A new method for measuring the linewidth enhancement factor (α-parameter) of semiconductor lasers is proposed and discussed. The method itself provides an estimation of the measurement error, thus self-validating the entire procedure. The α-parameter is obtained from the temporal profile and the instantaneous frequency (chirp) of the pulses generated by gain switching. The time resolved chirp is measured with a polarization based optical differentiator. The accuracy of the obtained values of the α-parameter is estimated from the comparison between the directly measured pulse spectrum and the spectrum reconstructed from the chirp and the temporal profile of the pulse. The method is applied to a VCSEL and to a DFB laser emitting around 1550 nm at different temperatures, obtaining a measurement error lower than ± 8%.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1364/OE.20.004979 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Improved phosphorus MRSI acquisition through compressed sensing acceleration combined with low-rank reconstruction.
MAGMA
December 2024
Department of Radiology and Medical Informatics, Faculty of Medicine, University of Geneva, Geneva, Switzerland.
Objectives: Phosphorus-31 magnetic resonance spectroscopic imaging (P-MRSI) is a non-invasive tool for assessing cellular high-energy metabolism in-vivo. However, its acquisition suffers from a low sensitivity, which necessitates large voxel sizes or multiple averages to achieve an acceptable signal-to-noise ratio (SNR), resulting in long scan times.
Materials And Methods: To overcome these limitations, we propose an acquisition and reconstruction scheme for FID-MRSI sequences.
Active Surface-Enhanced Raman Scattering Platform Based on a 2D Material-Flexible Nanotip Array.
Biosensors (Basel)
December 2024
Department of Physics and Quantum Photonics Institute, Ulsan National Institute of Science and Technology (UNIST), Ulsan 44919, Republic of Korea.
Two-dimensional materials with a nanostructure have been introduced as promising candidates for SERS platforms for sensing application. However, the dynamic control and tuning of SERS remains a long-standing problem. Here, we demonstrated active tuning of the enhancement factor of the first- and second-order Raman mode of monolayer (1L) MoS transferred onto a flexible metallic nanotip array.
View Article and Find Full Text PDFEnhancing cooperativity of molecular J-aggregates by resonantly coupled dielectric metasurfaces.
Nanophotonics
August 2024
Centre for Disruptive Photonic Technologies, The Photonics Institute, Nanyang Technological University, Singapore 637371, Singapore.
Article Synopsis
- J-aggregates are assemblies of dyes that exhibit strong light absorption and fluorescence due to delocalized excitons, but their effectiveness is limited by local disorder and thermal decoherence.
- To enhance exciton coherence and delocalization, researchers coupled ordered molecular dipoles to an electromagnetic mode within an optical resonator.
- By using dielectric metasurfaces, the study achieved a 5-fold increase in luminescence intensity and reduced emission directivity, showcasing the potential of these surfaces in promoting cooperative behaviors in excitonic systems.
Si metasurface supporting multiple quasi-BICs for degenerate four-wave mixing.
Nanophotonics
August 2024
Facultad de Ciencias Exactas y Naturales, Departamento de Física, Universidad de Buenos Aires, 1428 Buenos Aires, Argentina.
Article Synopsis
- Dielectric metasurfaces with quasi-bound states in the continuum (qBICs) can boost field enhancement through narrow resonances in the visible and near-infrared ranges.
- A new silicon-on-silica metasurface design supports up to four qBIC resonances by using an elliptical cylinder array with varied symmetry-breaking shapes.
- The study showcases the nonlinear process of four-wave mixing and highlights the potential applications in areas like information multiplexing and multi-wavelength sensing using the unique geometric control of qBICs.
Using the fs-IR laser point-by-point inscription method, parallel-cladding random fiber Bragg gratings (Parallel-CLRFBGs) were fabricated in a single-mode fiber (SMF) as a novel, to the best of our knowledge, filtering device for random fiber lasers (RFLs). The Parallel-CLRFBGs effectively control light scattering and interference, enhancing system feedback through increased backward Rayleigh scattering. Compared to conventional axially cascaded random gratings, gratings aligned in parallel within sub-centimeter cladding improve the integration of a laser system.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!