The change of contact angle is one of the major subjects in the studies of electrowetting on dielectrics. A larger change in contact angle with a less applied electric potential has been pursued by the researchers on digital microfluidics. From previous research it is concluded that the effect of free charges in electrolytes on contact angles can almost be neglected. In this article, obvious influences of free charges on contact angles are presented and discussed. To verify the influence of free charges, both weak electrolyte (boric acid) and strong electrolyte (sodium chloride) are used as sources of free charges in our experiment. It was found that the increase of ion concentration enhances the contact angle variation due to the attraction between the bound surface charges in the dielectric layer and the free counter-ions in the solution. The saturated contact angle occurs with a lower electric potential compared with de-ionized water due to the shielding of the electric field by the free counter-ions. When a strong electrolyte is used, the contact angle varies at a much higher rate than with de-ionized water, and the huge amount of accumulated free ions shields the driving field, causing the contact angle to saturate at a much lower electric potential. The saturated contact angle in strong electrolyte solution is markedly larger than those in weak electrolyte solutions and de-ionized water.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1039/c3an36832g | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Atmospheric air plasma pre-activation and customizable covalent functionalization of PVDF-membranes of microtiter filter plates.
Sci Rep
January 2025
Department of Pharmaceutical Chemistry, Semmelweis University, Hőgyes Endre U. 9, 1092, Budapest, Hungary.
Microtiter-plate-based systems are unified platforms of high-throughput experimentation (HTE). These polymeric devices are used worldwide on a daily basis-mainly in the pharmaceutical industry-for parallel syntheses, reaction optimization, various preclinical studies and high-throughput screening methods. Accordingly, laboratory automation today aims to handle these commercially available multiwell plates, making developments focused on their modifications a priority area of modern applied research.
View Article and Find Full Text PDFPostoperative guidelines following pediatric cataract and glaucoma surgeries: a survey of preferred surgeon instructions.
J AAPOS
January 2025
Johns Hopkins University Wilmer Eye Institute, Baltimore, Maryland. Electronic address:
Background Recommendations regarding long-term postoperative activity are intended to prevent adverse events, but no common policy or best practice exists among ophthalmologists for pediatric patients. We surveyed ophthalmologists on their postoperative guidelines after the one-month postoperative period following childhood cataract and glaucoma surgeries. Methods A 28-question anonymous Qualtrics survey was distributed via listservs and social media.
View Article and Find Full Text PDFStructure and properties of chitosan plasticized with hydrophobic short-chain fatty acid cosolvent.
Int J Biol Macromol
January 2025
Research Institute of Interdisciplinary Science, School of Materials Science and Engineering, Dongguan University of Technology, Dongguan 523808, China; Guangdong Provincial Key Laboratory of Extreme Conditions, Dongguan 523803, China. Electronic address:
The application of chitosan in packaging has always been limited due to its brittle and hygroscopic nature. In this study, hydrophobic short-chain fatty acids (SCFAs) were utilized to modify chitosan to overcome this issue. For the first time, hydrophobic SCFAs, typically hexanoic acid and its homologs, were found to be able to dissolve chitosan in water as well as its hydrophilic analog.
View Article and Find Full Text PDFResearch of mesoporous silica loaded lignin to enhance the anti-corrosion and anti-weathering performance of epoxy surface.
Int J Biol Macromol
January 2025
Key Laboratory of Automobile Materials, Ministry of Education, and College of Materials Science and Engineering, Jilin University, Changchun 130025, China. Electronic address:
A new type of filler was added to epoxy resin to prepare a composite coating with excellent corrosion and weathering resistance. The simple synthesis process and nonpolluting raw materials of this filler contribute to the development of green chemistry. Specifically, lignin was encapsulated in mesoporous silica, the synergistic effect between the two resulted in the formation of lignin/mesoporous silica composite particles (MSN-L) with excellent ultraviolet (UV) resistance.
View Article and Find Full Text PDFSurface Fluorination of Silicone Rubber with Enhanced Stain Resistance and Slip Properties.
ACS Appl Mater Interfaces
January 2025
State Key Laboratory of Polymer Materials Engineering, College of Polymer Science and Engineering, Sichuan University, Chengdu, Sichuan 610065, P.R. China.
Silicone rubber (SR) holds significant potential for everyday wearable devices due to its inherent sweat resistance and flexibility. However, its broader applicability is constrained by poor oil resistance and a suboptimal slip performance. In this study, we developed an SR with durable oil resistance and enhanced slip properties by forming a covalently bonded barrier layer on its surface through a one-step in situ fluorination reaction using F/N.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!