Background: To investigate the feasibility of contouring the planning risk organ volume (PRV) for the heart, and to determine the probability of evaluating radiation dose to the heart using kilovoltage-cone beam computed tomography (kV-CBCT) in early-stage non-small-cell lung cancer (NSCLC) patients, who received stereotactic body radiotherapy (SBRT).
Materials And Methods: Seventeen NSCLC patients who received SBRT (5Gy/f × 10f dose) were enrolled and subjected to CBCT and CT imaging analyses to plan treatment. Sequential planning CBCT images of individual patient's hearts were analyzed for reproducibility of heart contouring and volume. Comparative analyses were made between the planning CT- and CBCT-detected heart margins and dose-volume indices for treatment.
Results: The heart volume from planning CT images was significantly smaller than that from CBCT scans (p < 0.05), and the volumes based on the different series of CBCT images were similar (p > 0.05).The overlap of the heart region on the same anatomical section between the first series of CBCT scans and other scans reached 0.985 ± 0.020 without statistically significant differences (p > 0.05). The mean margins of the heart from planning CT and CBCT scans were 10.5 ± 2.8 mm in the left direction, 5.9 ± 2.8 mm in the right direction, 2.2 ± 1.6 mm in the direction of the head, 3.3 ± 2.2 mm in the direction of the foot, 6.7 ± 1.1 mm in the anterior direction, and 4.5 mm ± 2.5 mm in the posterior direction. All relative and absolute dose-volume indices obtained from CBCT images were significantly larger than those from planning CT scans (p < 0.05), with the exception of the volume in the 5Gy region.
Conclusion: The PRV of heart contouring based on kV-CBCT is feasible with good reproducibility. More accurate and objective dose-volume indices may be obtained for NSCLC patients by using kV-CBCT, instead of CT, to plan SBRT.
Download full-text PDF |
Source |
|---|---|
| http://www.ncbi.nlm.nih.gov/pmc/articles/PMC3909334 | PMC |
| http://dx.doi.org/10.1186/1748-717X-8-295 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Utility of 3D facial reconstruction for forensic identification: a focus on facial soft tissue thickness and customized techniques.
Forensic Sci Med Pathol
January 2025
Department of Anatomy, Faculty of Medicine, Chiang Mai University, Chiang Mai, 50200, Thailand.
Facial reconstruction, a crucial method in forensic identification, finds particular significance in cases where conventional means of identification are unavailable. This study addresses a significant gap in the field of forensic facial reconstruction focusing on facial soft tissue thickness (FSTT) and facial reconstruction techniques specifically tailored to the Thai population. By developing and implementing the 3D (three-dimensional) facial reconstruction program and compiling an extensive dataset of FSTT, this research makes substantial progress in advancing forensic facial reconstruction methodologies employing the combination Manchester Method, 3D skull images obtained through cone beam computed tomography (CBCT) scans were reconstructed using Autodesk Maya software.
View Article and Find Full Text PDFAssessment of the Quality of Root Canal Fillings-An Ex-Vivo Comparison of CBCT Scans, Conventional Intraoral Sensors, and a Novel Photon-Counting Sensor.
Dentomaxillofac Radiol
January 2025
Associate Professor, Division of Oral Diagnostic Sciences, School of Dentistry, Oregon Health & Science University, Portland, OR, USA.
Objectives: To compare a novel photon-counting sensor, two CBCT protocols and two CMOS sensors on the detection of gaps between a gutta-percha cone and root canal walls.
Methods: Twenty-five mandibular incisors were prepared to 45/.04 (size/taper) at working length.
Targeted Endodontic Access Preparation: Comparing Grid-Guided and Freehand CBCT Techniques.
J Endod
January 2025
Department of Endodontics, Texas A&M College of Dentistry, 3302 Gaston Ave, Dallas, TX 75246. Electronic address:
Introduction: Endodontic access is often one of the most challenging aspects of treatment, particularly in cases involving locating calcified or missed canals, or when performing selective retreatments of a targeted root. Therefore, the purpose of this study is to compare the accuracy of targeted accesses made using prefabricated grid to those made using freehand techniques with CBCT measurements METHODS: Twenty extracted maxillary molars were mounted into the TrueJaw maxillary model (PlanB Dental, CA). To replicate a clinical scenario where the tooth is extensively restored or has a calcified pulp chamber, the build-up material was intentionally placed directly over the canal orifices.
View Article and Find Full Text PDFPurpose: The degenerative joint disease is a temporomandibular disorder. By analysing texture parameters, it becomes possible to characterize and differentiate various tissues, based on their textural properties according to cone-beam computed tomography (CBCT). This study evaluated degenerative diseases in the temporomandibular joint through texture analysis.
View Article and Find Full Text PDFUnilateral cleft lip and palate patients present cranial base modifications: a cross-sectional study.
Braz Oral Res
January 2025
Pontifícia Universidade Católica de Minas Gerais - PUC Minas, School of Dentistry, Graduate Program in Dentistry, Belo Horizonte, MG, Brazil.
The aim of this cross-sectional study was to perform a three-dimensional (3D) assessment of the cranial base of patients with unilateral cleft lip and palate (UCLP). Cone-beam computed tomography (CBCT) scans of 52 UCLP patients (21 females and 31 males; mean age, 10.0 ± 2.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!