Background: In rehabilitation, training intensity is usually adapted to optimize the trained system to attain better performance (overload principle). However, in balance rehabilitation, the level of intensity required during training exercises to optimize improvement in balance has rarely been studied, probably due to the difficulty in quantifying the stability level during these exercises. The goal of the present study was to test whether the stabilizing/destabilizing forces model could be used to analyze how stability is challenged during several exergames, that are more and more used in balance rehabilitation, and a dynamic functional task, such as gait.
Methods: Seven healthy older adults were evaluated with three-dimensional motion analysis during gait at natural and fast speed, and during three balance exergames (50/50 Challenge, Ski Slalom and Soccer). Mean and extreme values for stabilizing force, destabilizing force and the ratio of the two forces (stability index) were computed from kinematic and kinetic data to determine the mean and least level of dynamic, postural and overall balance stability, respectively.
Results: Mean postural stability was lower (lower mean destabilizing force) during the 50/50 Challenge game than during all the other tasks, but peak postural instability moments were less challenging during this game than during any of the other tasks, as shown by the minimum destabilizing force values. Dynamic stability was progressively more challenged (higher mean and maximum stabilizing force) from the 50/50 Challenge to the Soccer and Slalom games, to the natural gait speed task and to the fast gait speed task, increasing the overall stability difficulty (mean and minimum stability index) in the same manner.
Conclusions: The stabilizing/destabilizing forces model can be used to rate the level of balance requirements during different tasks such as gait or exergames. The results of our study showed that postural stability did not differ much between the evaluated tasks (except for the 50/50 Challenge), compared to dynamic stability, which was significantly less challenged during the games than during the functional tasks. Games with greater centre of mass displacements and changes in the base of support are likely to stimulate balance control enough to see improvements in balance during dynamic functional tasks, and could be tested in pathological populations with the approach used here.
Download full-text PDF |
Source |
---|---|
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC3408325 | PMC |
http://dx.doi.org/10.1186/1743-0003-9-28 | DOI Listing |
Small
December 2024
Department of Chemistry, Indian Institute of Technology Kharagpur, Kharagpur, West Bengal, 721302, India.
The separation and purification of acetylene from the light hydrocarbon gas mixtures is considered as one of the most industrially challenging task for the production of fine chemicals. Though metal-organic frameworks (MOFs) are promising candidates for such separation and offer a cost and energy-efficient pathway, achieving the trade-off between sorption capacity and separation selectivity along with framework robustness is a daunting task and demands effective design. Herein, a new 3D chemically stable MOF, IITKGP-24 (stable over a wide range of aqueous pH solution, pH = 2-12) is developed, displaying excellent separation selectivity of 13.
View Article and Find Full Text PDFBMC Biotechnol
December 2024
Environmental Microbiology and Biotechnology Unit, Department of Microbiology, Faculty of Biological Sciences, University of Calabar, Calabar, Nigeria.
Background: The eco-friendly transformation of agro-industrial wastes through microbial bioconversion could address sustainability challenges in line with the United Nations' Sustainable Development Goals. The bulk of agro-industrial waste consists of lignocellulosic materials with fermentable sugars, predominantly cellulose and hemicellulose. A number of pretreatment options have been employed for material saccharification toward successful fermentation into second-generation bioethanol.
View Article and Find Full Text PDFPolymers (Basel)
November 2024
Instituto Universitario de Ingeniería de Alimentos (FoodUPV), Universitat Politècnica de València, Camí de Vera s/n, 46022 València, Spain.
Poly(3-hydroxybutyrate-co-3-hydroxyvalerate) (PHBV) is a biodegradable biopolymer from the PHAs family that has potential to replace conventional plastics and reduce plastic pollution. However, PHBV has thermo-sealability issues, making it challenging to use for bags. Blending it with polycaprolactone (PCL) could address this but may alter the barrier properties of the films, affecting their effectiveness as food packaging material.
View Article and Find Full Text PDFBackground: Patients surviving the coronavirus disease 2019 (COVID-19) are reported to explore pulmonary sequelae. It is challenging to provide pulmonary function tests (PFTs) during the pandemic of this contagious diseases because of the difficulty related to infection control risks. This study aims to identify important predictors of lung diffusion capacity impairment in COVID-19 survivors after hospital discharge.
View Article and Find Full Text PDFPolymers (Basel)
November 2024
Faculty of Civil Engineering, Nguyen Tat Thanh University, 300A Nguyen Tat Thanh Street, District 4, Ho Chi Minh City 700000, Vietnam.
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!