Bench-scale experiments were performed to evaluate virus control by an integrated electrochemical-microfiltration (MF) process from turbid (15 NTU) surface water containing moderate amounts of dissolved organic carbon (DOC, 5 mg C/L) and calcium hardness (50 mg/L as CaCO3). Higher reductions in MS2 bacteriophage concentrations were obtained by aluminum electrocoagulation and electroflotation compared with conventional aluminum sulfate coagulation. This was attributed to electrophoretic migration of viruses, which increased their concentrations in the microenvironment of the sacrificial anode where coagulant precursors are dissolved leading to better destabilization during electrolysis. In all cases, viruses were not inactivated implying measured reductions were solely due to their removal. Sweep flocculation was the primary virus destabilization mechanism. Direct evidence for virus enmeshment in flocs was provided by two independent methods: quantitative elution using beef extract at elevated pH and quantitating fluorescence from labeled viruses. Atomic force microscopy studies revealed a monotonically increasing adhesion force between viruses immobilized on AFM tips and floc surfaces with electrocoagulant dosage, which suggests secondary contributions to virus uptake on flocs from adsorption. Virus sorption mechanisms include charge neutralization and hydrophobic interactions with natural organic matter removed during coagulation. This also provided the basis for interpreting additional removal of viruses by the thick cake formed on the surface of the microfilter following electrocoagulation. Enhancements in virus removal as progressively more aluminum was electrolyzed therefore embodies contributions from (i) better encapsulation onto greater amounts of fresh Al(OH)3 precipitates, (ii) increased adsorption capacity associated with higher available coagulant surface area, (iii) greater virus-floc binding affinity due to effective charge neutralization and hydrophobic interactions, and/or (iv) additional removal by a dynamic membrane if a thick cake layer of flocs is deposited.

Download full-text PDF

Source
http://dx.doi.org/10.1021/es400291eDOI Listing

Publication Analysis

Top Keywords

sweep flocculation
8
surface water
8
charge neutralization
8
neutralization hydrophobic
8
hydrophobic interactions
8
additional removal
8
thick cake
8
viruses
6
virus
6
flocculation adsorption
4

Similar Publications

In order to solve the shortcomings of a single flocculant, the inorganic-organic hybrid flocculant SiO-CTS-DMDACC was successfully prepared by grafting copolymerization of chitosan (CTS), dimethyl diallyl ammonium chloride (DMDACC), and silicon dioxide (SiO). The performance of SiO-CTS-DMDACC in treating papermaking wastewater was investigated, and the mechanism of the flocculation process was analyzed. The results showed that the crystallinity of chitosan was reduced due to the introduction of DMDACC and SiO.

View Article and Find Full Text PDF

Simultaneous removal of Microcystis aeruginosa and microplastics by oxidation enhanced coagulation.

Environ Pollut

December 2024

Department of Environmental Science and Engineering, Fudan University, Shanghai, 200433, China; Department of Civil and Environmental Engineering, National University of Singapore, 10 Kent Ridge, 119260, Singapore. Electronic address:

The composite pollution is an increasingly severe challenge in the field of water treatment. Especially, microplastics (MPs) contamination and Microcystis aeruginosa (M. aeruginosa) were verified that they could synergistically pose a serious threat to safety of drinking water.

View Article and Find Full Text PDF

Key flocculated-species is the pivotal factor influencing the effectiveness of flocculants, which in turn directly determines the performance of mainstream wastewater treatment processes. Recovery of titanium-coagulated sludge and high-efficiency of titanium-coagulation have made titanium-coagulants an attractive hot point. However, the separation of key titanium-based flocculated-species remains a critical bottleneck limiting the advancement of titanium-based flocculant chemistry in water treatment.

View Article and Find Full Text PDF

Influence of Basalt Fiber Morphology on the Properties of Asphalt Binders and Mixtures.

Materials (Basel)

November 2024

College of Civil Science and Engineering, Yangzhou University, Yangzhou 225127, China.

Article Synopsis
  • * Researchers used microscopy and various rheological and performance tests to evaluate how chopped basalt fiber (CBF) and flocculent basalt fiber (FBF) affect asphalt binders and mixtures.
  • * The study found that both fiber types improve binder properties, but FBFs were particularly effective, showing higher resistance to deformation and providing better overall performance enhancements in asphalt mixtures compared to CBFs.
View Article and Find Full Text PDF

In this work, a green sludge bioflocculant (SBF) was prepared via chemical hydrolysis of dewatered sludge and applied to flocculation of domestic wastewater. The process parameters for the preparation of the SBF were 1.80 % hydrochloric acid concentration, 60 min extraction time, and 4000 r/min centrifugation speed.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!