Background: Patients requiring knee and hip revision arthroplasty often present with difficult anatomical situations that limit options for surgery. Customised mega-implants may be one of few remaining treatment options. However, extensive damage to residual bone stock may also be present, and in such cases even customised prosthetics may be difficult to implant. Small quantities of lost bone can be replaced with standard allografts or autologous bone. Larger defects may require structural macro-allografts, sometimes in combination with implants (allograft-prosthesis composites).
Methods: Herein, we describe a process for manufacturing lesion-specific large structural allografts according to a 3D, full-scale, lithographically generated defect model. These macro-allografts deliver the volume and the mechanical stability necessary for certain complex revisions. They are patient-and implant-matched, negate some requirements for additional implants and biomaterials and save time in the operating theatre by eliminating the requirement for intra-operative sizing and shaping of standard allografts.
Conclusion: While a robust data set from long-term follow-up of patients receiving customised macro-allografts is not yet available, initial clinical experience and results suggest that lesion-matched macro-allografts can be an important component of revision joint surgery.
Download full-text PDF |
Source |
|---|---|
| http://www.ncbi.nlm.nih.gov/pmc/articles/PMC3678296 | PMC |
| http://dx.doi.org/10.1159/000345269 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Oncologic reconstructive surgery of the talus with structural allograft: Case report.
Int J Surg Case Rep
December 2024
Orthopedics and traumatology UNAB, Floridablanca, Colombia. Electronic address:
Introduction And Importance: Introduction and importance: Bone tumors of the foot constitute 3 % of all bone tumors, within these, the location in the talus constitutes between 8 and 23 % of bone tumors. Within the oncological management of these lesions, preservation surgery has had a great boom in the last 10 years, however, the use of massive structural allograft is not a conventional surgery and there is little literature on its use, which is why we consider important to document clinical cases.
Case Presentation: we document 2 clinical cases of bone tumor in the talus that were surgically managed with tumor resection plus reconstruction with total and partial talus allograft.
Pilot Study: Human Adipose Tissue Allograft for Fat Pad Defects in Patients With Preulcerative Lesions.
Plast Reconstr Surg Glob Open
December 2024
Britecyte, Inc., Frederick, MD.
Background: Loss or displacement of a fat pad on the foot increases plantar pressure, leading to pain and plantar ulcers. These ulcers, especially in patients with diabetic neuropathy, have high recurrence rates, often resulting in amputations. Standard of care focuses on reducing plantar pressure with shoe padding or orthotic devices, leaving the restoration of the fat pad as an unmet medical need.
View Article and Find Full Text PDFSelf-assembling peptide nanofibers and nanoceramics in a model of alveolar bone repair: Insights from in vivo experiments and clinical trial.
Regen Ther
March 2025
Department of Medical Biotechnology, Iran University of Medical Sciences, Tehran, Iran.
Introduction: Tooth extraction initiates a cascade of homeostatic and structural modifications within the periodontal tissues, culminating in alveolar ridge resorption. To prevent ridge resorption following extraction and facilitate successful placement of an implant-supported prosthesis, alveolar ridge preservation was performed.
Methods: In this study, the biocompatibility of a nanocomposite consisting of self-assembling peptide nanofibers (organic phase) and tri-calcium phosphate-nano hydroxyapatite (mineral phase), was evaluated in rabbits.
Repair of Acute Grade-3 Combined Posterolateral Corner Avulsion Injuries Using a Transosseous Krackow Suture Pull-Through Technique.
JBJS Essent Surg Tech
December 2024
Department of Orthopaedics and Rehabilitation, Yale School of Medicine, New Haven, Connecticut.
Background: For complete disruption of the posterolateral corner (PLC) structures, operative treatment is most commonly advocated, as nonoperative treatment has higher rates of persistent lateral laxity and posttraumatic arthritis. Some studies have shown that acute direct repair results in revision rates upwards of 37% to 40% compared with 6% to 9% for initial reconstruction. In a recent study assessing the outcomes of acute repair of PLC avulsion injuries with 2 to 7 years of follow-up, patients with adequate tissue were shown to have a much lower failure rate than previously documented.
View Article and Find Full Text PDFTissue Engineering 3D-Printed Scaffold Using Allograft/Alginate/Gelatin Hydrogels Coated With Platelet-Rich Fibrin or Adipose Stromal Vascular Fraction Induces Osteogenesis In Vitro.
J Cell Physiol
December 2024
Dental Research Center, Research Institute of Dental Sciences, Shahid Beheshti University of Medical Sciences, Tehran, Iran.
Incorporating autologous patient-derived products has become imperative to enhance the continually improving outcomes in bone tissue engineering. With this objective in mind, this study aimed to evaluate the osteogenic potential of 3D-printed allograft-alginate-gelatin scaffolds coated with stromal vascular fraction (SVF) and platelet-rich fibrin (PRF). The primary goal was to develop a tissue-engineered construct capable of facilitating efficient bone regeneration through the utilization of biomaterials with advantageous properties and patient-derived products.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!