Knowledge of the physical characteristics of commercially available over-the-counter preparations can aid the compounding pharmacist in preparing medication. In this study, 15 over-the-counter products were studied with regard to their specific gravity, surface tension, pH, and rheologic profile. The specific gravities of all the products were greater than 1, with the exceptions of Nivea Lotion and rubbing alcohol, which were less than 1. The majority of the products had an acidic pH. With the exception of two products, Citrucel and Chloraseptic, all products demonstrated a surface tension value less than that of water (72.8 dynes/cm). Chloraseptic had the lowest Newtonian viscosity (1.27 cPs), whereas Vicks DayQuil had the highest (098.86 cPs). Citrucel exhibited dilatant-type flow; Suave Shampoo, herbal shampoo, Tangerine Tickle Herbal Shampoo, and Metamucil pseudoplastic flow; the remaining non-Newtonian formulations, plastic flow profiles.
Download full-text PDF |
Source |
|---|
Publication Analysis
Top Keywords
Similar Publications
On the enhancement of the efficiency of concentrated solar power plants using nanofluids based on a linear silicone fluid and Pt nanoparticles.
Sci Rep
January 2025
Department of Physical Chemistry, University of Cádiz, 11510, Puerto Real, Spain.
To reduce greenhouse emissions and producing electricity with the smallest environmental impact, developing solar power technology is one of the most important milestones to achieve. Thus, to improve the efficiency of the concentrated solar power (CSP) plants, with lower environmental impact, is of great interest. This work reports the development of nanofluids, a colloidal suspension of nanomaterials in a fluid, based on an environment-friendly base fluid for improving the performance of the heat transfer process in CSP plants.
View Article and Find Full Text PDFDynamic omniphobic surfaces enable the stable dropwise condensation of completely wetting refrigerants.
Nat Commun
January 2025
Department of Mechanical Science and Engineering, University of Illinois Urbana-Champaign, Urbana, IL, 61801, USA.
Condensation is a vital process integral to numerous industrial applications. Enhancing condensation efficiency through dropwise condensation on hydrophobic surfaces is well-documented. However, no surfaces have been able to repel liquids with extremely low surface tension, such as fluorinated solvents, during condensation, as they nucleate and completely wet even the most hydrophobic interfaces.
View Article and Find Full Text PDFOptimizing Nanobubble Production in Ceramic Membranes: Effects of Pore Size, Surface Hydrophobicity, and Flow Conditions on Bubble Characteristics and Oxygenation.
Langmuir
January 2025
John A. Reif, Jr. Department of Civil and Environmental Engineering, New Jersey Institute of Technology, 323 Martin Luther King Blvd., Newark, New Jersey 07102, United States.
Precise control of nanobubble size is essential for optimizing the efficiency and performance of nanobubble applications across diverse fields, such as agriculture, water treatment, and medicine. Producing fine bubbles, including nanobubbles, is commonly achieved by purging gas through porous media, such as ceramic or polymer membranes. Many operational factors and membrane properties can significantly influence nanobubble production and characteristics.
View Article and Find Full Text PDFStudy on Influence of Microwave Electric Field Direction on Evaporation Based on Molecular Dynamics.
J Phys Chem A
January 2025
College of Electronics and Information Engineering, Sichuan University, Chengdu 610065, China.
Microwave-assisted evaporation technology is widely used today, but its molecular mechanism is not fully understood. To investigate the molecular mechanism of the influence of microwave electric field direction on water evaporation, this paper designed experiments to measure the microwave energy required to evaporate each gram of water with electric field directions parallel and perpendicular to the water surface. The temperature rise curve of the water is controlled to be consistent in both cases, and the temperature distribution of the water is made uniform by stirring.
View Article and Find Full Text PDFDevelopment of electrospun whey protein isolate nanofiber mat for omega-3 nanoencapsulation: Microstructural and physical property analysis.
Int J Biol Macromol
January 2025
Department of Food Science and Technology, Sari Agricultural Science and Natural Resources University, PO BOX 578, Sari, Mazandaran, Iran.
This study aimed to develop bead-free nanofibers for effective omega-3 encapsulation using optimal mixing ratios of whey protein isolate (WPI)/polyvinyl alcohol (PVA) blends via electrospinning method. Various WPI-PVA ratios (100:0, 90:10, 80:20, 70:30, 60:40, 50:50 v/v) were examined for surface tension, viscosity, and conductivity. SEM images revealed uneven nanofibers with bead at 90:10 and 80:20 ratios, while the 70:30 ratio produced uniform and bead-free nanofibers with an average diameter of 262.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!