This Letter presents a method for the fast and broad wavelength sweeping of a standard setup of a diode's active region and its immediate vicinity, which contain the diode's optical feedback system. The selective and rapid heating of the active region is possible due to the confinement of the voltage drop to the active diode's region that has submicrometer thickness. Using the presented method and an off-the-shelf telecommunication distributed feedback laser diode, we demonstrate wavelength sweeps in excess of 10 nm that were completed in about 200 ns, while generating average optical power in excess of 50 mW. In spite of high-amplitude current-drive pulses, 6000 h continuous operation of the diode within such an operational regime did not show any significant degradation of the diode's performance.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1364/OL.38.001999 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Light quality affects chlorophyll biosynthesis and photosynthetic performance in Antarctic Chlamydomonas.
Photosynth Res
January 2025
Department of Biology, University of Ottawa, 30 Marie-Curie Pr., Ottawa, ON, K1N 6N5, Canada.
The perennially ice-covered Lake Bonney in Antarctica has been deemed a natural laboratory for studying life at the extreme. Photosynthetic algae dominate the lake food webs and are adapted to a multitude of extreme conditions including perpetual shading even at the height of the austral summer. Here we examine how the unique light environment in Lake Bonney influences the physiology of two Chlamydomonas species.
View Article and Find Full Text PDFEngineering of Cd Zn S Nanomaterials for Fabrication of Hybrid Cd Zn S/Si Heterojunction Broadband Photo Detectors.
ACS Omega
January 2025
Department of Physics, Government General Degree College Gopiballavpur-II, Jhargram 721517, India.
Effective engineering of nanostructured materials provides a scope to explore the underlying photoelectric phenomenon completely. A simple cost-effective chemical reduction route is taken to grow nanoparticles of Cd Zn S with varying = 1, 0.7, 0.
View Article and Find Full Text PDFBiomimetic Confined Assembly of Plasmonic CuS from Electronic Waste for Rapid Photothermal Disinfection.
ACS Nano
January 2025
State Key Laboratory of Pollution Control and Resources Reuse, College of Environmental Science and Engineering, Tongji University, Shanghai 200092, China.
Photothermal disinfection (PTD) offers promising potential for water purification due to its sustainable and broad-spectrum bactericidal properties, although it is hindered by slow charge separation in photosensitizers. Herein, we present a plasma-mediated PTD technique utilizing an efficient localized heating effect induced by incident light at specific wavelengths for rapid bacterial inactivation. A metallic CuS photosensitizer, derived from electronic waste through a biomimetic transmembrane confined-assembled strategy, facilitates collective and coherent oscillation of free electrons around Cu atoms in the near-infrared range.
View Article and Find Full Text PDFStretchable AgS-MXene Photodetector Designed for Enhanced Electrical Durability and High Sensitivity.
ACS Appl Mater Interfaces
January 2025
Advanced Materials Division, Korea Research Institute of Chemical Technology, Daejeon 34114, Korea.
In this work, we present a facile and straightforward approach for fabricating highly stretchable photodetectors based on AgS and TiCT MXene hybrid materials. These devices exhibit exceptional mechanical resilience, maintaining stable electrical and optical performance even after 10 000 cycles of 30% strain. The incorporation of MXene not only enhances the device's electrical durability but also ensures the retention of conductivity under significant mechanical deformation, positioning MXene as a critical material for the advancement of flexible electronics.
View Article and Find Full Text PDFHere we report a simple self-masking technique for fabricating bioinspired broadband antireflection coatings on both single-crystalline and multicrystalline silicon wafers with the assistance of a polyimide tape. Subwavelength-structured moth-eye nanopillars, which exhibit superior antireflection performance over a broad range of visible and near-IR wavelengths, can be patterned uniformly on the wafer surface by applying a chlorine-based reactive ion etching (RIE) process. The resulting random nanopillars show improved antireflection properties compared with ordered nanopillars templated by colloidal lithography under the same RIE conditions.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!