Objectives. Many techniques were described for ureteroileal anastomosis in orthotopic bladder substitution, ranging from nonrefluxing to refluxing techniques, all aiming at preservation of the upper tract. We describe our technique of dipping the ureter into the ileal pouch, which is simple and had no complications. Patients and Methods. Our technique implies dipping the ureter in the lateral side of the pouch, in right and left corners, with two rows of four sutures fixing the seromuscular layer of the ureter to the seromuscular layer of the ileal pouch. The procedure was applied in both normal ureteric calibre and dilated ureter. Total number of procedures done was 1,340 ureters in 670 patients after radical cystectomy for invasive carcinoma of the bladder of urothelial and nonurothelial cancer. Results. Followup of patients every six months and onward did not show stenosis in the ureteroileal anastomotic site. Filling of the ureter with contrast dye on ascending pouchogram was observed in patients who had considerably dilated ureters at the time of cystectomy. Normal ureter did not show clinical reflux but radiological filling of the ureter when the intravesical pressure exceeded the leak point pressure. Time to perform the dipping technique was 5-7 minutes for each site. Conclusion. Dipping technique for ureteroileal anastomosis in orthotopic ileal neobladder avoids the incidence of stenosis, preserves the upper tract, is a fast procedure, stands the evaluation in long-term followup, and was practiced successfully for twenty years.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC3677618PMC
http://dx.doi.org/10.1155/2013/725286DOI Listing

Publication Analysis

Top Keywords

dipping technique
12
ureteroileal anastomosis
12
anastomosis orthotopic
12
upper tract
12
technique ureteroileal
8
orthotopic ileal
8
ileal neobladder
8
preservation upper
8
dipping ureter
8
ileal pouch
8

Similar Publications

Bionic adhesive materials with 3D complex micro/nanostructures have several advantages of low preload, strong adhesion, switchable adhesion, etc. As the primary high-precision fabrication method for such materials, lithography is inherently limited by its 2D processing capabilities. Achieving complex 3D morphologies typically requires auxiliary processes, such as dipping and double-sided separate UV exposures, which increase both the complexity and limitations of the fabrication process.

View Article and Find Full Text PDF

Versatile platforms of mussel-inspired agarose scaffold for cell cultured meat.

J Adv Res

January 2025

College of Biosystems Engineering and Food Science, Ningbo Innovation Center, Zhejiang University, Hangzhou 310058, China. Electronic address:

Introduction: Biomaterial scaffolds are critical for cell cultured meat production. polysaccharide scaffolds lack essential animal cell adhesion receptors, leading to significant challenges in cell proliferation and myogenic differentiation. Thus, enhancing cell adhesion and growth on polysaccharide scaffolds is strongly required to supply the gaps in cell-cultured meat production.

View Article and Find Full Text PDF

Tunnel stability is a critical factor in complex geological conditions, particularly in rock masses with steeply dipping layers. Among widely used methods, the Convergence-Confinement Method (CCM), a prevalent two-dimensional (2D) approach, effectively captures the relaxation process preceding support installation. However, most studies focus on homogeneous or horizontally layered rock masses, often overlooking the influence of steeply dipping, and layered geological formations.

View Article and Find Full Text PDF

Background: Nocturnal blood pressure dipping is crucial for cardiovascular health, but the effect of exercise on this phenomenon is not well understood. This study aims to investigate how a single session of aerobic exercise impacts nocturnal blood pressure dipping in individuals with hypertension who are on medication.

Methods: Twenty hypertensive adults (67 ± 16 years) participated in a randomised, parallel-group clinical trial.

View Article and Find Full Text PDF

Soil data from the Barbastro-Balaguer gypsum belt, NE Spain.

Data Brief

February 2025

Estación Experimental de Aula Dei, EEAD - CSIC, Ave. Montañana 1005, 50059 Zaragoza, Spain.

The dataset [1] hosts pedological info and images of the lands -locally known as - of the outcropping gypsiferous core of the Barbastro-Balaguer anticline (Fig. 1). It stands out in the landscape for the linear reliefs due to outcrops of dipping strata with differential resistance to erosion, and also because of its whitish color (Fig.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!