The incipient contact plasticity of metallic surfaces involves nucleation of crystalline defects. The present molecular dynamics simulations and nanoindentation experiments demonstrate that the current notion of nanocontact plasticity in fcc metals does not apply to high-strength bcc metals. We show that nanocontact plasticity in Ta-a model bcc metal-is triggered by thermal and loading-rate dependent (dynamic) nucleation of planar defects such as twins and unique {011} stacking fault bands. Nucleation of different planar defects depending on surface orientation leads to distinct signatures (pop ins) in the nanoindentation curves. Nanoscale plasticity is then ruled by an outstanding dynamical mechanism governing twin annihilation and subsequent emission of linear defects (full dislocations). While this investigation concerns Ta crystals, the present are landmark findings for other model bcc metals.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1103/PhysRevLett.109.075502 | DOI Listing |
Nat Commun
May 2022
University of Tokyo, Institute of Industrial Science, Tokyo, JP, Japan.
The behavior of materials in sliding contact is challenging to determine since the interface is normally hidden from view. Using a custom microfabricated device, we conduct in situ, ultrahigh vacuum transmission electron microscope measurements of crystalline silver nanocontacts under combined tension and shear, permitting simultaneous observation of contact forces and contact width. While silver classically exhibits substantial sliding-induced plastic junction growth, the nanocontacts exhibit only limited plastic deformation despite high applied stresses.
View Article and Find Full Text PDFACS Appl Mater Interfaces
October 2019
Department of Mechanical Engineering and Applied Mechanics , University of Pennsylvania, Philadelphia , Pennsylvania 19104 , United States.
Nanoindentation and sliding experiments using single-crystal silicon atomic force microscope probes in contact with diamond substrates in vacuum were carried out in situ with a transmission electron microscope (TEM). After sliding, the experimentally measured works of adhesion were significantly larger than values estimated for pure van der Waals (vdW) interactions. Furthermore, the works of adhesion increased with both the normal stress and speed during the sliding, indicating that applied stress played a central role in the reactivity of the interface.
View Article and Find Full Text PDFNanotechnology
January 2019
Department of Mechanical Engineering and Materials Science, University of Pittsburgh, Pittsburgh, PA 15261, United States of America.
Metal nanocontacts play a critical role in atomic force microscopy, functional nanostructures, metallic nanoparticles, and nanoscale electromechanical devices. In all cases, knowledge of the area of contact, and its variation with load, is critical for the quantitative prediction of behavior. Often, the contact area is predicted using continuum mechanics models which relate contact size to geometry, material properties, and load.
View Article and Find Full Text PDFBiosens Bioelectron
October 2018
Nano Electronic Center of Excellence, Nano Bio Electronic Devices Lab, School of Electrical and Computer Eng, Faculty of Engineering, University of Tehran, P.O. Box 14395/515, Tehran, Iran; Nano Electronic Center of Excellence, Thin Film and Nanoelectronic Lab, School of Electrical and Computer Eng, Faculty of Engineering, University of Tehran, P.O. Box 14395/515, Tehran, Iran. Electronic address:
Determining the migratory and invasive capacity of cancer cells as well as clarifying the underlying mechanisms are most relevant for developing biosensors in cancer diagnosis, prognosis, drug development and treatment. Intravasation of metastatic cells into blood stream initiated by their invasion to vascular layer would be a significant characteristic of metastasis. Many types of biochemical and bioelectrical sensors were developed for early detection of metastasis.
View Article and Find Full Text PDFSci Rep
February 2017
Division of Materials Science, Faculty of Pure and Applied Sciences, University of Tsukuba, Tsukuba, Ibaraki 305-8573, Japan.
Various types of nanometer-sized structures have been applied to advanced functional and structural devices. Inherent structures, thermal stability, and properties of such nanostructures are emphasized when their size is decreased to several nanometers, especially, to several atoms. In this study, we observed the atomistic tensile deformation process of zirconium nanocontacts, which are typical nanostructures used in connection of nanometer-sized wires, transistors, and diodes, memory devices, and sensors, by in situ transmission electron microscopy.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!