image quality (statistics, thinner films) or lower irradiation doses to patients in addition to lowering of cost.

View Article and Find Full Text PDF

Cherenkov radiation is emitted during x-ray irradiation in a linear accelerator (LINAC). Cherenkov light contains many short wavelength components, including ultraviolet (UV) light, which is well-known for its bactericidal effects. A similar phenomenon is probable for human cancer cells.

View Article and Find Full Text PDF

Vortex free-electron radiation has attracted considerable interest because of its promising potential for applications in communication, high-density radiation sources, and particle detection. Here, we reveal angular momentum modulation of vortex Cherenkov radiation using subwavelength silicon waveguides. The topological charge of vortex radiation field can be controlled by the position parameters of two electron beams based on the rotational symmetry.

View Article and Find Full Text PDF

Optimized scintillation imaging in low dose rate and bright room light conditions.

Biomed Phys Eng Express

November 2024

Department of Medical Physics, School of Medicine and Public Health, University of Wisconsin-Madison, WI, United States of America.

. To develop a robust method for non-contact surface dosimetry during Total Body Irradiation (TBI) that uses an optimally paired choice of scintillator material with camera photocathode and can work insensitively to the normal ambient room lighting conditions (∼500 Lux)..

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!