Sustainable production of syngas from biomass-derived glycerol by steam reforming over highly stable Ni/SiC.

ChemSusChem

Department of Chemical & Biomolecular Engineering, Graduate School of EEWS (WCU), Korea Advanced Institute of Science and Technology, Daejeon 305-701, Korea.

Published: August 2012

The production of syngas was investigated by steam reforming glycerol over Ni/Al(2)O(3), Ni/CeO(2), and Ni/SiC (which have acidic, basic, and neutral properties) at temperatures below 773 K. The complete and stable conversion of glycerol with a yield (higher than 90 %) of gaseous products (mainly syngas) was achieved over Ni/SiC during a 60 h reaction, whereas the conversion of glycerol continually decreases over Ni/Al(2)O(3) (by 49.8 %) and Ni/CeO(2) (by 77.1 %). The deactivation of Ni/Al(2)O(3) and Ni/CeO(2) is mainly caused by coke deposition because of the C-C cleavage of the byproducts produced by dehydration over acidic sites and condensation over basic sites. Gaseous products with a 1.0-1.9 syngas ratio (H(2)/CO) are produced over Ni/SiC. This ratio is required for the Fischer-Tropsch synthesis. However, a syngas ratio of more than 3.0 was observed over Ni/Al(2)O(3) and Ni/CeO(2) because of the high activity of the water-gas-shift reaction. Any dissociative or associative adsorption of water on Al(2)O(3) and CeO(2) promotes a water-gas-shift reaction and produces a higher syngas ratio. H(2) and CO were mainly produced by decomposition of glycerol through dehydrogenation and decarbonylation over Ni sites. Thus, SiC promotes an intrinsic contribution of nickel (dehydrogenation, and decarbonylation) without any byproducts from the dehydration and condensation.

Download full-text PDF

Source
http://dx.doi.org/10.1002/cssc.201100821DOI Listing

Publication Analysis

Top Keywords

ni/al2o3 ni/ceo2
12
syngas ratio
12
production syngas
8
steam reforming
8
conversion glycerol
8
gaseous products
8
water-gas-shift reaction
8
dehydrogenation decarbonylation
8
syngas
6
glycerol
5

Similar Publications

Sustainable hydrogen production from bio-oil model compounds (meta-xylene) and mixtures (1-butanol, meta-xylene and furfural).

Bioresour Technol

September 2016

Dept. of Chemical and Environmental Engineering, Faculty of Engineering, University of the Basque Country (UPV/EHU), C/Alda. Urquijo s/n, 48013 Bilbao, Spain.

In the present work m-xylene and an equimolecular mixture of m-xylene, 1-butanol and furfural, all of them bio-oil model compounds, were studied in steam reforming (SR) conditions. Three different nickel catalysts, which showed to be active in 1-butanol SR (Ni/Al2O3, Ni/CeO2-Al2O3 and Ni/La2O3-Al2O3), were tested and compared with thermodynamic equilibrium values. Tests were carried out at temperatures from 800 to 600°C at atmospheric pressure with a steam to carbon ratio (S/C) of 5.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!