Graphite furnace atomic absorption elemental analysis of ecstasy tablets.

Forensic Sci Int

School of Physical Sciences, University of Kent, Canterbury, Kent, CT2 7NH, UK.

Published: September 2013

Six metals (copper, magnesium, barium, nickel, chromium and lead) were determined in two separate batches of seized ecstasy tablets by graphite furnace atomic absorption spectroscopy (GFAAS) following digestion with nitric acid and hydrogen peroxide. Large intra-batch variations were found as expected for tablets produced in clandestine laboratories. For example, nickel in batch 1 was present in the range 0.47-13.1 parts per million (ppm) and in batch 2 in the range 0.35-9.06 ppm. Although batch 1 had significantly higher 3,4-methylenedioxy-N-methamphetamine (MDMA) content than batch 2, barium was the only element which discriminated between the two ecstasy seizures (batch 1: 0.19-0.66 ppm, batch 2: 3.77-5.47 ppm).

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.forsciint.2013.04.021DOI Listing

Publication Analysis

Top Keywords

ppm batch
12
graphite furnace
8
furnace atomic
8
atomic absorption
8
ecstasy tablets
8
batch range
8
batch
6
absorption elemental
4
elemental analysis
4
analysis ecstasy
4

Similar Publications

In this study, stems and leaves of the papaya plant were employed to prepare a high-quality porous adsorbent carbonization and chemical activation using phosphoric acid. This adsorbent demonstrates superior adsorption capabilities for the efficient removal of hazardous alizarin red s (ARS) and methylene blue (MB) dyes. Thus, it contributes to waste reduction and promotes sustainable practices in environmental remediation, aligning with global efforts to develop sustainable materials that address water pollution while supporting circular economy principles.

View Article and Find Full Text PDF

Activated Nanocellulose from Corn Husk: Application to As and Pb Adsorption Kinetics in Batch Wastewater.

Polymers (Basel)

December 2024

Research Group for the Development of Advanced Materials for Water and Food Treatment, Universidad Nacional José María Arguedas, Andahuaylas 03701, Peru.

The aim of this study was to evaluate the removal of Pb and As from an aqueous solution using corn residue cellulose nanocrystals (NCCs). The corn husk was subjected to alkaline digestion, followed by bleaching and esterification with 3% citric acid to obtain NCCs. A 10 ppm multimetal solution of Pb and As was prepared.

View Article and Find Full Text PDF

Chitosan (CS), derived from the partial deacetylation and hydrolysis of chitin, varies in the degree of deacetylation, molecular weight, and origin, influencing its biological effects, including antifungal properties. In plants, CS triggers immune responses and stimulates biomass growth. Previously, we found that the antifungal activity of CS was strongly dependent on its physicochemical properties.

View Article and Find Full Text PDF

Enhancement of electrode surface hydrophilicity and selectivity with Nafion-PSS composite for trace heavy metal sensing in electrochemical sensors.

Anal Chim Acta

January 2025

School of Chemical Engineering, Engineering Campus, Universiti Sains Malaysia, 14300, Nibong Tebal, Pulau Pinang, Malaysia. Electronic address:

Article Synopsis
  • Effective electrochemical sensing requires a balance between optimal signal output and sensitivity, which this study addresses by creating a modified screen-printed electrode (Nafion-PSS/SPE) using two sulfonate-rich polymers.
  • The Nafion-PSS/SPE was successfully employed to detect lead (Pb) and cadmium (Cd) through square wave anodic stripping voltammetry, achieving low detection limits (6.478 ppb for Pb and 5.277 ppb for Cd) and high selectivity against interfering ions.
  • This research highlights a simple screen-printing method for mass-producing heavy metal sensors and provides valuable insights into the electrode's surface properties to improve analytical performance.
View Article and Find Full Text PDF

Covalent organic frameworks (COFs) have developed as efficient and selective adsorbents to mitigate TcO contamination. However, the eco-friendly and scalable production of COF-based adsorbents for the removal of TcO has not yet been reported. This study explores the potential of a cationic COF (TpDB-COF) synthesized a green hydrothermal method, achieving gram-scale yields per batch, thereby addressing a significant limitation of existing COF production methods.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!