Background: Previous studies have shown that a calcium (Ca) pre-rinse given before a 228 ppm fluoride (F) rinse greatly increased salivary fluoride. Objectives. The aim of this randomized controlled trial is to examine if Ca pre-rinse could increase the fluoride concentration in the overnight unstimulated saliva after a 905 ppm F-rinse.
Materials And Methods: Pre-rinses containing 150 mM, 75 mM or 0 mM Ca-lactate prepared by a validated pharmaceutical cGPM procedure were tested by nine subjects in a randomized order immediately followed by a 905 ppm F-rinse. The fluoride concentration was measured in unstimulated saliva collected 10 h later.
Results And Conclusions: The Ca pre-treatment significantly increased F level in overnight saliva following the 905 ppm fluoride rinse by 1.7× relative to the 905 ppm F-rinse alone; however, a significant effect was only observed with the highest (150 mM) Ca concentration as pre-rinse. Clinical relevance. High concentration F rinses (905 ppm) are commonly recommended for patients at high-risk of caries. A pre-treatment with high levels of Ca may further improve the cariostatic effect of this ion.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.3109/00016357.2013.859729 | DOI Listing |
Carbohydr Polym
December 2024
Center for the Development of Advanced Materials and Nanotechnology, National University of Engineering, Av. Tupac Amaru 210, Lima, Peru.
This work proposes an evaluation of the Crystalline Index (CrI) in function of the bleaching process employed during cellulose extraction from corn husk, for further characterization using CP/MAS C NMR, XRD, and FT-IR. In that sense, CrI values were calculated by FT-IR and the bands associated with the crystalline and amorphous regions were observed at 1424 cm and 896 cm, respectively. Similarly, the signals due to ordered (89.
View Article and Find Full Text PDFJ Environ Sci (China)
March 2025
National Engineering Research Center of Urban Environmental Pollution Control, Beijing Municipal Research Institute of Eco-Environmental Protection, Beijing 100037, China. Electronic address:
To understand the smoke level and NO emission characteristics of in-use construction machinery in Beijing, we selected 905 construction machines in Beijing from August 2022 to April 2023 to monitor the emission level of smoke and NO. The exhaust smoke level and excessive emission situation of different machinery types were identified, and their NO emission levels were monitored according to the free acceleration method. We investigated the correlation of NO and smoke emission, and proposed suggestions for controlling pollution discharge from construction machinery in the future.
View Article and Find Full Text PDFOdontology
October 2024
Department of Preventive and Restorative Dentistry, School of Dentistry, São Paulo State University (UNESP), Rua José Bonifácio 1193, Araçatuba, SP, Cep 16015-050, Brazil.
To evaluate the effect of 1100 ppm F toothpastes supplemented with micrometric or nanosized β-CaGP (β-CaGPm/β-CaGPn) on artificial enamel remineralization, using a pH cycling model. Enamel blocks with artificial caries were randomly allocated into ten groups (n = 10), according to the toothpastes: without fluoride/β-CaGPm/β-CaGPn (negative control); 1100 ppm F (1100F); 1100F plus 0.125%, 0.
View Article and Find Full Text PDFJ Mech Behav Biomed Mater
March 2024
São Paulo State University (UNESP), School of Dentistry, Araçatuba, Brazil; Department of Preventive and Restorative Dentistry, Rua José Bonifácio 1193 Araçatuba, SP - Cep 16015-050, Brazil; School of Dentistry, University of Ribeirão Preto - UNAERP, Ribeirão Preto, SP, Cep 14096-900, Brazil. Electronic address:
The aim of this study was to evaluate the effects of supplementing toothpastes containing 1100 ppm F with micrometric or nanometric [beta]-calcium glycerophosphate (β-CaGPm/β-CaGPn) on artificial enamel demineralization, using a pH cycling model. Bovine enamel blocks (4 mm × 4 mm, n = 120) selected using initial surface hardness were randomly allocated to ten toothpaste groups (n = 12): without fluoride or β-CaGPm or β-CaGPn (Negative control), 1100 ppm F (1100 F), and 1100 ppm F plus 0.125%, 0.
View Article and Find Full Text PDFSensors (Basel)
December 2023
Center for the Development of Functional Materials, Federal University of São Carlos, São Carlos 13565-905, Brazil.
Although semiconducting metal oxide (SMOx) nanoparticles (NPs) have attracted attention as sensing materials, the methodologies available to synthesize them with desirable properties are quite limited and/or often require relatively high energy consumption. Thus, we report herein the processing of Zn-doped SnO NPs via a microwave-assisted nonaqueous route at a relatively low temperature (160 °C) and with a short treatment time (20 min). In addition, the effects of adding Zn in the structural, electronic, and gas-sensing properties of SnO NPs were investigated.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!