Evaluating facial pores and skin texture after low-energy nonablative fractional 1440-nm laser treatments.

J Am Acad Dermatol

SkinCare Physicians, Chestnut Hill, Massachusetts 02467, USA.

Published: January 2013

Background: The fractionated nonablative 1440-nm laser creates microscopic thermal wounds within the epidermis and the dermis and is used clinically to improve tone, texture, and color of skin.

Objective: We sought to investigate the use of this device to treat facial pores and to improve skin texture.

Methods: Twenty patients received 6 treatments at the highest tolerable energy level performed 2 weeks apart. Photographic assessments using the VISIA-CR (Canfield Scientific Inc, Fairfield, NJ) imaging system were performed. The pore score was calculated, which is the percentage of the skin surface that has detected pores. Subjective measurements (0-4 scale) were recorded by both the subject and investigator regarding pore appearance, skin texture, and overall skin appearance. Treatment discomfort was scored by patients (1-10 scale).

Results: After 6 treatments there was a significant reduction in pore score (P < .002). Total average pore score at baseline was 2.059 ± 0.8 and 2 weeks after the final treatment it was 1.700 ± 0.8, resulting in a 17% average reduction in pore score. Study investigators reported average scores being 1.95 ± 0.3 for improved pore appearance and 2.75 ± 0.2 for improved overall appearance (0-4 scale). Subjects noted average scores of 1.9 ± 0.5 for improvement of the appearance of pores and 2.85 ± 0.4 for improvement of overall appearance (0-4 scale). The average discomfort score during treatments was reported to be 4.6 ± 0.1 (1-10 scale). There were no serious adverse effects or long-term side effects.

Limitations: Small sample size and limited follow-up are study limitations.

Conclusions: A series of treatments with the nonablative low-energy fractional 1440-nm laser appears to be safe and effective for reducing detectable pores and improving overall skin appearance.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.jaad.2012.08.041DOI Listing

Publication Analysis

Top Keywords

pore score
16
1440-nm laser
12
0-4 scale
12
facial pores
8
skin texture
8
fractional 1440-nm
8
pore appearance
8
skin appearance
8
reduction pore
8
average scores
8

Similar Publications

In silico drug repurposing at the cytoplasmic surface of human aquaporin 1.

PLoS One

January 2025

Genome and Structural Bioinformatics Group, Faculty of Medicine, Health and Life Science, Swansea University, Swansea, Wales, United Kingdom.

Aquaporin 1 (AQP1) is a key channel for water transport in peritoneal dialysis. Inhibition of AQP1 could therefore impair water transport during peritoneal dialysis. It is not known whether inhibition of AQP1 occurs unintentionally due to off-target interactions of administered medications.

View Article and Find Full Text PDF

This study investigates the effect of microstructural changes in polyurethane coatings on their water resistance properties. Polyurethane coatings with varying diluent contents were prepared and tested for water penetration resistance and mechanical property retention. The time-dependent behavior of water within the coatings at different immersion durations was analyzed using low-field nuclear magnetic resonance (NMR).

View Article and Find Full Text PDF

Design, characterisation, and clinical evaluation of a novel porous Ti-6Al-4V hemipelvic prosthesis based on Voronoi diagram.

Biomater Transl

September 2024

Orthopaedic Research Institute and Department of Orthopaedics, West China Hospital, Sichuan University, Chengdu, Sichuan Province, China.

Three-dimensional printed Ti-6Al-4V hemipelvic prosthesis has become a current popular method for pelvic defect reconstruction. This paper presents a novel biomimetic hemipelvic prosthesis design that utilises patient-specific anatomical data in conjunction with the Voronoi diagram algorithm. Unlike traditional design methods that rely on fixed, homogeneous unit cell, the Voronoi diagram enables to create imitation of trabecular structure (ITS).

View Article and Find Full Text PDF

This study focused on persimmons and applied variable-temperature pressure-differential puffing drying to produce persimmon chips. The effects of puffing pressure, holding time, drying temperature, and duration on moisture content, crispness, and sensory scores were examined. The optimal parameters determined via response surface methodology were a pressure differential of 0.

View Article and Find Full Text PDF

Introduction: In inguinal hernia repair, mesh weight and pore size are used to describe the mesh characteristics. One meta-analysis of laparo-endoscopic inguinal hernia repairs identified 12 prospective randomized controlled trials (RCTs) with 2,909 patients who had all been treated with lightweight (≤ 50 g/m²) or heavyweight (> 70 g/m²) meshes. None of the 12 RCTs gave details of the pore size.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!