Unlabelled: Firefighters are exposed to a wide range of risks, among them, biological risk. The objective was to analyze working conditions of firefighters in the city of Campo Grande, MS, Brazil, focusing on risk conditions of exposure to biological material. Three hundred and seven (307) firefighters were interviewed for data collection and observed for ergonomic job analysis (AET).
Results: 63.5% of the firefighters suffered some kind of job related accident with blood or body fluids. Statistically significant association was found between having suffered accidents at work and incomplete use of personal protective equipment (PPE). About AET regarding the biological risks, 57.1% of all patients had blood or secretions, which corresponds in average to 16.0% of the total work time, based on a working day of 24 h. Besides biological risks, other stressing factors were identified: emergency and complexity of decision, high responsibility regarding patients and environment, and conflicts. Health promotion and accident prevention actions must be emphasized as measures to minimize these risks.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.3233/WOR-2012-0855-5468 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Material Visual Perception and Discharging Robot Control for Baijiu Fermented Grains in Underground Tank.
Sensors (Basel)
December 2024
School of Mechanical Engineering, Hebei University of Technology, Tianjin 300401, China.
Addressing the issue of excessive manual intervention in discharging fermented grains from underground tanks in traditional brewing technology, this paper proposes an intelligent grains-out strategy based on a multi-degree-of-freedom hybrid robot. The robot's structure and control system are introduced, along with analyses of kinematics solutions for its parallel components and end-effector speeds. According to its structural characteristics and working conditions, a visual-perception-based motion control method of discharging fermented grains is determined.
View Article and Find Full Text PDFFabrication of Polytetrafluoroethylene-Reinforced Fluorocarbon Composite Coatings and Tribological Properties Under Multi-Environment Working Conditions.
Polymers (Basel)
December 2024
School of Mechanical and Electrical Engineering, Xi'an University of Architecture and Technology, Xi'an 710055, China.
Currently, few studies have been conducted on the use of fluorocarbon resin (FEVE) and polytetrafluoroethylene (PTFE) as adhesive substrates and lubricating and anti-corrosion fillers, respectively, for the fabrication of PTFE-reinforced fluorocarbon composite coatings. In this paper, the tribological properties of polytetrafluoroethylene-reinforced fluorocarbon composite coatings were investigated through orthogonal tests under various operating conditions. The optimal configuration for coating preparation under dry friction and aqueous lubrication was thus obtained: the optimal filler particle size, mass ratio of FEVE to PTFE, spraying pressure, and curing agent content were 50 μm, 3:4.
View Article and Find Full Text PDFWind Turbine Blade Material Behavior in Abrasive Wear Conditions.
Polymers (Basel)
December 2024
Faculty of Engineering, "Dunărea de Jos" University, 800008 Galati, Romania.
The wind turbine blades are exposed, during functioning, to the abrasive wear generated by the impact with air-borne sand particles. In this work, samples of a commercial wind turbine blade, made of a multi-layered composite material, are subjected to abrasive wear tests, using an air streamed wearing particles test rig. Following the analysis of the tests' results was found that the only protection against failure of the blade by abrasive damage is the surface layer.
View Article and Find Full Text PDFPathological In Vivo Analysis of Helicobacter DNA Infection in Stomach Cells Using Carbon Nanotube Microsensor.
Microorganisms
December 2024
Biosensor Research Institute, Seoul National University of Science & Technology, Seoul 01811, Republic of Korea.
The WHO has classified Helicobacter pylori as a group 1 carcinogen for stomach cancer since early 1994. However, despite the high prevalence of Helicobacter pylori infection, only about 3% of infected people eventually develop gastric cancer.Biomolecular detections of Helicobacter pylori(HP) were compared using specially modified sensors and fluorine immobilized on a carbon nanotube (HFCNT) electrode, which yielded sensitive results.
View Article and Find Full Text PDFSimulation and Assessment of Thermal-Stress Analysis of Welding Materials in IGBT.
Micromachines (Basel)
December 2024
School of Material Science and Engineering, Huazhong University of Science & Technology, Wuhan 430074, China.
Insulated gate bipolar transistors (IGBTs), as an important power semiconductor device, are susceptible to thermal stress, thermal fatigue, and mechanical stresses under high-voltage, high-current, and high-power conditions. Elevated heat dissipation within the module leads to fluctuating rises in temperature that accelerate its own degradation and failure, ultimately causing damage to the module as a whole and posing a threat to operator safety. Through ANSYS Workbench simulation analysis, it is possible to accurately predict the temperature distribution, equivalent stress, and equivalent strain of solder materials under actual working conditions, thus revealing the changing laws of the heat-mechanical interaction in solder materials.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!