Inadvertent screw stripping during ankle fracture fixation in elderly bone.

Geriatr Orthop Surg Rehabil

International Center for Orthopaedic Advancement, Department of Orthopaedic Surgery, The Johns Hopkins University/Johns Hopkins Bayview Medical Center, Baltimore, MD, USA.

Published: May 2011

Poor screw purchase because of osteoporosis presents difficulties in ankle fracture fixation. The aim of our study was to determine if cortical thickness, unicortical versus bicortical purchase, and bone mineral density are predictors of inadvertent screw stripping and overtightening. Ten paired cadaver ankles (average donor age, 81.7 years; range, 50-97 years) were used for the study. Computed tomography scanning with phantoms of known density was used to determine the bone density along the distal fibula. A standard small-fragment, 7-hole, one-third tubular plate was applied to the lateral surface of the fibula, with 3 proximal bicortical cortical screws and 2 distal unicortical cancellous screws. A posterior plate, in which all 5 screws were cortical and achieved bicortical purchase, was subsequently applied to the same bones and positioned so that the screw holes did not overlap. A torque sensor was used to measure the torque of each screw during insertion (Ti) and then stripping (Ts). The effect of bone density, screw location, cortical thickness, and unicortical versus bicortical purchase on Ti and Ts was checked for significance (P < .05) using a general linearized latent and mixed model. We found that 9% of the screws were inadvertently stripped and 12% were overtightened. Despite 21% of the screws being stripped or being at risk for stripping, we found no significant predictors to warn of impending screw stripping. Additional work is needed to identify clinically useful predictors of screw stripping.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC3597310PMC
http://dx.doi.org/10.1177/2151458511401352DOI Listing

Publication Analysis

Top Keywords

screw stripping
16
bicortical purchase
12
inadvertent screw
8
ankle fracture
8
fracture fixation
8
cortical thickness
8
thickness unicortical
8
unicortical versus
8
versus bicortical
8
bone density
8

Similar Publications

Orthopedic screws are widely used to achieve bone reduction, compression, and construct stability. However, the relationship between insertion torque, interfragmentary compression, and fixation strength, especially when comparing standard screws with NiTiNOL/sustained dynamic compression (SDC), has not been thoroughly investigated. This study measured insertion torque, interfragmentary compression, and fixation strength for two types of headed orthopedic devices-standard and SDC-using solid foam bone replicates and cadaver validation.

View Article and Find Full Text PDF

The purpose of this study was to present the surgical technique of Unilateral Biportal Endoscopic (UBE) decompression combined with percutaneous pedicle screws for the treatment of thoracolumbar burst fractures with secondary spinal stenosis. Thoracolumbar burst fracture is a common traumatic disease in spinal surgery. In the Arbeitsgemeinschaft für Osteosynthesefragen (AO) classification of thoracolumbar fractures, Type A fractures have the highest incidence, accounting for about 70%, with A1 and A3 types being the most common.

View Article and Find Full Text PDF

Introduction: Proximal femoral nail antirotation - II (PFNA- II) is a common treatment for intertrochanteric fractures in the elderly. Removing PFNA is difficult in rare circumstances due to blade head stripping or breaking. In this article, we endeavored to explain an easy methodology that can be utilized to remove stripped, damaged anti-rotation blades for which few had been formulated but other procedures have failed.

View Article and Find Full Text PDF

Background: Due to its deep position and complex surrounding anatomy, the scapular glenoid fracture was relatively difficult to deal with especially in cases of severe fracture displacement. Improper treatment may lead to failure of internal fixation and poor fracture reduction, severely affecting the function of the shoulder joint. Inferior scapular glenoid fracture was Ideberg type II fracture, and posterior approach was commonly used to deal with inferior scapular glenoid fracture.

View Article and Find Full Text PDF
Article Synopsis
  • The study aimed to assess how often screwdriver stripping occurred in the screws used during the removal of femoral neck fracture implants and to identify related risk factors.
  • The research involved analyzing data from 47 patients who had undergone surgical fixation for specific types of femoral neck fractures between November 2019 and February 2023.
  • Results showed that 27.7% of patients experienced stripping, with a higher body mass index (BMI) showing a borderline significant link to this issue, while other factors were not significantly associated.
View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!