In this work, a higher concentration of Ti ions are incorporated into hydrothermally grown Ti-doped (2.2% by atomic ratio) micro-nanostructured hematite films by an in situ solid-state reaction method. The doping concentration is improved from 2.2% to 19.7% after the in situ solid-state reaction. X-ray absorption analysis indicates the substitution of Fe ions by Ti ions, without the generation of Fe²⁺ defects. Photoelectrochemical impedance spectroscopy reveals the dramatic improvement of the electrical conductivity of the hematite film after the in situ solid-state reaction. As a consequence, the photocurrent density increases 8-fold (from 0.15 mA/cm² to 1.2 mA/cm²), and it further increases up to ∼1.5 mA/cm² with the adsorption of Co ions. Our findings demonstrate that the in situ solid-state reaction is an effective method to increase the doping level of Ti ions in hematite films with the retention of the micro-nanostructure of the films and enhance the photocurrent.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1021/am302575p | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
High-Pressure Neutron Diffraction Study on ε-FeOOH: The Spin-Reorientation Transition and Hydrogen-Bond Symmetrization.
J Am Chem Soc
January 2025
Department of Earth Science, Graduate School of Science, Tohoku University, Sendai 980-8578, Japan.
The compression behavior of iron oxyhydroxide ε-FeOOH is complex, with variations in its magnetic property and bonding character. In this study, in situ powder neutron diffraction experiments were conducted on ε-FeOOH and ε-FeOOD up to pressures exceeding 20 GPa to investigate a spin-reorientation (spin-flop) transition, hydrogen-bond (H-bond) symmetrization, and their correlation. The magnetic transition was observed at 8 GPa in both ε-FeOOH and ε-FeOOD.
View Article and Find Full Text PDFBeyond Polymerization: In Situ Coupled Fluorination Enables More Stable Interfaces for Solid-State Lithium Batteries.
J Am Chem Soc
January 2025
Nanoyang Group, Tianjin Key Laboratory of Advanced Carbon and Electrochemical Energy Storage, School of Chemical Engineering and Technology, National Industry-Education Integration Platform of Energy Storage, and Collaborative Innovation Center of Chemical Science and Engineering (Tianjin), Tianjin University, Tianjin 300072, China.
In situ polymerization strategies hold great promise for enhancing the physical interfacial stability in solid-state batteries, yet (electro)chemical degradation of polymerized interfaces, especially at high voltages, remains a critical challenge. Herein, we find interphase engineering is crucial for the polymerization process and polymer stability and pioneer an in situ polymerization-fluorination (Poly-FR) strategy to create durable interfaces with excellent physical and (electro)chemical stabilities, achieved by designing a bifunctional initiator for both polymerization and on-surface lithium donor reactions. The integrated in situ fluorination converts LiCO impurities on LiNiCoMnO (NCM811) surfaces into LiF-rich interphases, effectively inhibiting the aggressive (de)lithiation intermediates and protecting the interface from underlying chemical degradation, thereby surpassing the stability limitations of polymerization alone.
View Article and Find Full Text PDFUnveiling a Tunable Moiré Bandgap in Bilayer Graphene/hBN Device by Angle-Resolved Photoemission Spectroscopy.
Adv Sci (Weinh)
January 2025
School of Physical Science and Technology, ShanghaiTech Laboratory for Topological Physics, ShanghaiTech University, Shanghai, 201210, P. R. China.
Over the years, great efforts have been devoted in introducing a sizable and tunable band gap in graphene for its potential application in next-generation electronic devices. The primary challenge in modulating this gap has been the absence of a direct method for observing changes of the band gap in momentum space. In this study, advanced spatial- and angle-resolved photoemission spectroscopy technique is employed to directly visualize the gap formation in bilayer graphene, modulated by both displacement fields and moiré potentials.
View Article and Find Full Text PDFProbing and manipulating the Mexican hat-shaped valence band of InSe.
Nat Commun
January 2025
School of Physics and Astronomy, University of Nottingham, Nottingham, UK.
Ferroelectrics based on van der Waals semiconductors represent an emergent class of materials for disruptive technologies ranging from neuromorphic computing to low-power electronics. However, many theoretical predictions of their electronic properties have yet to be confirmed experimentally and exploited. Here, we use nanoscale angle-resolved photoemission electron spectroscopy and optical transmission in high magnetic fields to reveal the electronic band structure of the van der Waals ferroelectric indium selenide (α-InSe).
View Article and Find Full Text PDFElectronic structure of superconducting infinite-layer lanthanum nickelates.
Sci Adv
January 2025
National Laboratory of Solid State Microstructures, Jiangsu Key Laboratory of Artificial Functional Materials, College of Engineering and Applied Sciences, Nanjing University, Nanjing 210093, China.
Revealing the momentum-resolved electronic structure of infinite-layer nickelates is essential for understanding this class of unconventional superconductors but has been hindered by the formidable challenges in improving the sample quality. In this work, we report the angle-resolved photoemission spectroscopy of superconducting LaSrNiO films prepared by molecular beam epitaxy and in situ atomic-hydrogen reduction. The measured Fermi topology closely matches theoretical calculations, showing a large Ni [Formula: see text]-derived Fermi sheet that evolves from hole-like to electron-like along and a three-dimensional (3D) electron pocket centered at the Brillouin zone corner.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!