Few studies have evaluated the 'bulk' mechanical properties of human longbones and even fewer have compared human tissue to the synthetic longbones increasingly being used by researchers. Distal femur fractures, for example, comprise about 6% of all femur fractures, but the mechanical properties of the distal condyles of intact human and synthetic femurs have not been well quantified in the literature. To this end, the distal portions of a series of 16 human fresh-frozen femurs and six synthetic femurs were prepared identically for mechanical testing. Using a flat metal plate, an axial 'crush' force was applied in-line with the long axis of the femurs. The two femur groups were statistically compared and values correlated to age, size, and bone quality. Results yielded the following: crush stiffness (human, 1545 +/- 728 N/mm; synthetic, 3063 +/- 1243 N/mm; p = 0.002); crush strength (human, 10.3 +/- 3.1 kN; synthetic, 12.9 < or = 1.7 kN; p = 0.074); crush displacement (human, 6.1 +/- 1.8 mm; synthetic, 2.8 +/- 0.3 mm; p = 0.000); and crush energy (human, 34.8 +/- 15.9J; synthetic, 18.1 +/- 5.7J; p = 0.023). For the human femurs, there were poor correlations between mechanical properties versus age, size, and bone quality (R2 < or = 0.18), with the exception of crush strength versus bone mineral density (R2 = 0.33) and T-score (R2 = 0.25). Human femurs failed mostly by condyle 'roll back' buckling (15 of 16 cases) and/or unicondylar or bicondylar fracture (7 of 16 cases), while synthetic femurs all failed by wedging apart of the condyles resulting in either fully or partially displaced condylar fractures (6 of 6 cases). These findings have practical implications on the use of a flat plate load applicator to reproduce real-life clinical failure modes of human femurs and the appropriate use of synthetic femurs. To the authors' knowledge, this is the first study to have done such an assessment on human and synthetic femurs.

Download full-text PDF

Source
http://dx.doi.org/10.1177/0954411912438038DOI Listing

Publication Analysis

Top Keywords

synthetic femurs
24
human
13
human synthetic
12
mechanical properties
12
human femurs
12
synthetic
11
femurs
11
distal condyles
8
femur fractures
8
age size
8

Similar Publications

Objective: Abaloparatide (ABL) is a synthetic parathyroid hormone-related protein analog developed as an anabolic drug to treat osteoporosis. ABL increases bone mineral density (BMD) of the long bones and spine; however, the influence of ABL on alveolar bone regeneration remains unknown. This study assessed the effects of systemic ABL administration on tooth extraction socket healing and dental implant osseointegration in a preclinical rodent model.

View Article and Find Full Text PDF

Long-Term Natural Hydroxyapatite and Synthetic Collagen Hydroxyapatite Enhance Bone Regeneration and Implant Fixation Similar to Allograft in a Sheep Model of Implant Integration.

Calcif Tissue Int

January 2025

Orthopaedic Research Laboratory, Department of Orthopedic Surgery and Traumatology, Odense University Hospital & Department of Clinical Research, University of Southern Denmark, V18-812B-1, Etage 1, Bygning 45.4, Nyt Sund, SDU Campus 5230, Odense, Denmark.

There is an increasing demand for a suitable bone substitute to replace current clinical gold standard autografts or allografts. Majority of previous studies have focused on the early effects of substitutes on bone formation, while information on their long-term efficacies remains limited. This study investigated the efficacies of natural hydroxyapatite (nHA) derived from oyster shells and synthetic hydroxyapatite mixed with collagen (COL/HA) or chitosan (CS/HA) on bone regeneration and implant fixation in sheep.

View Article and Find Full Text PDF

A tension system for angular correction of bent intramedullary nails: in vitro analysis.

Eur J Orthop Surg Traumatol

December 2024

Department of Orthopedics and Trauma, Universidade Federal Fluminense (UFF), Niterói, Rio de Janeiro, Brazil.

Purpose: Although several techniques have been described for bent intramedullary nail removal, there is no universally accepted strategy. We hypothesized that a device based on the action principle of a three-point bend fixture could facilitate extraction of bent intramedullary nails; this paper describes its design and experimental testing.

Methods: Five large synthetic left femurs and five steel intramedullary nails were used.

View Article and Find Full Text PDF

Wood-Derived Hydrogels for Osteochondral Defect Repair.

ACS Nano

January 2025

Department of Biomaterials, Faculty of Dental Science, Kyushu University, 3-1-1 Maidashi, Higashi-ku, Fukuoka 812-8582, Japan.

Repairing cartilage tissue is a serious global challenge. Herein, we focus on wood skeletal structures that are highly porous for cell penetration yet have load-bearing strength, and aim to synthesize wood-derived hydrogels with the ability to regenerate cartilage tissues. The hydrogels were synthesized by wood delignification and the subsequent intercalation of citric acid (CA), which is involved in tricarboxylic acid cycles and essential for energy production, and -acetylglucosamine (NAG), which is a cartilage glycosaminoglycan, among cellulose microfibrils.

View Article and Find Full Text PDF

Introduction: Aneurysmal bone cysts (ABCs) are benign, locally destructive, blood-filled reactive lesions of the bone most commonly presenting as pain or mass effect. Most are frequently located in the proximal humerus, distal femur, proximal tibia, spine, uncommonly the sacrum, and rarely the sacroiliac (SI) joint. We present a rare case of ABC in the SI joint and its recurrence treated with percutaneous intralesional doxycycline ablation and the corresponding outcome.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!