In many cases knee osteoarthritis leads to total knee replacement surgery (TKR) even if the lateral compartment is not involved. More recently, a bicompartmental knee replacement system (BKR) (Journey Deuce, Smith & Nephew Inc., Memphis, TN, USA) has been developed that only replaces the medial tibiofemoral and the patellofemoral compartments, thus preserving both cruciate ligaments with its associated benefits. However information on the effect of BKR on in vivo knee joint kinematics is not widely available in the literature. Therefore, this study analyzed full three-dimensional knee joint kinematics in 10 postoperative BKR-subjects for a broad spectrum of relevant daily life activities: walking, walking followed by a cross-over or sidestep turn, step ascent and descent, mild squatting and chair rise. We analyzed to what extent normal knee motion is regained through comparison with their non-involved limb as well as a group of matched controls. Furthermore, coefficients of multiple correlation were calculated to assess the consistency of knee joint kinematics both within and between subject groups. This analysis demonstrated that, despite the presence of differences indicative for retention of pre-operative motion patterns and/or remaining compensations, knee joint kinematics in BKR limbs replicate, for a large range of daily-life motor tasks, the kinematics of the contra-lateral non-affected limbs and healthy controls to a similar extent as they are replicated within both these control groups.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1016/j.gaitpost.2012.04.008 | DOI Listing |
Patients with anterior cruciate ligament reconstruction frequently present asymmetries in the sagittal plane dynamics when performing single leg jumps but their assessment is inaccessible to health-care professionals as it requires a complex and expensive system. With the development of deep learning methods for human pose detection, kinematics can be quantified based on a video and this study aimed to investigate whether a relatively simple 2D multibody model could predict relevant dynamic biomarkers based on the kinematics using inverse dynamics. Six participants performed ten vertical and forward single leg hops while the kinematics and the ground reaction force "GRF" were captured using an optoelectronic system coupled with a force platform.
View Article and Find Full Text PDFActa Bioeng Biomech
September 2024
Faculty of Sports Science, Ningbo University, Ningbo, China.
: Asymptomatic patellar tendon abnormality (APTA) is considered a precursor to patellar tendinopathy (PT), but its pathogenesis remains unclear, especially regarding changes in muscle coordination. Therefore, it is essential to explore the muscle synergy patterns in individuals with APTA. This study recorded sEMG data during stop-jump tasks in 8 APTA and 8 healthy amateur male basketball players in a simulated basketball game.
View Article and Find Full Text PDFActa Bioeng Biomech
September 2024
Xinjiang University, China.
: The purpose of this study was to investigate dynamic responses of Lenke1B+ spines of adolescent scoliosis patients to different frequencies. : Modal analysis, harmonic response analysis and transient dynamics of a full spine model inverted by the finite element method using Abaqus. : The first-order axial resonance frequency of 4.
View Article and Find Full Text PDFActa Bioeng Biomech
September 2024
Key Laboratory for Biomechanics and Mechanobiology of Ministry of Education.
: Elbow contracture is a common complication post-elbow trauma, the biomechanical environment after anterior capsule injury was complex. This study aimed to use a finite element model to investigate the biomechanical environment within elbow capsule and its surrounding tissues at various stages after anterior capsule injury. : A finite element model of the elbow joint, incorporating muscle activation behavior, was developed to simulate elbow flexion under normal condition (no injury) and at 2, 4, 6 and 8 weeks following anterior joint capsular injury.
View Article and Find Full Text PDFActa Bioeng Biomech
September 2024
Department of Mechanics, Materials and Biomedical Engineering, Faculty of Mechanical Engineering, Wrocław University of Science and Technology, Wrocław, Poland.
: The aim of this study was to evaluate the abrasive wear of the sliding screw-rod joint used in growth guidance system (GGS) stabilizers, allowing for the translation of the screw along the rod during the spinal growth process in a standard and modified system. : The study used single kinematic screw-rod pairs made of titanium alloy Ti6Al4V. Mechanical tests (cyclic loads) simulated the stabilizer's operation under conditions similar to actual use.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!