The paradigm shift in dye sensitized solar cells (DSCs) - towards donor- π bridge-acceptor (D-π-A) dyes - increases the performances of DSCs and challenges established design principles. Framed by this shifting landscape, a series of four diketopyrrolopyrrole (DPP)-based sensitizers utilizing the donor-chromophore-anchor (D-C-A) motif were investigated computationally, spectroscopically, and fabricated by systematic evaluation of finished photovoltaic cells. In all cases, the [Co(bpy)3](3+/2+) redox-shuttle afforded superior performance compared to I3(-)/I(-). Aesthetically, careful molecular engineering of the DPP chromophore yielded the first example of a high-performance blue DSC - a challenge unmet since the inception of this photovoltaic technology: DPP17 yields over 10% power conversion efficiency (PCE) with the [Co(bpy)3](3+/2+) electrolyte at full AM 1.5 G simulated sun light.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC3744082PMC
http://dx.doi.org/10.1038/srep02446DOI Listing

Publication Analysis

Top Keywords

solar cells
8
blue-coloured highly
4
highly efficient
4
efficient dye-sensitized
4
dye-sensitized solar
4
cells implementing
4
implementing diketopyrrolopyrrole
4
diketopyrrolopyrrole chromophore
4
chromophore paradigm
4
paradigm shift
4

Similar Publications

(ZnO) Cluster Decorated 2D Porous CN Materials as Efficient Solar Cells.

J Phys Chem A

January 2025

College of Physics Science and Technology, Yangzhou University, Yangzhou 225009, China.

Developing high-performance solar cells is a practical way to improve clean energy conversion efficiency. However, the performance of solar cells faces challenges such as fast carrier combination, poor stability, and limited solar light harvesting. Herein, we propose a strategy by decorating periodic holes in two-dimensional (2D) porous carbon-nitrogen (CN) materials with a zero-dimensional (0D) semiconducting (ZnO) cluster.

View Article and Find Full Text PDF

Enhancing a Perovskite Solar Cell and Module by Suppressing Protonation through Chelating Agents.

ACS Appl Mater Interfaces

January 2025

Institute of New Energy Technology, College of Physics and Optoelectronic Engineering, Jinan University, Guangzhou 510632, Guangdong, China.

Formamidinium-based perovskites (FA perovskites) often incorporate methylammonium chloride (MACl) to stabilize the α-FAPbI phase and prevent formation of the δ phase. However, MACl undergoes deprotonation and reacts with FA, leading to the generation of unstable byproducts that can cause component degradation and negatively impact the device performance. In this study, we introduce ethylenediaminetetramethylenephosphonic acid as a corrosion inhibitor, which effectively prevents the formation of these byproducts and stabilizes α-FAPbI.

View Article and Find Full Text PDF

The rational design of non-fullerene acceptors (NFAs) with both high crystallinity and photoluminescence quantum yield (PLQY) is of crucial importance for achieving high-efficiency and low-energy-loss organic solar cells (OSCs). However, increasing the crystallinity of an NFA tends to decrease its PLQY, which results in a high non-radiative energy loss in OSCs. Here we demonstrate that the crystallinity and PLQY of NFAs can be fine-tuned by asymmetrically adapting the branching position of alkyl chains on the thiophene unit of the L8-BO acceptor.

View Article and Find Full Text PDF

Novel factors of cisplatin resistance in epithelial ovarian tumours.

Adv Med Sci

January 2025

Department of Medical Biology, Faculty of Medicine, Pavol Jozef Šafárik University, Košice, Slovak Republic. Electronic address:

Ovarian tumours are these days one of the biggest oncogynecological problems. In addition to surgery, the treatment of ovarian cancer includes also chemotherapy in which platinum preparations are one of the most used chemotherapeutic drugs. The principle of antineoplastic effects of cisplatin (cis-diamminedichloroplatinum(II), CDDP) is its binding to the DNA and the formation of adducts.

View Article and Find Full Text PDF

Silica nano/microparticles have generated significant interest for the past decades, emerging as a versatile material with a wide range of applications in photonic crystals, bioimaging, chemical sensors, and catalysis. This study focused on synthesizing silica nano/microparticles ranging from 20 nm to 1.2 μm using the Stöber and modified Stöber methods.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!