Aerobic granular sludge (AGS) was successfully cultivated at 27±1 °C and pH 7.0±1 during the treatment of rubber wastewater using a sequential batch reactor system mode with complete cycle time of 3 h. Results showed aerobic granular sludge had an excellent settling ability and exhibited exceptional performance in the organics and nutrients removal from rubber wastewater. Regular, dense and fast settling granule (average diameter, 1.5 mm; settling velocity, 33 m h(-1); and sludge volume index, 22.3 mL g(-1)) were developed in a single reactor. In addition, 96.5% COD removal efficiency was observed in the system at the end of the granulation period, while its ammonia and total nitrogen removal efficiencies were up to 94.7% and 89.4%, respectively. The study demonstrated the capabilities of AGS development in a single, high and slender column type-bioreactor for the treatment of rubber wastewater.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1016/j.biortech.2012.12.113 | DOI Listing |
RSC Adv
January 2025
Hainan Provincial Key Laboratory of Natural Rubber Processing, Agricultural Products Processing Research Institute, Chinese Academy of Tropical Agricultural Sciences Zhanjiang 524001 P. R. China
Addressing the environmental challenges posed by oil spills and industrial wastewater is critical for sustainable development. Graphene aerogels demonstrate significant potential as highly efficient adsorbents due to their high specific surface area, excellent structural tunability and outstanding chemical stability. Among available fabrication methods, the hydrothermal self-assembly technique stands out for its low cost, high tunability and good scalability.
View Article and Find Full Text PDFBiodegradation
December 2024
Department of Environmental Engineering, Middle East Technical University, 06800, Ankara, Turkey.
This study focused on a new approach for valorization of both ground tire rubber (GTR) and nitrate-containing wastewater via simultaneous devulcanization and denitrification. Initially, sulfur-based autotrophic denitrifiers were successfully enriched from three different seed sludge sources, biological nutrient removal (BNR) sludge, anaerobic digester sludge and BNR sludge of a leather organized industrial zone WWTP. Average nitrate removal efficiencies were 96-98%.
View Article and Find Full Text PDFSci Total Environ
December 2024
Institute of Polar Sciences, National Research Council (CNR-ISP), Via Torino, 155, 30172 Venice Mestre, VE, Italy; Department of Environmental Sciences, Informatics and Statistics, Ca' Foscari University of Venice, Via Torino, 155, 30172 Venice Mestre, VE, Italy.
Bioresour Technol
January 2025
State Key Joint Laboratory of Environmental Simulation and Pollution Control, Research Center for Eco-Environmental Sciences, Chinese Academy of Sciences, Beijing 100085, China; Laboratory of Water Pollution Control Technology, Research Center for Eco-Environmental Sciences, Chinese Academy of Sciences, Beijing 100085, China; University of Chinese Academy of Sciences, Beijing 100049, China; National Institute of Fundamental Studies, Hanthana Road, Kandy 20000, Sri Lanka. Electronic address:
Global rubber industry, growing 4-6 % annually with 13.76 million Mt of rubber produced in 2019, significantly impacts the economy. This study explores coupling sulfate-dependent ammonium oxidation (Sulfammox) and sulfide-driven autotrophic denitrification (SDAD) within an anaerobic membrane bioreactor (AnMBR) to treat high-strength natural rubber wastewater.
View Article and Find Full Text PDFInt J Biol Macromol
December 2024
Istanbul Technical University, Faculty of Science and Letters, Department of Chemistry, Soft Materials Research Laboratory, 34469 Maslak, Istanbul, Turkey. Electronic address:
Anionic polysaccharide-based gels enable the design of biobased materials with biochemical properties, non-toxic and natural origin. A new set of cationic gels was prepared from carboxymethylcellulose (CMC)-doped tertiary amino functional cationic monomers 2-(dimethylamino)ethyl methacrylate and N-(3-(dimethylamino)propyl) methacrylamide via the formation of semi-interpenetrated network (semi-IPN) at different polymerization temperatures, T. A detailed understanding of the temperature-dependent synthesis and physicochemical response is required for the design of interpenetrating networks with CMC as an adsorbent that provides effective sources for the removal of azo-food dyes such as tartrazine and carmoisine from aqueous solutions.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!