Developed were the determination methods of Cr(VI) and Cr(III) by electrospray ionization mass spectrometry, where HCrO(4)(-) (m/z 117) and [Cr(III)(cydta)](-) (m/z 394) were measured, respectively. Moreover, total Cr was also determined by measuring [Cr(III)(cydta)](-) after reduction of Cr(VI) with ascorbic acid. Here, cydta denotes trans-1,2-diaminocyclohexane-N,N,N',N'-tetraacetic acid. The detection limits were ca. 13 nmol/dm(3) for Cr(VI) and 56 nmol/dm(3) for Cr(III) and total Cr. The proposed methods were applied to analyze chromate and trivalent chromium conversion coatings and gave consistent results with those obtained by a diphenylcarbazide spectrophotometric method for Cr(VI) and ICP-AES for total Cr.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.talanta.2011.11.028DOI Listing

Publication Analysis

Top Keywords

chromate trivalent
8
trivalent chromium
8
chromium conversion
8
conversion coatings
8
electrospray ionization
8
ionization mass
8
mass spectrometry
8
determination chromiumiii
4
chromiumiii chromiumvi
4
total
4

Similar Publications

Article Synopsis
  • The study investigates how substituting manganese (Mn) at B sites affects the structural, electronic, magnetic, and optical properties of nickel chromate spinel (NiCrO), revealing no major structural distortion but changes in bond angles and lengths as Mn content varies.
  • Electronic structure analysis shows that nickel is divalent while chromium and manganese remain trivalent, with these configurations influencing the material's semiconducting nature and direct bandgap that ranges from 1.16 to 2.40 eV.
  • All compositions exhibit ferrimagnetic ordering below the Néel temperature, with magnetic properties improving as Mn is added; however, the anisotropy shows a decreasing trend which is attributed to
View Article and Find Full Text PDF

To maximize the potential of biomass from invasive plants, waste leaves from Rhus typhina (RT) and Amorpha fruticosa (AF) were used to prepare activated carbons (ACs) for the efficient removal of chromium from wastewater. Six ACs were prepared by CO activation at 850 °C with varying flow rates (500, 1000, and 1500 mL/min) and characterized by yield, pH, N adsorption isotherm, FTIR, SEM, TG, and XPS. The adsorption isotherm and kinetics for chromium removal were analyzed.

View Article and Find Full Text PDF

The aim of this study was to investigate the practicability of exhaled breath condensate (EBC) as a biological matrix to detect and measure hexavalent chromium (Cr(VI)) and trivalent chromium (Cr(III)) in workers occupationally exposed to Cr(VI). EBC samples were collected from workers in France, Finland, Italy, The Netherlands and the United Kingdom from three different target activities: chrome platers, stainless steel welders and surface treatment workers. Pre and post working week EBC samples were collected from 177 exposed workers and 98 unexposed workers (control group).

View Article and Find Full Text PDF

Use of LDH- chromate adsorption co-product as an air purification photocatalyst.

Chemosphere

January 2022

Departamento de Química Inorgánica, Instituto Universitario de Nanoquímica IUNAN, Universidad de Córdoba, Campus de Rabanales, E-14014, Córdoba, Spain. Electronic address:

This work deals with the use of layered double hydroxides for a double environmental remediation. The residue obtained in the use of these materials as a chromate sorbent in water, was subsequently studied as a photocatalyst for the removal of NO gases. With this aim, MgAl-CO layered double hydroxides were synthesized by the coprecipitation method with a divalent/trivalent metal ratio of 3.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!