Calcium-based scrubbers designed to absorb HCl and SO(2) from flue gases can also remove oxidized mercury. Dissolved mercury halides may have an appreciable partial vapor pressure. Chemical reduction of the dissolved mercury may increase the Hg emission, thereby limiting the coremoval of mercury in the wet scrubbing process. In this paper we evaluate the effects of the pH level, different gypsum qualities, and iron in flue gas desulfurization (FGD) scrubber suspensions. The impact of these parameters on mercury vapor pressure was studied under controlled laboratory conditions in model scrubber suspensions. A major influence is exerted by pH values above 7, considerably amplifying the mercury concentration in the vapor phase above the FGD scrubber suspension. Gypsum also increases the mercury re-emission. Fe(III) decreases and Fe(II) increases the vapor pressure significantly. The consequences of the findings for a reliable coremoval of mercury in FGD scrubbers are discussed. It is shown that there is an increased risk of poor mercury capture in lime-based FGD scrubbers in comparison to limestone FGD scrubbers.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1021/es203605h | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Impact of land conversion on environmental conditions and methane emissions from a tropical peatland.
Sci Total Environ
January 2025
Sarawak Tropical Peat Research Institute, Kota Samarahan, Malaysia.
Tropical peatlands are significant sources of methane (CH₄), but their contribution to the global CH₄ budget remains poorly quantified due to the lack of long-term, continuous and high-frequency flux measurements. To address this gap, we measured net ecosystem CH exchange (NEE-CH) using eddy covariance technique throughout the conversion of a tropical peat swamp forest to an oil palm plantation. This encompassed the periods before, during and after conversion periods from 2014 to 2020, during which substantial environmental shifts were observed.
View Article and Find Full Text PDFShort-term impact of low air pressure on plants' functional traits.
PLoS One
January 2025
Department of Biotechnology, University of Verona, Verona, Italy.
Lower atmospheric pressure affects biologically relevant physical parameters such as gas partial pressure and concentration, leading to increased water vapor diffusivity and greater soil water content loss through evapotranspiration. This might impact plant photosynthetic activity, resource allocation, water relations, and growth. However, the direct impact of low air pressure on plant physiology is largely unknown.
View Article and Find Full Text PDFOxygen-Passivated Sulfur Vacancies in Monolayer MoS for Enhanced Piezoelectricity.
ACS Nano
January 2025
School of Engineering, RMIT University, 124 La Trobe Street, Melbourne, Victoria 3001, Australia.
Modern-day applications demand onboard electricity generation that can be achieved using piezoelectric phenomena. Reducing the dimensionality of materials is a pathway to enhancing the piezoelectric properties. Transition-metal dichalcogenides have been shown to exhibit high piezoelectricity.
View Article and Find Full Text PDFRecovery of iron as hematite and separation of trivalent lanthanide ions from spent hard disk magnet leach liquor using [P66614][Cy272] ionic liquid.
RSC Adv
January 2025
Department of Chemistry, Institute of Technical Education and Research, Siksha 'O' Anusandhan Deemed to Be University Bhubaneswar-751030 Odisha India
The widespread use of neodymium-iron-boron (NdFeB) magnets has raised concerns about the environmental impact of their disposal, prompting the need for sustainable recycling strategies. Traditional solvents used in recycling are toxic and flammable, making them risky to use. Ionic liquids are safer and greener options with low vapor pressure, high stability, and less flammability.
View Article and Find Full Text PDFSupramolecular Ionic Gels for Stretchable Electronics and Future Directions.
ACS Mater Au
January 2025
Department of Electrical and Electronic Engineering, Kyushu Institute of Technology, 1-1 Sensuicho, Tobataku, Kitakyushu, Fukuoka 804-8550, Japan.
Ionic gels (IGs), ionic liquids (ILs) dispersed in polymers, exhibit extremely low vapor pressure, electrochemical and thermal stability, and excellent mechanical characteristics; therefore, they are used for fabricating stretchable sensors, electrochemical transistors, and energy storage devices. Although such characteristics are promising for flexible and stretchable electronics, the mechanical stress-induced ruptured covalent bonds forming polymer networks cannot recover owing to the irreversible interaction between the bonds. Physical cross-linking via noncovalent bonds enables the interaction of polymers and ILs to form supramolecular IGs (SIGs), which exhibit favorable characteristics for wearable devices that conventional IGs with noncovalent bonds cannot achieve.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!