Experimental studies were carried out on flue gas denitrification using activated carbon irradiated by microwave. The effects of microwave irradiation power (reaction temperature), the flow rate of flue gas, the concentration of NO and the flue gas coexisting compositions on the adsorption property of activated carbon and denitrification efficiency were investigated. The results show that: the higher of microwave power, the higher of denitrification efficiency; denitrification efficiency would be greater than 99% and adsorption capacity of NO is relatively stable after seven times regeneration if the microwave power is more than 420 W; adsorption capacity of NO in activated carbon bed is 33.24 mg/g when the space velocity reaches 980 per hour; adsorption capacity declines with increasing of the flow rate of flue gas; the change in denitrification efficiency is not obvious with increasing oxygen content in the flue gas; and the maximum adsorption capacity of NO was observed when moisture in flue gas was about 5.88%. However, the removal efficiency of NO reduces with increasing moisture, and adsorption capacity and removal efficiency of NO reduce with increasing of SO2 concentration in the flue gas.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1080/09593330.2011.646318 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Induce (101) plane exposure boosting photocatalytic CO reduction in aerobic environment for NH-MIL-125.
J Colloid Interface Sci
December 2024
College of Materials Science and Engineering, Xi'an University of Architecture and Technology, Xi'an 710055, PR China. Electronic address:
NH-MIL-125 with abundant porosity and specific interactions with CO molecules, has been demonstrate great potential in the field of photocatalytic CO reduction. However, conventional NH-MIL-125 and their composites much lower CO photoreduction efficiency in aerobic environments because of the O competition. To circumvent the issue, this study modifies NH-MIL-125 through crystal facet engineering to enhance its selective CO adsorption and photocatalytic efficiency in the environment of impurity CO.
View Article and Find Full Text PDFAnalysis of carbon reduction potential from typical municipal solid waste incineration plants under MSW classification.
J Environ Manage
December 2024
College of Environmental and Municipal Engineering, Qingdao University of Technology, Qingdao, 266520, China.
The disposal of municipal solid waste (MSW) is a significant source of greenhouse gas (GHG) emissions. As incineration becomes the primary method of MSW disposal in China, MSW incineration (MSWI) plants are expected to play a crucial role in mitigating GHG emissions in the waste sector. This study estimated the quarterly GHG emissions from two representative MSWI plants in Qingdao using a life-cycle assessment (LCA) approach.
View Article and Find Full Text PDF[Analysis of the Impact of Waste Classification on Carbon Emission Reduction of Waste Treatment in Urban-Rural Integration Mode： A Case Study of Baoji City].
Huan Jing Ke Xue
January 2025
Shaanxi Key Laboratory of Environmental Engineering, School of Environment and Municipal Engineering, Xi'an University of Architecture and Technology, Xi'an 710055, China.
Domestic waste treatment is an important source of anthropogenic greenhouse gas emissions, and it is of great significance to clarify the carbon emission intensity of each link before and after waste classification treatment to help with the "double carbon" goal. Based on the relevant data on domestic waste generation in Baoji City in 2021, combined with the integrated urban and rural domestic waste disposal model, the carbon emission intensity of urban and rural domestic waste treatment before and after classification was calculated using the IPCC inventory guide carbon emission factor method. The results showed that by reducing the proportion of simple landfills in rural areas, the carbon reduction could reach 59 451.
View Article and Find Full Text PDFOne-Pot Synthesis of Multicentric DIL@PDIL Catalyst for Mild CO 2 Conversion to Cyclic Carbonates.
Chemistry
December 2024
Guangdong Pharmaceutical University, Guangzhou Higher Education Mega Center, 510006, Guangzhou, CHINA.
Among the various studies on CO2 utilization, the sustainable and cost-effective fixation of CO2 into cyclic carbonates remains one of the most intriguing subjects. To this end, a novel type of composite dicationic ionic liquid material, DIL@PDIL, was developed. This composite consists of a dicationic ionic liquid (DIL), DMAP[TMGH]Br, supported on a polymeric dicationic ionic liquid (PDIL), P-DVB/Im[TMGH]Br.
View Article and Find Full Text PDFTowards the use of low-concentration CO2 sources by direct selective electrocatalytic reduction.
Angew Chem Int Ed Engl
December 2024
Ruhr University Bochum, Analytische Chemie, Universitätsstr 150, 44780, Bochum, GERMANY.
The direct CO2 reduction reaction (CO2RR) from simulated flue gas of various CO2 concentrations could minimize extra energy for pre-concentration processes to highly concentrated CO2 as a feed-stock. We investigate the challenges for CO2RR caused by low CO2 concentrations and provide strategies concerning the impact of the chosen electrocatalyst material and the selection of the electrolyte to attain high CO selectivity. We continuously feed CO2 mixed with N2 (the typical dilutant in flue gas) in various ratios to gas diffusion electrodes in a model flow-through electrolyzer.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!