Aim Of The Study: To evaluate the efficacy and cleaning ability of Hedstrom files, and ProTaper retreatment instruments in removing gutta-percha from root canals with and without xylene as solvent.
Materials And Methods: Sixty extracted single rooted human teeth were selected and decoronated, straight access established working length determined 1 mm short of canal, chemomechanical preparation done and obturated with guttapercha and AH plus sealer. Samples were stored for 1 week in humidifier divided into four groups of 15 teeth each. • Group I: Hedstrom files without xylene. • Group II: Hedstrom files with xylene. • Group III: ProTaper retreatment instruments without xylene. • Group IV: ProTaper retreatment instruments with xylene. and the following criteria were assessed - Time taken for initial plunge of instrument into guttapercha. - Time taken for complete removal of gutta-percha to reach working length - Ability of H files and ProTaper retreatment files with/ without xylene to remove gutta-percha in coronal, middle and apical 1/3 of canal. The teeth were grooved in labiolingual cross section, observed under a steromicroscope and scored according to gutta-percha debris left in the canal. Results were evaluated using ANOVA test and multiple comparisons done using Scheffe test.
Results: The least time to reach working length was found with group IV followed by groups III, II and group I respectively. Also the fastest way to remove maximum gutta-percha was group IV followed by groups III, II, and I respectively with a statistically significant difference among all groups. Apical 1/3 has more amount of remaining gutta-percha debris than middle and coronal 1/3 in all groups. The amount of gutta-percha debris in apical 1/3 was least in group IV followed by groups III, II and I respectively.
Discussion: The better performance of ProTaper rotary instruments has been attributed to their special flute design which tends to pull gutta-percha coronally directing it toward orifice. Also the movements of engine driven instruments produce frictional heat which plasticises gutta-percha and aids in easy removal. Apical third of root canals showed more guttapercha debris compared to coronal and middle 1/3 and has been attributed to the greater anatomic variability and difficulty of instrumentation in the apical area. The existence of deep groves and depressions on dentine walls in this apical 1/3 make them less instrumented areas as it did be difficult to direct the file against the extreme root canal wall.
Conclusion: The fastest technique to remove gutta-percha and the shortest time to reach working length was observed with ProTaper retreatment instruments with xylene followed by ProTaper retreatment files without xylene and Hedstrom files without xylene. After instrumentation for removal of gutta-percha, apical third was found to have more debris compared to coronal and middle 1/3 of the root canal.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.5005/jp-journals-10024-1377 | DOI Listing |
Medicina (Kaunas)
December 2024
Department of Endodontics, Faculty of Dentistry, Ankara University, Ankara 06560, Turkey.
: The access cavity design and instrumentation system could affect the remaining root canal obturation materials in root canal retreatment. This study aimed to evaluate the efficiency of two different multi-file systems in removing obturation materials with two different access cavities utilizing micro-CT scanning. : Conservative access cavity (CAC) preparation was performed for 80 mandibular premolars.
View Article and Find Full Text PDFDent Res J (Isfahan)
November 2024
Department of Endodontics, Faculty of Dentistry, Isfahan (Khorasgan) Branch, Islamic Azad University, Isfahan, Iran.
Background: Periapical extrusion of debris for root retreatment will effectively improve the posttreatment inflammation and pain. The aim of this study was to investigate the extruded debris for root retreatment using XP shaper and ProTaper files.
Materials And Methods: In his experimental laboratory study, 40 extracted human maxillary molars were used in this laboratory study.
Dent J (Basel)
November 2024
Department of General Surgery and Surgical-Medical Specialties, University of Catania, 95131 Catania, Italy.
: Apical extrusion of debris can affect the success of endodontic treatments, and the specific performance of certain retreatment systems has not been studied yet. Therefore, the aim of this in vitro study was to quantitatively assess the amount of apically extruded debris produced during retreatment procedures using three rotary NiTi retreatment systems in mature non-resorbed straight roots. : Thirty extracted permanent human teeth with single straight roots were selected.
View Article and Find Full Text PDFRestor Dent Endod
November 2024
Department of Endodontics, Faculty of Dentistry, Cairo University, Cairo, Egypt.
Objectives: This study evaluated the effect of ProTaper Next (PTN), ProTaper Universal Retreatment (PTR) and hybrid instrumentation (HI) for canal filling removal on the fracture resistance (FR), mode of failure (MoF), and filling removal time.
Materials And Methods: Ninety-six, mandibular premolars were decoronated and randomly divided into 6 groups ( = 16), as follows: sound (S), untreated canals; prepared teeth (P), canals only prepared to ProTaper Universal finishing instrument (F4); endodontically-treated (ET), prepared and obturated canals using the single-cone technique; and groups PTN, PTR, and HI where filling was removed using PTN, PTR, or HI respectively. FR under vertical loading; MoF and time were assessed.
J Dent
January 2025
Division of Endodontics, Department of Oral Biological and Medical Sciences, Faculty of Dentistry, University of British Columbia, Vancouver, Canada. Electronic address:
Objective: This study evaluated the efficacy of the ProTaper Universal Retreatment system (PTUR) and XP-endo Finisher R instrument (XPFR) in removing 64-month-old root filling material from minimally-instrumented mandibular molar canals.
Methods: Forty-eight root canals with Vertucci type II or IV configurations from 30 mandibular molars were instrumented to size 20/0.04 taper using Vortex Blue NiTi rotary instruments and irrigated with the GentleWave system.
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!