The environmental fate of metal oxide particles as a function of size was assessed by comparing the behavior of CuO or ZnO nanoparticles (NPs) to that of the corresponding microparticles (MPs) in a sand matrix, with and without wheat (Triticum aestivum L.) growth. After 14 days of incubation in the planted sand, the CuO and ZnO NPs were increased from their nominal sizes of <50 nm and <100 nm, to ~317 nm and ~483 nm, respectively. Accordingly, the negative surface charge of colloids present in aqueous extracts from the sand amended with CuO (-27.0 mV) and ZnO (-10.0 mV) NPs was reduced by the presence of plants, to -19.8 mV and -6.0 mV, respectively. The surface charge of the MPs was not influenced by plants. Plant growth increased dissolution of NPs and MPs of both metal oxides in the sand from <0.3 mg/kg to about 1.0 mg/kg for the CuO products, and from ≤0.6 mg/kg to between 1.0 and 2.2 mg/kg for the Zn products. The NP or MP products reduced wheat root length by ~60% or ~50% from control levels; CuO was more toxic than ZnO. X-ray absorption spectroscopy (XAS) analysis showed that treatments with MPs or NPs of ZnO led to similar accumulations of Zn-phosphate species in the shoots, likely from dissolution of ZnO. Exposure to CuO NPs or MPs resulted in similar XAS spectra for Cu in the shoots explained by plant accumulation of both CuO and Cu(I)-sulfur complexes. These findings demonstrate the similarities between commercial NPs and MPs of CuO or ZnO in wheat plants, with greater root toxicity correlating with smaller particle size. Factors from the sand and the plant modified the aggregation or dissolution of both types of particles, thus, influencing their environmental fates.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1021/es304736y | DOI Listing |
Chempluschem
January 2025
Universita degli Studi Di Cagliari, Chemical and Geological Science, S.S. 554 bivio per Sestu, 09042, Monserrato, ITALY.
This work deals with the design of nanocomposite hydrogenation-dehydration bifunctional catalysts for the one-pot conversion of CO2 to dimethyl ether (DME), focusing on obtaining a high and homogeneous dispersion of a Cu-based CO2 hydrogenation phase into the pores of mesostructured supports. Particularly, three aluminosilicate mesostructured acid catalysts with catalytic activity towards methanol dehydration and featuring different porous structures (Al-MCM-41, Al-SBA-15, Al-SBA-16) were synthesized and used as supports to host a CuO/ZnO/ZrO2 (CZZ) CO2 hydrogenation catalyst for methanol synthesis. The use of a mesostructured support allows to maximize the exposed surface of the CO2 reduction function by nanostructuring it through its confinement within the mesochannels, thus obtaining nanocomposite bifunctional catalysts with an ultra-small hydrogenation nanophase.
View Article and Find Full Text PDFNanomaterials (Basel)
January 2025
Tecnológico Nacional de México Campus Tuxtla, Carretera Panamericana Km 1080, Tuxtla Gutiérrez C.P. 29050, Mexico.
This study provides a comprehensive structural, chemical, and optical characterization of CZTS thin films deposited on flexible Kapton substrates via the Successive Ionic Layer Adsorption and Reaction (SILAR) method. The investigation explored the effects of varying deposition cycles (40, 60, 70, and 80) and annealing treatments on the films. An X-ray diffraction (XRD) analysis demonstrated enhanced crystallinity and phase purity, particularly in films deposited with 70 cycles.
View Article and Find Full Text PDFSci Rep
January 2025
Department of Physics, Faculty of Science, University of Tabuk, Tabuk, Saudi Arabia.
Glass system of 45BO-20ZnO-30BaO-5X, (where X represents CaO, MgO, AlO, TiO, CuO and FeO) in mole percentage was investigated for gamma ray radiation shielding experimentally. Six glass composites were fabricated and the density was measured experimentally and the BZBCa glass sample has the least density with a value of 3.932 g cm and this is due to the presence of CaO in it, and the sample BZBFe has the highest density with a value of 4.
View Article and Find Full Text PDFNat Commun
January 2025
Energy Storage Research Department, Korea Institute of Energy Research (KIER), Daejeon, 34129, Republic of Korea.
Zinc (Zn)-based batteries have been persistently challenged by the critical issue of inhomogeneous zinc deposition/stripping process on substrate surface. Herein, we reveal that zinc electrodeposition behaviors dramatically improved through the introduction of highly zincophilic copper oxide nanoparticles (CuO NPs). Strong electronic redistribution between Zn and CuO explains the high Zn affinity on CuO, with negligible nucleation overpotential.
View Article and Find Full Text PDFDalton Trans
January 2025
Faculty of Materials Science and Engineering, Phenikaa University, Hanoi 12116, Viet Nam.
Cupric oxide (CuO) is a promising p-type semiconducting oxide used in many critical fields, such as energy conversion and storage, and gas sensors, which is attributed to its unique optoelectrical properties and cost-effectiveness. This work successfully deposited amorphous, pinhole-free, ultrathin CuO films using atmospheric pressure spatial atomic layer deposition (SALD) with copper(II) acetylacetonate and ozone as precursors. The growth rate increased from 0.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!