Combustion and gasification characteristics of chars from raw and torrefied biomass.

Bioresour Technol

Sibley School of Mechanical and Aerospace Engineering, Upson Hall, Cornell University, Ithaca, NY 14853, USA.

Published: September 2012

Torrefaction is a mild thermal pretreatment (T<300°C) that improves biomass milling and storage properties. The impact of torrefaction on the gasification and oxidation reactivity of chars from torrefied and raw biomass was investigated. Thermogravimetric analysis was used to study the differences in O(2) and steam reactivity, between chars prepared from torrefied and raw willow, under both high- and low-heating-rate conditions. High-heating-rate chars were prepared at 900°C with a residence time of 2s. Low-heating-rate chars were prepared with a heating rate of 33°C/min, a maximum temperature of 850 or 1000°C, and a residence time of 30 min or 1h, respectively, at the maximum temperature. Pretreatment by torrefaction consistently reduced char reactivity. Torrefaction's impact was greatest for high-heating-rate chars, reducing reactivity by a factor of two to three. The effect of torrefaction on a residence time requirements for char burnout and gasification was estimated.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.biortech.2012.05.109DOI Listing

Publication Analysis

Top Keywords

combustion gasification
4
gasification characteristics
4
characteristics chars
4
chars raw
4
raw torrefied
4
torrefied biomass
4
biomass torrefaction
4
torrefaction mild
4
mild thermal
4
thermal pretreatment
4

Similar Publications

Hydrogen (H) offers a less carbon-intensive energy production method than natural gas. The potential of utilizing hydrogen at a large scale within the future energy mix to fuel the world opens the door to investigating hydrogen production from heavy and extra-heavy oil reservoirs. Various reaction mechanisms are involved in the in situ combustion gasification of heavy oil to produce sustainable and low carbon intensive hydrogen.

View Article and Find Full Text PDF

The valorization of shell-based agricultural waste biomass for biofuel production represents a promising approach within the circular bioeconomy. This study employs a bibliometric analysis to investigate research trends and identify key developments in the field from 1997 to 2023, using data from the Web of Science and VOSviewer for scientific mapping. A total of 1333 research articles were examined, revealing notable shifts in research focus: from pyrolysis and biomass energy (1997-2005) to gasification (2006-2014), and more recently, to enzymatic hydrolysis and lignocellulosic biomass gasification (2015-2023).

View Article and Find Full Text PDF

Thermal processes are emerging as promising solutions to recovering phosphorus and other nutrient elements from anaerobic digestates. The feasibility of nutrient element recovery depends largely on the fates of nutrient elements and heavy metals during thermal processing. This study assesses the partitioning of macronutrients (N, P, K, Na, Ca and Mg) and heavy metals (Zn, Cu, and Mn) between condensed and gaseous phases during thermal conversion of cattle slurry digestates in gas atmospheres of pyrolysis, combustion, and gasification processes.

View Article and Find Full Text PDF

To comprehensively explore syngas cocombustion technology, gasification experiments in a bench-scale circulating fluidized bed (CFB) and three-dimensional (3D) numerical simulations of a coal-fired boiler furnace have been conducted. In the amplification experiment of biomass gasification, sawdust has been gasified using air, oxygen-enriched air, and steam. The highest heating value of the syngas products reaches 12.

View Article and Find Full Text PDF

Leather waste contains up to 10% nitrogen (N); thus, combustion or gasification only for the energy recovery would not be rational, if safety standards are met. On the other hand, the chromium (Cr) content exceeding 5% in half of the waste stream (/) is too significant to be applied in agriculture. In this work, four acid hydrolysates from leather waste shavings, both wet-white free of Cr and wet-blue with Cr, were used: two with a mixture of acids and supplemented with Cu, Mn, and Zn, and the other two as semi-products from collagen extraction using hydrochloric acid.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!