We provide an analytical solution to the problem of scattering of electromagnetic radiation by a square-wave grating with a flat graphene sheet on top. We show that for deep groves there is a strong plasmonic response, with light absorption in the graphene sheet reaching more than 45% due to the excitation of surface plasmon-polaritons. The case of a grating with a graphene sheet presenting an induced periodic modulation of the conductivity is also discussed.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1088/0953-8984/25/12/125303 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Impact of operating parameters on the electrooxidation of methylene blue and ciprofloxacin: a comprehensive analysis and degradation pathway.
Environ Sci Pollut Res Int
January 2025
Environmental Science and Engineering Department (ESED), Indian Institute of Technology Bombay, Mumbai, 400076, India.
In recent decades, freshwater bodies have experienced significant stress due to the excessive disposal of dyes from textile industries and waste antibiotic discharges from pharmaceutical industries. The continuous disposal of these substances may harm the natural ecosystem and generate antibiotic resistance in living organisms. Conventional treatment facilities are inadequate in treating these contaminants effectively, leading to a focused interest in advanced technologies, such as electrooxidation.
View Article and Find Full Text PDFCross-talk-free, high extinction ratio, and ultra-compact all‑optical 4 × 2 encoder using graphene-based plasmonic waveguides.
Sci Rep
January 2025
Department of Communications and Electronics, School of Electrical and Computer Engineering, Shiraz University, Shiraz, Iran.
This paper presents an all-optical 4 × 2 encoder based on graphene-plasmonic waveguides for operation in the wavelength range of 8-12 μm. The basic plasmonic waveguide consists of a silicon (Si) strip and a graphene sheet supported by two dielectric ridges. Surface plasmon polaritons (SPPs) are stimulated in the spatial gap between the graphene sheet and the Si strip.
View Article and Find Full Text PDFUltrasensitive and selective impedance paper-based analytical device through Dual-C imprinted sensor for determination of carcinoembryonic antigen and C-reactive protein.
Mikrochim Acta
January 2025
Department of Chemistry and Center of Excellence for Innovation in Chemistry, Faculty of Science, Ubon Ratchathani University, Ubon Ratchathani, 34190, Thailand.
Carcinoembryonic antigen (CEA) and C-reactive protein (CRP) are biomacromolecules known as cancer and inflammatory markers. Thus, they play a crucial role in early cancer diagnosis, post-treatment recurrence detection, and tumor risk assessment. This paper describes the development of an ultrasensitive and selective imprinted paper-based analytical device (PAD) as impedance sensor for determination of CEA and CRP in serum samples for point-of-care testing (POCT).
View Article and Find Full Text PDFElastomer-assisted graphene transfer technique for enhanced resonance characteristics in chemisorption-based graphene resonant mass sensors.
Nanoscale
January 2025
Department of Electrical and Electronic Information Engineering, Toyohashi University of Technology, Toyohashi, Aichi 441-8580, Japan.
A process technology was developed for transferring strained graphene sheets using an elastomer nanosheet to enhance the resonance characteristics of a graphene resonator. The strain-induced graphene resonator demonstrated a 1.80-fold improvement in the product of resonant frequency and -factor compared to the unstrained resonator.
View Article and Find Full Text PDFFast-Charging Lithium-Ion Batteries Enabled by Magnetically Aligned Electrodes.
ACS Nano
January 2025
Materials Science and Engineering Program and Walker Department of Mechanical Engineering, The University of Texas at Austin, Austin, Texas 78712, United States.
With the increasing popularity of electric transportation over the past several years, fast-charging lithium-ion batteries are highly demanded for shortening electric vehicles' charging time. Extensive efforts have been made on material development and electrode engineering; however, few of them are scalable and cost-effective enough to be potentially incorporated into the current battery production. Here, we propose a facile magnetic templating method for preparing LiFePO (LFP) cathodes with vertically aligned graphene sheets to realize fast-charging properties at a practical loading of 20 mg cm.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!