Competitive adsorption of phenol and 3-chlorophenol on purified MWCNTs.

J Colloid Interface Sci

Department of Physical Chemistry and Materials Science, Budapest University of Technology and Economics, H-1521 Budapest, Hungary.

Published: December 2012

A commercial multiwall carbon nanotube and its carboxylated derivate (CNTC and COOHC, respectively) was used after purification to study the competitive adsorption of phenol (P) and m-chlorophenol (CP) from 0.1 M aqueous NaCl solutions without external pH control. The adsorption takes place practically exclusively on the external surface of the nanotubes. The uptake of P is suppressed in comparison to its single solute behaviour on both nanotubes, independently of the initial pollutant concentration. The uptake of CP however is more sensitive to the concentration and the surface chemistry of the nanotube. The measured co-adsorption isotherms were compared to the isotherms calculated from the competitive Langmuir model (CLM). Preferential adsorption of CP was observed in about 95% of the relative concentration range. The total adsorption may exceed the corresponding single component sorption capacity.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.jcis.2012.07.064DOI Listing

Publication Analysis

Top Keywords

competitive adsorption
8
adsorption phenol
8
phenol 3-chlorophenol
4
3-chlorophenol purified
4
purified mwcnts
4
mwcnts commercial
4
commercial multiwall
4
multiwall carbon
4
carbon nanotube
4
nanotube carboxylated
4

Similar Publications

Electrocatalytic dehalogenative deuteration is a sustainable method for precise deuteration, whereas its Faradaic efficiency (FE) is limited by a high overpotential and severe D evolution reaction (DER). Here, Cu site-adjusted adsorption and crown ether-reconfigured interfacial DO are reported to cooperatively increase the FE of dehalogenative deuteration up to 84% at -100 mA cm. Cu sites strengthen the adsorption of aryl iodides, promoting interfacial mass transfer and thus accelerating the kinetics toward dehalogenative deuteration.

View Article and Find Full Text PDF

The remediation of wastewaters contaminated with dyes (discharged mainly from industry) is very important for preserving environmental quality and human health. In this study, a new composite chitosan (CS)-based adsorbent combined with activated carbon (AC) and curcumin (Cur) (abbreviated hereafter as CS/AC@Cur) in three different ratios (12.5%, 25%, and 50%) was synthesized for the removal of anionic [reactive black 5 (RB5)] and cationic [methylene blue (MB)] dyes in single-component or binary systems.

View Article and Find Full Text PDF

This perspective work examines the current advancements in integrated CO capture and electrochemical conversion technologies, comparing the emerging methods of (1) electrochemical reactive capture (eRCC) though amine- and (bi)carbonate-mediated processes and (2) direct (flue gas) adsorptive capture and conversion (ACC) with the conventional approach of sequential carbon capture and conversion (SCCC). We initially identified and discussed a range of cell-level technological bottlenecks inherent to eRCC and ACC including, but not limited to, mass transport limitations of reactive species, limitation of dimerization, impurity effects, inadequate generation of CO to sustain industrially relevant current densities, and catalyst instabilities with respect to some eRCC electrolytes, amongst others. We followed this with stepwise perspectives on whether these are considered intrinsic challenges of the technologies - otherwise recommendations were disclosed where appropriate.

View Article and Find Full Text PDF

Corrosion inhibitors are widely used to mitigate safety risks and economic losses in engineering, yet post-adsorption processes remain underexplored. In this study, we employed density functional theory calculations with a periodic model to investigate the dissociation mechanisms of imidazole on the Fe(100) surface. Imidazole was found to adsorb optimally in a parallel orientation, with an adsorption energy of -0.

View Article and Find Full Text PDF

A novel biochar material with magnetic modification by MnFeO and surficial hydroxyl grafting (h-MFO-BC) was synthesized for capturing HMs (Cd, Pb and Cu) and their competition in composite systems was investigated. The modification of hydroxyl considerably improved the adsorption capacity of HMs. Chemisorption and monolayer and homogeneous reaction dominated adsorption processes.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!